Forum Replies Created

Page 7 of 26
  • Jeff

    Member
    May 10, 2023 at 1:23 pm in reply to: Matching paint colors

    I contacted either Prevost or Liberty (can’t remember) to get the paint specs/data for our 96 Liberty. Here’s what they emailed me and its accurate:

  • Jeff

    Member
    May 8, 2023 at 9:43 pm in reply to: What did you do to your bus today Part 2

    Started the solar project fit 18 100w panels and will add a 2nd row later for 3600w total. Interestingly enough I found out i have 6 AC units and not 5 as well as I had a 3rd girard awning (back drivers side) that was screwed shut. Ended up removing the fabric and motor for that awning as I don’t think I’d ever use it anyways. We mounted them to the girard awning casings using door hinges. The plan is to run very long screws through the AC coverings so we don’t need to drill holes in the roof.

    Down the road we’ll be screwing the solar panels in for now then will work on adding linear actuators and some solar tracker so I can optimize output. Then adding a 2nd row, the other row will be arched so it doesn’t hit the AC unit.

  • Jeff

    Member
    May 1, 2023 at 1:18 pm in reply to: Changing hoses & dirty Radiator internals
    Which fitting and hose? I got the 2 atf lines and 2 water filter lines from Prevost. The rest of the hoses came from siliconehose.com after I got all the measurements.
    The radiator shop I dealt with here gives a core manufacturer? all the specs, they build it, and my local shop gets it puts it together. Takes about 5to7 working days. Cost with labor $3200
    or
    Prevost quoted me a price of $3300 for a core, they need 3 wks led time. Then a shop has to put it together.
    or
    Prevost quoted me $5200 for a complete radiator, they need 1 month led time. I’m not sure how much more labor is involved in this option?
  • Jeff

    Member
    April 29, 2023 at 9:05 pm in reply to: 2000 XL Pneumatics

    the broken lines are the functions of selonoid stack when in your parked indivual air bag adjustment. the solid lines are when you are in driving mode..I took the diagram you have to office depot and had it blown up (about 20 by 30 inches and lamaniated less than 15$..you can use erase markers on it when tracing system..Use colored ones..Bob

  • Jeff

    Member
    April 29, 2023 at 6:52 am in reply to: Best deionizer

    I’ve been looking as well and they’re expensive and the resin doesn’t last long. Make sure to get one with a bypass so you can wash without using DI.

    Also get water filters and a softener. I have a 2 stage filter and a softener to clean the intake water for fresh. I use a giraffetools pressure washer in my wash bay. Plan on plumbing a DI with bypass valves and tucking it away just out of room and need to reconfigure the genny vent fan to make smaller to get a bit more room in that bay.

  • Jeff

    Member
    April 28, 2023 at 2:18 pm in reply to: Changing hoses & dirty Radiator internals

    I got the CAC, radiator, gearbox, clutch fan area all cleaned and read to reinstall everything soon.

  • Jeff

    Member
    April 21, 2023 at 10:45 pm in reply to: Step cover slide

    Quick follow up question

    The step well cover on our liberty has an issue.

    The red dots move the slide in and out;

    The spool moves well and looks good.

    The problem:

    but I am not seeing 24v (or any voltage)

    at the valves when the switch is held in either direction.

    I am using the little 6 wire bus bar to check incoming voltage.

    Is there a fuse or breaker that I am missing?

    I may test the coils by connecting them to 24v — just to make sure that they energize and can move the valve — but that will only tell me not to replace the valves/coils.

    Would thw next step to swap the switch with another similar carling switch (e.g bed lift switch)?

    any thoughts would be appreciated. thanks!

  • Jeff

    Member
    April 9, 2023 at 1:41 pm in reply to: Kubota V2003 temp sensor locations?

    The only temp sensor that I know of on ours is on the thermostat housing.

  • Jeff

    Member
    April 3, 2023 at 7:59 am in reply to: Buying advice for newbie’s- 1996 Vogue V

    Andy, if this is a prevost converted vogue call us at East Tennessee Luxury Coach (423)884-6008

    we don’t do mobile inspections but if your able to get pictures im more then happy to look it over and give my non biased opinion.

    any rv that’s sat for 5 years regardless of how it was stored is going to need some love

  • Jeff

    Member
    March 28, 2023 at 10:10 pm in reply to: OTR Evaporator Solenoid Failed (again)

    Are they 100 percent duty ?

  • Jeff

    Member
    March 14, 2023 at 11:53 pm in reply to: Prevost OTR Air

    Our main cabin fan speed rheostat does raise and lower the main cabin fan speed, but the lowest speed position (ccw) isn’t anywhere near zero like is possible with the dash fan rheostat.

  • Jeff

    Member
    March 3, 2023 at 9:01 am in reply to: Replacement for ceiling Tivoly lights

    Nothing yet.

  • Jeff

    Member
    February 24, 2023 at 9:46 pm in reply to: stair coverings

    We are also looking for stair covering material after seeing it in the buses at the Expo. We were at Liberty in Stuart after the Expo and asked about getting some made… The answer made us quickly decide to look for the material elsewhere and make our own. We will look at the Chilewich product.

  • Jeff

    Member
    February 12, 2023 at 10:51 am in reply to: Coffee and lies

    Thanks Jeep, see ya there.

  • Jeff

    Member
    February 9, 2023 at 4:49 pm in reply to: 1998 Liberty living room lights not working

    Theirs is an “elegant Lady”, yours/mine is a “classic”. two different animals.

Page 7 of 26