glen
Forum Replies Created
-
Jerry can you explain what this “shunt” device will do for you?
-
Congratulations! May you enjoy the next chapter in your lives!
-
I step out for two minutes…..
Seriously, congratulations to you all!
-
After I sold my 1991 XL ,,, Working on a project while I find another camper,,,
-
That depends on where you take it to do the work. There are so many factors to this question.
Is your current one a custom build or a standard pre-built that can just be swapped out? What type of leather, cow hide, ostrich, Softness etc. Is your current one built into a slide, or non slide. What’s the age of your coach? Will tile / carpet need to be replaced?
It would really need to be looked at for any accuracy on an estimate, but you can guess 10 to 20 hours of labor at a minimum of $130/hour plus the cost of the parts which can range anywhere from $8000 to $50000 depending on how fancy you want it.
-
Great job. Mirrors the ones I added on the Liberty because of the cruisair insanity. Ernie- former Liberty owner
-
Actually, max torque for the Series 60 is at 1200 rpm. The torque stays constant from 1200-1400 rpm for the 12.7l and 1200-1500 rpm for the 14l version. Driving anywhere in the 1200-1400 (1500) rpm band would be fairly efficient. 1200 rpms would be most efficient due to lower internal friction. But that would be pretty slow.
-
That’s my assumption.
-
finished air compressor install. pumped antifreeze back in cooling system. checked for leaks.. all-good. next project: inside door handle on entrance door release rod came off. remove pannel and hopefully re connect. will let you know if I get injured on this project..Bob
-
Some of those switches are still available from the manufacturer.
-
hate to jump this thread however on a previous post i did not get a response that I know of .
I lost prime after a battery change, any thoughts on how best to restore fuel flow and start ? Thank You in advance
-
Glen,
It looks like you have put the funds from the sale of your Prevost to good use. Now, clean up your parking space.
-
Known as freeze switch. keeps coil from icing over
-
You can replace the 3 with a 4. The 4 will give you more info than the 3
-
Great thread and good information. Do older inverters say 20 years old have pass thru power. Our inverters power refrigerator, gally ,tv,air compressor, bed bath,bay,outlets. Why would you not use shore power, and have inverters for backup .Wanting to up grade and go with newer products, looking at Magnum or Samlex thanks in advance.