Jon
Forum Replies Created
-
Northern WI area code if that helps. Covers all the way to Superior NW corner and goes to Eau Claire and east.
-
It’s been the same problem the entire time. When the got there he parked and a few hours later was going to move the coach a few feet and when he started it is when the problem started. He did try a different keypad but still did the same thing.
-
Sounds model year specific. The manual has to be consulted.
-
PDI has been around a long time. They are known for adding turbos and making big power on truck engines. Many cattle trucks and chicken trucks out west have used them.
They also have a box like Bully Dog and others that flashes the motor. if you have a warranty you must set it back before getting any work done because the engine serial number is changed which the computer will see. I prefer expanding pulse width.
A couple years ago a so called friend with a motorhome wanted to get his x15 cummins running and I sent him to PDI. The box became very popular after he posted a video on line as the only place to go for power. Now there’s a bunch of motorhomes out there running with a flashed motor.
Later
bv
-
thank you for the response! Had an ISL Cummins that they ( PdI )did a tune on, just wanted a little better MPG. $1500 latter and a cooling problem and less MPG. When back a couple of times and was told not to come back.
-
Yep, go 24v in parallel, otherwise out of balance occurs.
-
While Transynd is an amazing fluid and helps protect and prolong the life of an Allison automatic, one of the biggest reasons the transmission mentioned above may over heat is excessive fluid.
Even an amount as small as 1 quart in excess of the correct fill level can contribute to high internal transmission temps.
Not only switch to Transynd, but as difficult as it is checking fluid levels using the dip stick, make certain the levels are not above the full mark.
-
My sons and I have had many great days doing just that! I would love to get the dimensions of that cart. I don’t see an out of frame overhaul in my future but you never know!
Also if you are inclined, post progress photos of your work. Always nice to see how things flow.
Elliot
-
I think the compressor’s sump will be fully pressurized as the high and low side equalizes after you turn off the compressor. You’d have to pump down the refrigerant into the accumulator before you open up that service port.
The little oil injectors are much easier to use as long as you don’t have quarts to add. There are injectors that use refrigerant to push the oil in, others just screw in to force the oil into the system.
-
Server Security malfunction yesterday, all is well now.
-
Thanks Jon. What are you running as steer tires?
Wave
-
Hi Bernie,
Thanks for the note. I am sure you know more about tires than I do. I made the decision to upgrade since I needed new front tires and I wanted a margin of safety beyond the 315. I have a friend with huge brass balls in Florida. A motorcycle racer in the old days. He told me he was never in fear as much as a blowout on a downhill curve at 70mph in the Appalachians. I am hoping to avoid that outcome.
My previous comments were in regard to Kyle Boardman. He was the original subject of this post. Comments about being a hack were not my experience with him. I found him to be a very unique young man. Maybe taking on more than he should but I admire his attitude. My coach is better than before. I enjoy it more. That is all I can say.
Wave
-
I would turn off the water heater(s) and make sure you only have 1 A/C turned on. After a few hours the charger will have kicked down out of bulk charge and you should be able to turn the water heater on (1 if you have 2) and then just monitor what you are using when hair dryers need to be run or any other high load appliance.