Isaiah
Forum Replies Created
-
my Bus must be the only one broken.
1. 2 chassis batteries were bad. I replaced with new Napa units. I also built new battery cables for all connections. While batteries were out I cleaned the dirt off the battery floor, wire wheeled the metal and put down rust spray.
2. Determined my 24v charger is not on my bus. I’ll need to buy a new one.
3. Attempted install of dimmers for interior led lights. I purchased the wrong one. Didn’t like my tv mount in bed room and that got swapped out.
4. Installed final starboard cargo light I forgot to order
5. tracked down short in docking light in door, all docking lights now work.
6. Removed bumper and installed aft docking lights.
7. removed marker lights and installed rivnuts, pending gaskets to finish install.
8. Removed rear shocks, rear brakes. I’m stuck at the lower caliper pins on the tag axle and 2 air hoses left to
-
Thank you Jeff!
We’ll definitely give it a try when we’re down that way.
-
Hello, I did not take mine off and missed to take pictures from that side. In checking the part number on the net, I found a picture of used one where it shows it has a female/internal 1/4″ NPSF.
-
Hello all, thx for the suggestions…
Pressure switch went bad, need replacement, tried to find it, no luck, this is the part number, if anyone can provide an alternate/replacement nr.FURNAS Pressure Switch # 69mb108836u
Thank you! -
-
Two will be behind the front bumper. Two will be in the second bay, accessible from a panel on the rear wall of the first bay for the lower one, and from a panel in the forward rear of the second bay behind the entertainment system (which has to be removed).
-
Installed starboard cargo lights. The rear push button cargo light lost power, not sure where to find the breaker for that. You can see the difference between new and old lights.
new led bulbs inside are really nice and installed
air compressor installed but it keeps blowing the pressure switch on the pump at 85, I need to lower the pressure on the electric side. Also I can’t get air to my bags so more fun issues to track down.
-
Cut out old bracket and installed a new one to sit deeper
-
Aqua-Air PDF Brochure Posted in Articles, awaiting admin approval.
Chuck
-
There was a lot if positive interest in the Cruisair replacements by Aqua-Air at the Prevost Expo from both the attendees and the vendors. Looks like Aqua-Air is going to proceed forward with the project, should know more by next week. Thanks for all the inquiries, excited to see a solution for our aging dinosaurs especially since AAp has gone.
Chuck
-
yeayeaatou – appears yes… one of the narrative photos above mentions flushing out the existing oil (R-22 Mineral Oil) from within the evaporator and line-set prior to installing a new condenser
-
THANKS FOR THE PREVIEW.
-
COOL 🙂
-
I had a 77 fc and switched over to a 97 liberty. Seems like some have been listed for sale, if they are a good price they are getting purchased really quickly.
-
who said it was bad? DDec IV good thru 2000 then gets complicated when all the emission stuff was added. What are symptoms? Sorry to be so gruff but many a good ecm has been replaced because a bad wire or ground.. Bob