Forum Replies Created

Page 7 of 17
  • Jimmy

    Member
    November 19, 2018 at 12:54 pm in reply to: Windshield night visors won’t go up or down

    David and Susie:
    I learned real quik that Liberty is secretive about their electrical systems. I’ve NEVER been able to get a schematic out of them. In the back of your Liberty Owners Manual there should be a lot of info on what circuit gets what amperage fuse etc.

    I’ve installed “glow when they blow” fuses.

  • Jimmy

    Member
    November 19, 2018 at 12:40 pm in reply to: Brrrrrrrrrrrr

    As mentioned above, don’t run the genny, run the diesel heat. Not only will this keep you warmer, it will keep the wet bays warm and avoid any possibility of frozen water lines or pumps. You will be able to keep it as warm as you like with that heat alone and, as a bonus, it uses much less fuel than the genny!

  • Jimmy

    Member
    November 19, 2018 at 7:20 am in reply to: Marathon – External LED Upgrade

    They really don’t show much George, but here ya go.

  • Jimmy

    Member
    November 9, 2018 at 6:34 pm in reply to: Greetings from Silver City NM

    I’m going to call Marathon on Monday and have them start working on the first ever 5 slide Marathon… for Tom… then we won’t have to endure any of the this slide abuse…

    Bill

  • Jimmy

    Member
    November 5, 2018 at 8:45 am in reply to: 88Liberty/Elecrical Tranny problem

    Check the grounds for the trans. Sounds like it is trying to ground thru the headlights

  • Jimmy

    Member
    October 8, 2018 at 8:27 am in reply to: dryer

    They take a long time to dry.

  • Jimmy

    Member
    September 28, 2018 at 12:19 pm in reply to: An Newbie Question on Reliability of Suspension

    Jon’s admonition concerning an un-compromised air system (moisture) is the most important. While tires, batteries, brake and suspension components are not chump change…they are all normal maintainance items on any motor home. Even if you have to replace the upper a-arms on an independent fr susp coach, they are not crazy expensive. But, you will go crazy chasing chasing air leaks and components with system damaged by moisture. Geo.

  • Jimmy

    Member
    September 27, 2018 at 11:41 am in reply to: An Newbie Question on Reliability of Suspension

    Prevost Service Centers. Link Here.

  • Jimmy

    Member
    September 21, 2018 at 7:37 am in reply to: Marathon Slide Air

    I liked my 02 system better, one yellow valve that isolated the Marathon side and the reason was I didn’t have to be concerned about aux compressor water contaminating the Prevost slide. Remember, those aux compressors make a lot of water.

    Now with my 04, that is exactly what happens and I’ll need to stay ahead of the water by draining the various devices often.

  • Jimmy

    Member
    September 11, 2018 at 9:53 am in reply to: Marathon Auto Sewer Hose

    Or if you’re a klutz like me, you go directly to Marathon. Joe at San Antonio quoted me $600 to change the sewer hose. I’ll be stopping on my trip south in the fall.

    I have a big gash which I keep repairing. However, I still have to pull it out and pack it away manually now.

  • Jimmy

    Member
    September 11, 2018 at 9:05 am in reply to: Marathon Auto Sewer Hose

    In order to change the hose, from the curbside, you’ll need to remove both the 110v and the12v water pumps. Then you can get to where the hose is clamped onto the sewer valve assembly. You attach a rope to the hose and then pull it thru to the drivers side until it comes completely out. You then use the rope to pull the new hose thru. Then hook it up, replace your water pumps and that’s it.

  • Jimmy

    Member
    August 1, 2018 at 2:20 pm in reply to: Over the road blower quit

    R-32???????

    Maybe R-12 on an older OTR, or 134 on a newer system.

  • Jimmy

    Member
    July 23, 2018 at 1:27 pm in reply to: No Rally, Rally – Petoskey, MI – August 2 – 6

    We also are coming N on I-75 and I don’t know what the bus GPS will say, but Google shows leaving I-75 at exit 290 and proceeding left up Mill Street which appears to be C-48.

    At the Whippy Dip (not kidding) turn left and continue on C-48 to 131.

    Then you can take that to 31 or turn left on Intertown Road (your choice) to Laketown Road to 31 to the resort.

    At least that is what Google is showing.

    This navigation stuff is so confusing I get a sense that before I get there I will hear my GPS “recalculating” a lot.

  • Jimmy

    Member
    July 11, 2018 at 10:02 am in reply to: Paint removel

    Finally good enough, 2nd time around looks good 1st time when i hit it with the white wheel for the final a lot of scratches showed up so I went over it again with the cut and then the final step. Jon was right when he said polishing stainless is an art and I’m not quite there yet.

  • Jimmy

    Member
    July 9, 2018 at 11:43 am in reply to: Cabin A/C air filter

    You boy’s need an H.

Page 7 of 17