Tim
Forum Replies Created
-
8V71 has that shut off but the 8V92 does not. I would check the left exaust expansion pipe first for a break and also the right exaust pipe. The flanges will rust so look close.
Gary
-
When it became a standard feature on a Marathon I don’t know but mine switch automatically.
When on shore power the 120v is on and when driving the 12v is on. You can manually shut off either one in the closet for storage.
Later
bv
-
Your last paragraph says it all Tim. I have the Headhunter and a small Shurflo as back up. Both provide the same system pressure, but the only difference is the amount of flow. Until I see a wet spot I have no indication my water system is leaking.
-
I have a charter bus customer with a location in Seattle. They can help out and get you in pretty quick. MTR Western in Seattle. Tony Tolle 206.838.8131
-
I’ll let you know how 120 is when we leave on Thursday. Heading up 99/5 to Oregon.
-
You’re better at spelling than me 🙂
Yes … but I was interested that Marathon changed to all 12V water pumps instead of using the 110V water pumps.
-
Yeah Buddy and when you do what Tom says be sure and borrow his shoes okay?!!
Cheers, Diane
-
if i remember right the 8v92 had a airbox emerg shut down lever (electrical actuated ) that would cause the smytoms you are having … not sure if you have that or not ! but if it is all you need to do is reset it manually …
-
I had one of mine go bad a couple of yrs ago. Here’s what I posted.
https://prevostcommunity.com/forum/threaddetails.asp?Category=Electrical&ThreadID=6000
-
Good points… I always go to the bedroom after powering up to check volts, amps, etc. and maybe I’m also too impatient, I just hit the reset when it’s blinking. It doesn’t do it every time, only occasionally. I think it only does it when I have the charger on, so if I have the charger time set to zero and floating as soon as I plug in, no reset blinking.
When Leon retires, we’re in trouble.:)
-
It definitely is an adult toy, but it is the type you would be able to show your mother.
-
Looking at the air schematic, it looks like the 5 port valve is pilot operated so if you feel you can take that valve off you should be able to remove the end caps of the valve without worrying about a spring popping out. You will need either a Phillips screwdriver or an Allen wrench, once you get the caps off making sure you maintain the orientation of each cap(take a picture). Once the caps are removed gently try to push the spool out, also maintaining the correct orientation. Clean the spool as best as possible and the inner body of the valve. Check that the o-rings if applicable are clean and absent of any rust or corrosion, once that is done apply a lite amount of Vaseline or lubriplate to the spool and the inner body of valve. When replacing the spool in the body make sure the spool is all the way to one side or the other. Replace both end caps and give it a go. This hopefully will get you up and going till you can get new valves.
GOOD LUCK
-
Donaldson # P522874
I don’t know about blue?
-
Thanks Patrick,It’s folks like you who make this forum great!
Harry