Forum Replies Created

Page 55 of 214
  • Dick

    Member
    February 6, 2020 at 9:17 am in reply to: Lifeline Show Pricing

    I have read that the Relion Li’s will not fit in a Liberty classic that has three house batteries. Lifelines measure 19.5″ and Relion’s are 20.5″. That is from my memory banks , so dimensions could vary…

    Is this correct Tom , do you know if three of them will fit in a classic ?

  • Dick

    Member
    February 5, 2020 at 2:51 pm in reply to: Consignment Dealers

    Moisheh… You may or may not be aware, but “most” RV insurance policies do not provide coverage while your coach is in the possession of a consignment dealer. It used to be that you’d need a rider or some additional form of coverage. May have changed, but I’ve not heard it.

  • Dick

    Member
    February 5, 2020 at 8:48 am in reply to: Lifeline Show Pricing

    I think Li batteries are going to have substantial benefits for a lot of members. Anyone that does a lot of dry camping and intends to retain the coach for a lot of years they will realize a lot of benefits.

    But in anticipation of what is needed to make the change, especially for those who use auto-start I hope serious consideration is given to what has to be done to make them work with the way most coaches are set up today for the auto-start that measures a low voltage as the trigger to recharge.

  • Dick

    Member
    February 3, 2020 at 8:52 pm in reply to: Consignment Dealers

    Sorry about the email. I did not see that option. It is ON now. The one broker is from Oregon and his name is Ted Lewis. I do not think he has a company name. The other really surprised me. It is the Premier Group in Arizona. I will be in Phoenix on Monday and planned on going to his facility. When dealing with a normal RV dealer they wont leave you alone! I am a retired business owner and I always followed up with my customers. I did not mention any names as in many forums it is against their rules to say anything negative about a dealer.

  • Dick

    Member
    February 2, 2020 at 11:33 am in reply to: Detroit Series 60 Service

    I will contact Stewart Stevenson Dallas and see what they tell me about working on a bus.

  • Dick

    Member
    February 1, 2020 at 7:08 pm in reply to: Drive Axle Hub Inner Seal Leak

    At least you’ll know it was done right Don…

  • Dick

    Member
    January 31, 2020 at 7:10 pm in reply to: How often do you do top end adjustment?

    Bill where did you have the weekend to done?

  • Dick

    Member
    January 31, 2020 at 7:08 pm in reply to: Anyone familiar with this Liberty?

    Presume you mean ClassicCars.com. Searched it, there is a make category for Prevost, but I couldn’t find any Prevosts for sale.

  • Dick

    Member
    January 31, 2020 at 4:53 pm in reply to: Chassis Heat Issue

    Well after our trip to Prevost in Jacksonville all is well . Turned out there is a 12v wire running from the alternator that was burned . The wire runs to the relay in the front which controls the OTR heat . It did take 2 hrs due to the fact the wire was burned on the back side .

    I had no issue with it taking that long because the repair also fixed another issue we had with a battery dash light . It seems we originally thought we had a imbalance issue , however after replacing the Vantare installed voltage balance we still had a issue with voltage readings . Well Paul our Prevost technician said this will take care of you dash light also . So all is well and our experience could not have been better . Thank you to all that offered help .

  • Dick

    Member
    January 31, 2020 at 11:20 am in reply to: Drive Axle Hub Inner Seal Leak

    What size socket to I need?

    I may not need to do the drum brakes? Lining thickness is OK but I don’t have the drum off yet to see what is what. If they’re soaked with 90w, or whatever? I’ll be prepared. I don’t mind having the parts just sit on my shelf ready to go just in case. I have had new disc pads and slide pins sitting on my shelf for yrs now, for when or if.

    For everyones info, the mx manual says minimum thickness of the lining is 1/4″. It also says NEVER turn the drums. Cast into the outside of the drums is the maximum inside diameter. On ours it’s 14.830″. Below is a picture of the snap-on impact screw driver set and brake drum measuring caliper.

  • Dick

    Member
    January 31, 2020 at 9:18 am in reply to: Drive Axle Hub Inner Seal Leak

    All good info, and yours is the procedure in which runout and not torque is the standard.

    You will not have any problems since it sounds as if you will have all the right parts and you know the procedure.

    Why do you need brake linings? My 97 had 250,000 and the linings were still ample and in good shape.

  • Dick

    Member
    January 31, 2020 at 7:12 am in reply to: PREVENTIVE MAINTENANCE

    Marshall,

    What did Prevost charge to change all the coolant hoses ?

  • Dick

    Member
    January 29, 2020 at 7:59 pm in reply to: Solar Eclipse April 2024

    you can count us in Lord willing 🙂

  • Dick

    Member
    January 29, 2020 at 1:13 pm in reply to: RV Self Park!

    I agree with Jon, security is the main issue. Don’t need the showers, store, play ground, etc.

    Didn’t see much in the way of security when I looked at their web site.

    On a slightly different note: It seems rest area’s and truck stops are bursting at the seams with tractor trailers (more on the road then rest areas/truck stops can accommodate). Would a similar pay by the hour lot work for the trucking business too? Drivers could have a pay in advance card from their company’s like the fuel cards

    Chuck

  • Dick

    Member
    January 29, 2020 at 10:42 am in reply to: Securing items in coach while driving.

    We use “earthquake puffy” and industrial strength Velcro

Page 55 of 214