Jon
Forum Replies Created
-
Very Nice welcome to the Club took us a while to find our 40ft Like Bill said Rincon is beautiful I can barely get the bus and a Honda CRV in but do able
-
From Beijing and a long way from an eclipse we hope for clearing weather. Have fun.
-
Odd that it would take out one instead of both house battery banks and inverter/chargers. On older ccs the alternator charged two house battery banks wired in parallel to act as one. One bank/IC handled the drivers side and the other the house side. If alternator over voltage took out one it seems likely it would have taken out both. Look for some other cause like a short in the wiring on the failed side. On older ccs there is a fuse block behind the black panel centered between the two I/Cs. I would sure want to know the real root cause before plugging in to shore power.
Jerry
-
Can you use the level low manual controls to lift the front and then the left and right rear? If so, the “Drive” solenoid on the 5 stack level controls needs replacing. I believe it’s the 3rd from the top and should be the same voltage as all (or nearly all) the others. This means you can swap out the drive solenoid for one of the others that’s working to get that operation working again. This will get you down the road safely until you can get a replacement. It will only limit the manual capabilities of the level low system but that should not be a big deal for a short time.
-
The newer Dometic Penguin ac’s are a little quieter and smother because of all the plastic. I use to be a Dometic tech a few years back and I did Dometic and Coleman and both were decent, the Coleman that were equal to the Penguin had a large fan pointing straight up, I think the Coleman made a better unit, They are wired totally different, Penguins the controller is down stairs and everything wires to the up stairs furnace also (Aqua Hot) where the Coleman is wired to controller. Nothing is made like the old stuff, My Royale has all the OEM ac’s still working and they are not that noisy but when they die I will probably go with Dometic just because it would be easier, What your doing looks awesome and after you get all 3 up and working that will be interesting how they perform and sound Good Job. I’ve had a customer years that soldered a port in found the leak soldered charged it up and it worked great, For the longest time I had in my shop 2 slightly used Penguin ac’s with heat pumps that I replaced that weren’t very old I was going to fix and put on my Foretravel but I sold Foretravel and I gave them to new owner. All the roof ac’s are throw away’s I think alot of them could be fixed.
-
A little over 1 gal per coat. That’s using a heavy nap roller.
The company estimates 2 gal of primer, I sanded the the roof and put the primer on heavy (to the point it was almost running off) and used only one coat. Another Prevost owner had the same experience. I suggest getting only 1 gal of primer.
Same issue with Bus-Kote, companies Sq Ft coverage shows 5 gal required, I put it on pretty heavy and used about 3 1/2 gallons.
Good news is you have leftover for touch up or other projects.
Chuck
-
Good luck. Had those slides years ago. Front slide racked out due to sync cylinder failure.
-
It would try to start but then blew the 12 volt breaker, got that fixed now it will try to start but will never really catch. Acts like it’s a control issue. The iPad keeps giving gen error
-
We full time and if I don’t keep a charger on the engine batteries they will be dead in about 2 weeks. With the charger on there I have never had a starting issue. I will stick with the charger option.
-
That is the monitor for the chassis and just to be sure there is no issue with continuity I check its input at the base of the equalizer and then at the monitor.
If the voltages are within range and I have a dash light the monitor is bad.
I disconnect the output so I do not have the warning light to stare at.
Those monitors had a tendency to catch fire but later versions were OK.
-
Same with me it has been sitting since October because of surgery so I ran charger for 3 hours yesterday and amp meter was on 0
-
Hey Jon! I looked at mine yesterday I’m sure it’s close to Georges 98 and from Vanner EQ there is a small cable that goes from Vanner controller small box to Vanner EQ to the 3 lugs at bottom and on controller says lights must control dash lights maybe a wire is loose?