Dick
Forum Replies Created
-
This doesn’t directly answer your question, I have brought back to life single lead acid batteries that were completely discharged and charger wouldn’t respond by connecting dead battery to a good battery then connecting charger
-
Dick
MemberFebruary 23, 2020 at 12:03 pm in reply to: Needed: 95/96 Vantare switch light bulb sourceCheck with Donny Meyers 407-323-2367
or Featherlite 407-878-0003
The small bulbs come out (at least on mine) using needle nose pliers and a gentle pull.
-
I have removed the engine access panel on our coach but our coach has the east-west bed alignment and yours is north-south. I did have to remove a few pieces of finished hardwood flooring around the perimeter of the access panel. The hardwood flooring directly above the the access panel was attached to a separate piece of, Marathon installed, plywood that with some persuasion came out in one piece. Then there was a 5-7 inch vertical piece of, Marathon installed, plywood with finished flooring to the rear of the horizontal portion of the access panel that also had to be removed to get access to the bolts that hold the panel on. On our coach I did not have to cut any plywood but I did have to remove a few pieces of finished hardwood flooring around the perimeter of the access panel (as mentioned above) and remove a few nails from the, Marathon installed, plywood that covers the access panel.
Sorry I don’t have any pictures but I did include a diagram from the Prevost Parts Manual for your coach showing the position of the access panel location (number 10) for your coach.
I know a picture would be better. I hope this helps.
-
I second that as well. The balmar (and also I think the wakespeed, which was developed by the balmar 614 engineer before he passed away), are the best regulators out there. They are programmable (although a pain to program) for any kind of battery. The issue is that they are “externally regulated” and many converter setups use internally (read : dumb) regulated alternators. So you either have to convert to an external regulator (not too bad, but you do need to understand how to wire/re-wire etc) or get a new p-type alternator that can handle external regulation. Which may not be a bad option to upgrade to a balmar or leece-neville constant duty rated high output alternator.
External regulation also gives you the ability to safely stop the alternator when you are done charging for say LiFePO4 batteries rather than abruptly cutting them off
Also the Balmar does not like to be hot or exposed to elements – eventhough it is a marine unit, you dont want to put it in the back engine bay and exposed to water and heat. . .
But the balmar mc614 is the one of the best altenrator regulators out there. and its user base in the marine world is wide and manufacturer support is extensive.
-
sounds like screw thy neighbor mentality here. Enjoy your elite better than any one else .. you definitely are setting yourself up on a shelf. Remind you of another forum! I thought that is why this one was started. BYE poor middle class Bob
-
I have Outback inverters and a battery equalizer by Vanner. (my house is a 12/24 volt house) I have been assured that as long as I make certain my charge current and voltages are what Relion wants I am good to go.
I have a Liberty watchdog that can handle the autostart, but I have never used it and do not plan to ever use it, but I will set the sensing to autostart the generator at 11.8 volts as specified by Relion.
These are advertised and claimed to be drop in replacements so I intend to treat them as such.
As to my alternator its output is 27.7 which is a maintenance charge and in the case of Li is actually OK without the problems associated with AGM batteries if consistently charged at that level. The alternator is 270 amps, and since I will use 4 Li batteries I am well below the 100 amp max charge specified.
I have pressed the Relion rep very hard on this subject and am confident I will be well within the parameters for both charging and current draw.
-
Doors are 12′ x 14′ and wish they were wider… 14′ x 14′ would be ideal. Central a/c and heat to control humidity is a must….
-
Thanks Art and Tom. I’ll take your advice.
-
Just wanted to bump this to the top to see if anyone has any ideas on this. I messed with it a bit yesterday and there is no apparent looseness in the way it was mounted. It seems unlikely that the inner cable was somehow stretched. Is there a shop that specializes in this stuff?
-
Bogus Post. My Cricket is silver and to save the earth I have Tom push me around. I think he feels guilty about the dues thing.