glen
Forum Replies Created
-
I find we use it more when we have guest. The one I think I would like best if I do it again would be build in a compartment hiden under a ghost door behind the bus sideing. Seen it once was hidden along rivet lines. It had a air lock release. Bob
-
while at Liberty Coach in Florida, a few of us bored guys sat and watched a guy from “dazeling detail” remove the 3M shield. He used a heat gun and a plastic scraper ( like you would use for body filler) then cleaned the adhesive off with acetone. It took him about 7 hours to remove and about 4 hours to replace with new 3m film. set the coach owner back about $800…..looked nice though.
-
Leather was about twice the material cost of cloth so that will be a factor as well.
-
Welcome to the forum Yankee802! It was nice to visit with you and your wife at Tallahassee Flying J. Thanks for flagging me down. Glad you had a good trip to the Tampa area. I hope everything goes well for you there. Keep in touch!
DKO -
That’s Prevost Parts in Elgin, IL.
800-799-9938
Give them your coach model year and serial number and they can find the exact parts you need for anything.
-
Those Liberty guys are always polishing their pipes!
-
Congratulations!!
Invest that in a tank of fuel ASAP…. it’s the only part of the bus that will actually appreciate in value..
-
You are correct ,Jon. The procedure that you list is what we do when we are asked the question of panel adhesion. Thanks!!!!
-
Sold the Hog, but still have the bicycles. The bikes will still go on the rack on the back of the Avalance since the Criket would fit with the tailgate up. I wouldn’t carry the Criket all the time, just when we’re going to be in places where a golf car would make sense.
They have been making these for some time, but I haven’t actually seen one, so I was hoping someone had information about whether they’re good or not.
-
OK guys…….Joe said he fixed the problem, Steve just proved he did not. Is there an I-pad user that can post something to see if the problem is with Steve’s or if the problem is with all i-pads.
May I suggest you do a test post with your social security number, date of birth and a few credit card numbers?
Or just any combination of words if you are shy about sending me on a spending spree.
-
Thanks, I just sent an email to IBP and I will check chrome shops as well. Great Ideas.
DKO
-
No problem! Fully understand!
-
g-4 led 12volt play around with it g4 or g6 base are almost same. should be replacement out there. the wires on back are bendable to fit receptables of most sizes. The lights are neat to work with. easy to solder pig tales on little or no heat. If I get chance I’ll look around a little:: I think the zeon is what I replaced with these..Bob
-
Regardless of who the convertor is They are on a Prevost platform what a way to start!