Dick
Forum Replies Created
-
Treated our roof couple years ago, happy with the results…if you do not to do it yourself, contact Eric Mann at Superior Coach Detailing, 407-516-8088, he serves Michigan and Florida and everything in between…his crews left Michigan yesterday on the way to a rally in Texas. Talked to them couple weeks ago while in North Michigan.
-
Colt, I was starting to believe you until you got to the part about kicking one of your dogs. As much as you spent on those pups, you would never kick one. Besides Melissa would kick YOU through the goal posts. Hope the two of you are well.
-
Like Jeff, I saw Tom’s bus listed for sale, but saw no forum chatter about this significant event. I have waited patiently for some justification for such an outrageous and ill-advised course of action.
I can assure the members of the forum that had I followed through with my threat to bombard Tom with questions about coach operation, maintenance, etc., Tom’s short-lived relationship with the ultimate coach (2004 Marathon H, single slide) could be explained. I can also assure the members of the forum that I did not bother Tom one time with stupid questions (at least not lately), so there must be another explanation.
Tom’s next move could very well be a social and cultural mistake of epic proportions. Hopefully, he will stick with a Marathon conversion in an effort to avoid severe disappointment.
-
Mr. Pres: you have a beautiful place there—best in preserve!
-
Our coaches are complex. Even if we focus only on the chassis the amount of knowledge required to answer all questions approaches infinity.
Way back when all coaches were 40 feet XL with 8V92 engines we could expect someone to be able to handle about any question. But that is not the case. There are now 3 engines used in our coversions and multiple transmissions. We are dealing with XL, XLV, XLII, and X3. We also have several veriosn of H3. We have no slides, single slides, two, three and four slides and slides have about 5 versions. We have multiple versions of DDEC and the Volvo equivalent. We have at least 3 braking systems. The EPA emissions systems are varied significantly. Electrical systems have gone from switches and relays and miles of wire to complex multiplex systems.
My point is whoever we seek information from has to get accurate information from us about the coach and then somehow do one of the hardest things in the world, which is to diagnose a problem via the spoken or written word without the benefit of the use of senses to aid in the diagnosis and response.
Look at how difficult it is to respond accurately to questions on the forum and it becomes apparent the person manning the PASS phones has a far tougher job than the mechanic in the shop who can hear, smell, touch and feel the coach and its problem.
I am definitely not suggesting anyone shop among the various PASS technicians for answers, but to try to understand those folks might actually welcome an owner who really prepares for the phone call, gathering as much information as possible, no matter how trivial it might be, and to suggest as nicely as possible if the answers are no help, ask if someone else at PASS has some alternative ideas.
-
Not all Prevost service centers are created equal.
-
With regards to windows….H3-41? Also year as Prevost changed the windows on several years…
-
Prevost said my front pads are 60% good and dont really show any damage. They want $200 for pads and 1 hour labor for install. They also said the rubber boots are cracked on all 6 calipers and they have a caliper boot seal kit that covers all calibers for $122 and $200 labor.
I am just going to have them replace the front pads to be safe but the $200 for 6 boots installed seems crazy. Do they just snap on or are they lubing and making adjustments also?
-
Put this in mine as I use to run it in my 1 ton diesels, Dodge and Chevy’s, when I had the shop and didn’t have any injector problems. . Figure with this low sulfur fuel, anything would help. Heard that just a little automatic trans fluid at fill up would do the same trick,, That is on the older Dinosaur’s 8V92TA’s like mine.
-
While I am already seeking advice…… When I remove the W/D combo, There are also no visible shutoff valves to the water on it; so are there generally flex lines like in a residential application that I can see and disconnect upon sliding the Washer out of its closet?
-
quoting this:
Do you use an additive in your diesel fuel and if so what brand?.
Can you actually see a difference?.
End quote
The answers would be NO and NO!
They are good if you are going to store the RV for the Winter (add an anti-gel) but otherwise……
-
Josam has always been highly regarded and a properly aligned Prevost should be very relaxing to drive. We should never have to constantly struggle to maintain our lane.
-
Thanks Jon. Just went and checked evaporator bay and they weren’t there. Going to go check 1st bay. Even check in Aqua Hot Bay just then. Glad the coach is 100 foot away.
-
Is the draw bar solid? or hollow?
If hollow, once you get the receiver cherry red and are banging it with a sledge hammer, and you have tension on the draw bar … quickly run some water though the hollow draw bar. The idea is to expand the receiver with the heat and then shrink the draw bar with the water. That should help snap the corrosion.
This thread should be a message to EVERYONE on he Forum. If you have a draw bar in any receiver on a trailer hitch, at least annually remove the draw bar from the receiver. Coat the four sides with oil or some kind of anti-corrosion stuff and put it back in.
Another idea is to remove the draw bar from the receiver when you’re not pulling a trailer or the toad.