Frank
Forum Replies Created
-
Dorel,
If the engine starts the alternator will charge the house to get the inverters going. You should have Xantrex if so go to the remotes and move the cursor to ON (a line under on) they will come back on line.
Need more info to figure whats going on. Do you have the shore power breaker in the basement to let power in?
I just read your post again. What compressor belts are not turning? You sure it’s not your big alternator ?
Later
bv
-
we just had lease truck hauling asphalt on H E Bailey Turnpike for us forget to lower bed on truck after unloading drove 1/2 mile with it up toor bed of truck shut down Road 3 days at 3000.00 per hr peanelty before able to open plus repair on bridge
-
Are you in Las Vegas or some other extremely low humidity area? Ours usually pour water but here in Vegas……nothing!
-
Jon,
Just in case you are a slow learner…. ALL OF IT
rofl
-
Was at Prevost Winter Garden last week. They WILL NOT let you stay in the coach anytime it’s IN the shop.
Chuck
-
Frank,
Is the compressor coming on?
-
Guess it an H thing or Featherlite but also fun fact that stainless line that feeds the aluminum manifold has a screen filter at the other end of it which in mine was clogged up not allowing Freon to flow to that aluminum manifold which turned out to be my issue, since Freon wasn’t flowing the switches where not reading the pressures and not turning on the fans. We guess now I don’t have to worry about the relay and the switches for a while and if they do go bad I have some spares lol.
-
Holy crap Dick…..that is some list ” the need for speed”.
The one that jumps out is the 92 mph snowmobile run.
AL
-
This is the valve Truk is refering to in his above post.
-
ColoradoBus: Cresco, OK or Cresco, Iowa?
-
Yes it is the Aux Air. I am heading to Fleetpride now and I will see if they have DOT compression fittings.
-
THANK YOU Tom & Don. Excellent idea & appreciate the photos! Glad Tractor Supply is near 🙂
Seems the existing t-handle valve is similar to an old refrigerator water line shut off valve and those, at least in my experience, always failed. Perhaps replacing this valve will improve my aux air tank hold time. Thanks again!
-
How about a ball valve from Tractor Supply? This one is 1/4″ male npt, and 1/4″ female npt, $20.
It can be found on the isle with all the other air hose fittings etc. They have larger ones too.
-
I watch his videos for the “entertainment” value. He seems nice enough. Owns a plastic that he has dropped a lot $ into lately. Seems to like Liberty quite a lot and the famous coach painter, Dean Loucks [sic].
I did watch the de-lamination video and thought it would have been beneficial if he has a PC membership so that he got to the truth of the matter before scaring the tar out folks with the every 10 year crap.
Hope everyone on the forum is doing well.
R
-
When I first contacted Prevost I thought that the dash was stock Prevost and found out of course that I was wrong again. Thanks for all the help and the link to the Beaver stock. I have no doubt that will come in handy!
And Chad, thanks for the mention of “Carling” I missed that.
Thanks again,
Harry