Forum Replies Created

Page 18 of 76
  • Jim/Chris

    Member
    February 29, 2020 at 10:44 am in reply to: Coach for Sale – scam?

    Howard Active Steering is out of business years ago. Parts are

    extremely hard to find. At this time most remove the system in a

    shop so as to run into a major malfunction or leak on the

    road trip.

    AL

  • Jim/Chris

    Member
    February 28, 2020 at 11:49 pm in reply to: Long Canadian winters, engine painting

    Stunning. Simply stunning.

    Did you brush the paint on? Use a spray gun? Or rattle can?

  • Jim/Chris

    Member
    February 28, 2020 at 11:35 am in reply to: Another radiator leak!

    Just an FYI.

    If you head west on 10 you have 380 miles to the split in Van Horn. The only 2 places inbetween are Ozona and Ft Stockton. Nothing out there for long stretches.

    Then you have 2 hours to El Paso and another 7 to PHX. So you got alot of trucking if your leaking. I would try and find it, have plenty of water on board and watch my temp.

    If it’s bad I would regroup and head up the 2 lane to Prevost in Dallas.

    I don’t know who said your next to the Permian Basin but all that activity is NW of you in Midland / Odessa.

    Later

    bv

  • Jim/Chris

    Member
    February 20, 2020 at 10:38 am in reply to: Loud air leak at max height

    Nope, old school mechanical tensioner.

    Darn, drove by the one shop with a pit and they are tearing it down.

  • Jim/Chris

    Member
    February 19, 2020 at 8:33 am in reply to: Air leak with power switch

    I offered the latest IPhone to him and said he can’t take one because they scare him. He’s convinced if he puts it up to his ear, a microbiotic manubler bot (cooty) will enter his ear and and he’ll fall in love with Nancy Pelosi.

  • Jim/Chris

    Member
    February 17, 2020 at 5:37 am in reply to: Compression Fittings Installation Question

    I think 1/2 turn past hand tight may be the correct spec but you likely have enough dirt and grime on the lines that getting them to all be free turning by hand will be unlikely. Wipe the ends of the airlines down before you install the nut and ferrule will help.

    Just use some soapy water and bubble check them after you put pressure on the lines again. I’ve had to tighten some a lot.

  • Jim/Chris

    Member
    February 5, 2020 at 3:01 pm in reply to: Looking for Truk?

    Careful boys!!!!

    You’re headed to no-see-em country. They out and they’re looking for you and you’re loved ones!

  • Jim/Chris

    Member
    February 4, 2020 at 4:57 pm in reply to: Consignment Dealers

    Let us know please if you don’t get a better reception.

  • Jim/Chris

    Member
    February 4, 2020 at 4:56 am in reply to: Lifeline Show Pricing

    Shipped to where you need them..

  • Jim/Chris

    Member
    February 3, 2020 at 8:15 pm in reply to: Tire chains

    Larry,

    The “auto socks” can be purchased from Prevost and are in use worldwide. We used ours last winter when the February Snowmageddon hit Seattle/Portland. Spent 2 days driving home and they worke really well. They are approved in every State that I checked. Lighter than chains and much more user friendly. On special at Prevost parts for less than $115.

    Doug

  • Jim/Chris

    Member
    February 1, 2020 at 4:06 pm in reply to: West Palm Beach Prevost Show

    Diane and I will be there.

  • Jim/Chris

    Member
    February 1, 2020 at 9:37 am in reply to: Drive Axle Hub Inner Seal Leak

    What Joe suggests will work, but so will breaking it free using the threaded holes in the flange.

    If using the threaded holes use extreme caution. work slowly and gradually, perhaps 1/4 turn at a time. A Prevost owner had a “professional” mechanic pull his axle and the idiot used an impact wrench on the 1/2″ bolts used to break the axle free, only he used it on one bolt only and it was able to bend the flange so he could not get it to seal properly after everything was put back together.

    I have used Joe’s method almost every time, but have also had to encourage it to break loose with the three bolts when it got stubborn.

  • Jim/Chris

    Member
    January 29, 2020 at 7:57 pm in reply to: Chassis Heat Issue

    Well we have an appointment in the morning at Prevost in Jacksonville and will post the repair and cost .

  • Jim/Chris

    Member
    January 29, 2020 at 10:21 am in reply to: Turbo surging under full load

    Thanks to all for your suggestions. I am fairly certain the CAC is one of the newer designed units. As stated, pressure checks showed no leaks. All the boots were changed in late 2018 and inspection this week didn’t reveal anything. Strange problem. Airfilter only has a few hundred miles on it.

    I think its time for a trip to DD to see what they say.

  • Jim/Chris

    Member
    January 28, 2020 at 8:58 am in reply to: RV Self Park!

    Marshall,

    It’s a great idea. I know you’ve been to plenty of RV Parks, my take on this facility is it’s a transit deal and not a full service campground. Easy in and out and not designed with all the frills of a Campground.

Page 18 of 76