Forum Replies Created

Page 17 of 83
  • Tim

    Member
    September 2, 2017 at 10:08 pm in reply to: Topping off Over the Road

    Gerald you wrote: “The bus interior was cooling down nicely (air at vent was 58 deg F) and the compressor started unloading”

    By unloading, do you mean dropping pairs of cylinders? If so, how could you tell?

  • Tim

    Member
    September 2, 2017 at 7:59 pm in reply to: IS Otr/bus air a must have or like to have?

    Thought I may need it when I looked at a bus a couple years ago; however, we’ve only turned on the generator once going down road to turn on the Salon A/C (Instead of using Inverter). It was 95 degrees going into the sun.

    Like Mr. Mark, we avoid the SW in the summer, despite living in Tucson for 14 years, there’s no reason to travel to those parts in the summer.

  • Tim

    Member
    September 2, 2017 at 7:05 pm in reply to: Topping off Over the Road

    I would wait till tomorrow, then check the vapor pressure reading against the table for the ambient temp. That will give you an idea where your at.

    I assume your filling from a 30Lb tank? If so is the tank shutoff valve getting COLD when your adding Freon? It should be.

    To get it to fill faster you need to add the Freon in a liquid state. If it was mine, I would open the suction king valve no more than 1 turn to add the Freon in a liquid state(faster) without hurting anything.

    Heating the tank does force the Freon out, BUT I wouldn’t do it that way.

  • Tim

    Member
    August 31, 2017 at 4:11 pm in reply to: Traveling with Protection

    Thanks Chad, I’ll have to research it.

    Andy

  • Tim

    Member
    August 30, 2017 at 6:58 pm in reply to: Hey Jim L of Coloradobus fame, we need a subject

    Harry … for the record. I have plenty of Blinker Fluid. I’ll never run out of Blinker Fluid. You shouldn’t worry about anyone else’s Blinker Fluid … worry about your own Blinker Fluid.

  • Tim

    Member
    August 30, 2017 at 2:38 pm in reply to: Coach wont lift.

    Those numbers would be applicable to solid steer axle XL coaches.

    There are a lot of variations in part numbers for air bags and Now that I have cycled through air bag replacement I will not order by VIN because Prevost has gottent them wrong that way, but will not order by actual air bag number. I always log the part number, model number or any other kind of identification on any part regardless of supplier that I install or replace on my coach.

  • Tim

    Member
    August 28, 2017 at 8:21 pm in reply to: Sept 22-24 Evansville Indiana

    Bob,

    Any hints on best route coming in from the west on I-64? Looks like I could use most of the route Jon posted. Just wondering if you know of any better way from the west?

    With all the buses coming into town, I figuire the more we stay on prefered routes the less stress for us and less aggravation to the locals.

    Thanks

  • Tim

    Member
    August 28, 2017 at 2:51 pm in reply to: Pressure Pro Pulse

    I just got Tom’s check for my share of the dues money.

    I was extremely impressed because the total amount had a lot of zeros. My elation was short lived however because when I went to cash it the bank said the first digit had to be something other than zero.

    Maybe he just made a mistake and left out a number.

    I guess I have to be satisfied with my commission checks for selling muffler grease and sailboat fuel.

  • Tim

    Member
    August 27, 2017 at 5:53 pm in reply to: Sept 22-24 Evansville Indiana

    Is there a recommended preferred route to get to the rally site? I am not familer with the Evansville area and looking at the map it seems there could be a least 3 different ways to approcah the park. Is there an easy way in and out?

  • Tim

    Member
    August 27, 2017 at 8:29 am in reply to: Pressure Pro Pulse

    Tim, 40 degree is for the temperature.

    I love my system, bought it through Tom. I have the one with the repeater and 40 degree increments.

    I never have to check my tires anymore, just turn on Pressure Pro.

    I was a little alarmed at first when one tire showed 190 degrees, and the one next to it showed 150. Then, I realized by verifying with a temp gun, that if it is really 151 degrees, the monitor will show 190.

    Increments are

    70-110

    110-150

    150-190 and so on, Tom correct me if I’m wrong on those……

    Easy to install too.

  • Tim

    Member
    August 26, 2017 at 4:18 pm in reply to: Well ah S#@t

    Couple more pics of the bus.

    Home now, bus is unloaded(lots of fun getting everything out through the window). As we inspect we continue to find more damage, cabinet and floor damage back into the galley. The entry is pushed back into the front of the wheel well, the tire will rub on a tight turn to the left. Front cap is bowed above the windshield and has distorted where it connects up on the roof. Inside the first bay the ECC has about a half inch gap where it has separated from the bulkhead. There’s more, but you get the idea.

    Jon pointed out something to me about the Prius, with the battery load they carry they are heavy for their size.

  • Tim

    Member
    August 24, 2017 at 9:27 pm in reply to: Gremlins ?

    Mine hasn’t had any problems in the last month or so. My boogers have taken up with somebody else. Of course, I have been sitting in mine, in the AC, in it’s new Bus Barn watching the house being built. When I start it, and cruise out, before I get back to barn safely, something will go haywire. Good luck and don’t send the Grimlins back this way.

    PS

    I think it Harry’s fault!

  • Tim

    Member
    August 22, 2017 at 9:31 pm in reply to: Well ah S#@t


  • Tim

    Member
    August 22, 2017 at 5:23 pm in reply to: Solar Eclipse rally update

    It has all been said, and couldn’t think of a more fun way to spend our 40th.

    One of our highlights was, the mayor of Driggs came to visit on his bicycle. Looked like an indoor racing model because it had no brakes. Said he made the frame himself. It was obviously made from BAMBOO, picked it up with one finger.

  • Tim

    Member
    August 22, 2017 at 9:46 am in reply to: Differential pinion seal/gasket

    Thanks everyone for your very helpful comments. I have requested Prevost to inspect the differential vent and to clean the residual fluid on the differential drum housing. I will keep an eye on it and should there be a serious leak I will have the seal replaced.

Page 17 of 83