Forum Replies Created

Page 41 of 48
  • Jon

    Member
    July 3, 2021 at 6:17 am in reply to: 20/30 amp adapter to 50 amp

    Run the generator or watch your loads like a hawk because with inverters, water pump, HW tank, aux compressor and phantom loads you are already pushing it. Add in an A/C or two and power will trip.

  • Jon

    Member
    July 3, 2021 at 12:24 am in reply to: 20/30 amp adapter to 50 amp

    Rusk County Josie Creek Campground

  • Jon

    Member
    July 2, 2021 at 5:23 pm in reply to: Any experience w/ Kyle bordur renovations

    “No need to post this hacks shit on here.”?

    Not sure where that attitude comes from. If you have something to add say it! Spare me from dealing with a hack.

  • Jon

    Member
    July 2, 2021 at 1:46 pm in reply to: Any experience w/ Kyle bordur renovations

    Someone will be tearing that shower out along with half of the inside of that coach. Water will be running under that tile 6 feet in all directions. No curb. Really?

  • Jon

    Member
    July 2, 2021 at 9:19 am in reply to: How far do I go with this? etc. 1989 XL CC 8v92TA

    Liam, thanks. I am in the process of replacing every ac hose also. Aeroquip has a system called EZ Clip that I am looking at using. That is a project in and of itself, but I think there is no better time to do it. I will attempt to put a photo of the engine on the cart up here. Not sure how to do that yet.

  • Jon

    Member
    July 2, 2021 at 8:57 am in reply to: Jumped in the pool full speed ahead

    Welcome to the H3 club!

  • Jon

    Member
    July 1, 2021 at 8:49 am in reply to: Question on removing the valve core on valve stem

    Thanks everyone. The stem tool I have is not long enough to reach the inner drive wheel, so I have ordered a longer tool. I will definitely try to tighten first, but after thinking about it, jacking is probably the thing to do.

    Thanks again for your input.

  • Jon

    Member
    June 30, 2021 at 2:22 pm in reply to: How far do I go with this? etc. 1989 XL CC 8v92TA

    Rick,

    Just a suggestion, if the bottom of your transmission pan looks like ours then tiny pin size holes are not far in your future. Ditto for the engine oil pan.

  • Jon

    Member
    June 30, 2021 at 10:05 am in reply to: Vanner Monitor Again

    After hearing all this I ordered a EM70D from inverter service center for $112 bucks no tax free ship seems like a good deal. Every time I start the bus the light lights up for a couple of seconds about 30 seconds after it fires up always works good. I will install new part and save old part for back up. $112 seems like a good deal?

  • Jon

    Member
    June 29, 2021 at 5:19 pm in reply to: New Coach

    The fuel mileage is probably great and I really like the scull, but wonder how he stops it if the horses can’t hold back.

    This is the perfect rig for Jon, he could grow his own feed, then catch the droppings in a net and put back on the garden for fertilizer. No depreciation or fuel expense and maintenance would be the occasional set of horse shoes.

  • Jon

    Member
    June 29, 2021 at 1:58 pm in reply to: New Coach

    The netting to keep the horse flies off the driver is a nice touch.

  • Jon

    Member
    June 29, 2021 at 7:18 am in reply to: Vanner Monitor Again

    The fusing for the monitor is external and has to be done by Prevost or the converter. The equalizers have circuit protection, a resettable breaker located on the bottom of the equalizer.

    The monitors have been somewhat unreliable, but I have found, and posts on the forum seem to suggest a pretty good reliability level for equalizers.

  • Jon

    Member
    June 28, 2021 at 6:48 pm in reply to: Any experience w/ Kyle bordur renovations

    The front of the Prevost is operating nearer capacity with 315’s. At a given inflation the 365 offers about 2,000 lbs increased weight load ability vs the smaller tire. Tire specs enclosed. I do think it is a better ride as well.

    wave

  • Jon

    Member
    June 28, 2021 at 12:30 pm in reply to: Can Prevosts be put to sleep?

    Every coach can be put to sleep, but the process varies to an extent based on the converter and model of coach.

    Contact the converter for instructions specific to the coach. Some have a very important specific sequence to prevent damage to certain devices or components. The forum is not the best place for this advice.

    The chassis just requires turning off the master.

    One important thing that applies to all coaches is you need good fully charged batteries. If the batteries are old or there are any issues with any single battery the remaining batteries can be quickly drained and possibly ruined. Check the batteries periodically and recharge them as often as required to keep them fully charged andnever discharged below 50% state of charge.

  • Jon

    Member
    June 28, 2021 at 10:31 am in reply to: Any experience w/ Kyle bordur renovations

    Wave,

    Hope you don’t mind me asking, what was your reason(s) for the 365 upgrade? Was there any difference in the ride or handling after the 365 upgrade? Thanks!

Page 41 of 48