Forum Replies Created

Page 1 of 20
  • Reagan

    Member
    January 7, 2021 at 5:33 pm in reply to: Cruise Air Repair or replace

    I did the same but painted the lower units black

  • Reagan

    Member
    January 4, 2021 at 9:23 am in reply to: Air seat solenoid valve replacement

    Chad,

    If the valve(s) are to open and admit air, close and hold air, or open to exhaust air then in my little mind I see an opportunity to create an almost fool proof way to do that.

    Start with simple valves that are normally closed. Dedicate one to admit air, the other to exhaust it. If you want to get sophisticated design a small circuit with some micro-switches to function as ride height controls. I would stay simple and just use a rocker switch with on-off-on positions with the top “on” to add air, and the bottom “on” to exhaust air. If your seat air bag and the fittings are leak free you have a simple, easily serviced, and reliable air seat.

    Put the solenoid valves in the steer compartment, and mount the switch on the seat or even on the dash.

  • Reagan

    Member
    September 10, 2020 at 5:57 pm in reply to: AGM Batteries How long last until auto start

    That’s fuzzy weights you ole Cajun, Lifeline 4D’s are 135 lbs and the 8D is 162 lbs.

  • Reagan

    Member
    August 24, 2020 at 4:59 pm in reply to: North Arkansas

    The Crystal Bridges Museum is very outstanding… it will take a few hours to go through… one of the best in the nation for what it is designed to do … a $100 million project from Alice Walton ….one of the Wal-Mart heirs…

    If you can get to Hot Springs which is beautiful in and of itself, stay at the Katherine’s Landing RV Resort requesting a river site … The Garvin Gardens there are an absolute must to see… one of the most unique places possible … run by the University of Arkansas … the lakes there are breathtaking as well…eat at the Bleu Monkey Grill or at the the Fisherman’s wharf as well…

    If you need any other ideas there ..( C ) 713 725 9486 … glad to help. Leave a voice mail … I will respond.

    Pres

  • Reagan

    Member
    August 24, 2020 at 1:16 pm in reply to: Dry camping

    Beautiful photos and great results from your upgrades!

  • Reagan

    Member
    March 19, 2020 at 9:29 am in reply to: Aqua-Hot Electric Heat

    Art:

    Not sure how to confirm that, I think when I depress the schrader valve on the top of the tank and only get fluid (not air) I can say its full.

    Aqua-Hot has worked flawlessly while using the diesel side of the system.

    P.S. The tank was sent back to Aqua-Hot a year or so ago and completely replaced, don’t think that has anything to do with it.

    Chuck

  • Reagan

    Member
    July 24, 2019 at 12:04 pm in reply to: NEW FUEL DISCOUNT PROGRAM

    To turn off Profit don’t allow access to you credit card or email or call Deb Nau.

    Since your registration to the program is already in our system if you want to participate in the new program all you will have to do is click the button when we get it alive. It will pull the data already provided.

  • Reagan

    Member
    June 22, 2019 at 8:02 am in reply to: Moab Route

    Jon is not an Indian Chief and has every right to speak without reservation!

  • Reagan

    Member
    June 16, 2019 at 7:23 pm in reply to: Inverter problem in Tucson

    Thanks Dorel, I thought I made it clear more than once the temp compensators.

    Everyone says to unhook them, Inverter Services, Donnie Myers, Jeff at ETLC and others I’m sure.

  • Reagan

    Member
    May 14, 2019 at 12:49 pm in reply to: Marathon Techlon System – EDSI

    Bathroom Lights like Bath, Vanity, Vanity Accent, Bath heat, etc a eight button switch next to vanity. Is under vanity outboard of the removable forward panel in cabinet.

    Lights above Toilet a 4 button switch.

    1229 module is behind lower cabinet in toilet area looking straight ahead. When you remove cabinet there are two 1229 modules. Top module is one you are looking for. Its power comes from jumper from lower module.

    First make sure when you see if power is coming to module. There is a light inside it. The side of 1229 is label SW Light and reset. 1st make sure the light comes on. So you may need to remove it from wall. DO NOT remove ground strap. Just loose four mounting screws and tilt module so you can see light.

    If light comes on you have power to module. If not it gets more complicated then for me to explain. Push down reset button for a second or two. Lights on switch should some on red an go out. Memory restorted. If problem persists call Brian…

  • Reagan

    Member
    April 23, 2019 at 1:32 pm in reply to: Fuel Additive?

    Hey Les, I checked at our local Walmart super center today and they didn’t have the pour spout you show. I looked it up at Walmart on line and couldn’t find it there either. Do you have any name or number of the item to help me Find it?

    Just found it for anyone interested. Just copy below and put in search box at Walmart or Amazon and you’ll go right to it. Walmart is cheaper!

    Hopkins 10106B/6 FloTool Spill Saver Trans Fluid and Gear Oil On-Off Filler Refill

    Harry

  • Reagan

    Member
    April 16, 2019 at 5:27 pm in reply to: 1997 Liberty

    That bus belonged to a friend in Abilene, Texas who traded it in on a newer Marathon in February of this year. They owned the bus for approximately 11 years. The bus had some renovations done in 2018 (flooring, upholstery etc) and the owners took care of it.

  • Reagan

    Member
    March 15, 2019 at 11:18 am in reply to: Is it true?

    When we pull the air brake knob, the brake lights on the coach come on. The towed brake lights are on too. The flashers just indicate the turning signals are working, right?

    Mark

  • Reagan

    Member
    March 12, 2019 at 5:22 pm in reply to: Mobile Service in Colorado Springs

    I have two friends in Colorado Springs that own Prevosts. I know they have a mechanic that comes to them. I do not know if an airbag is in his skill set, but I imagine it is. Standby.

    Davy

  • Reagan

    Member
    March 5, 2019 at 2:16 pm in reply to: Service in Austin TX?

    I Googled UNited Engines, Austin, tx and saw they were hiring in Austin…

    See if you can find them … they can do anything Prevost can do engine wise…

    I will keep looking for a number….

    I just called Okahoma City and they are trying to obtain a name of their sister company that they believe has an outlet in Austin. They will call me back soon…

    Pres

Page 1 of 20