Jim/Chris
Forum Replies Created
-
Apex,
Not a problem at all…just had the question.
AL
-
and yes has the two alt.
-
Good point Jon. All the bags I referenced have bottom studs the same, 4.12” apart. All have top fittings the same 4.76” apart with the combination stud/air fitting being 3/4”-16 and 1/4” NPTF. All have the top fittings oriented 90 degrees from the bottom studs except one. 630151 = 1R12 377 has the top fittings and bottom studs parallel to each other. So none of the drive or tag bags could be put onto the steer axle. That being said, all the Prevost part numbers that I matched to Goodyear part numbers are good.
-
I know we sound like a broken record when it comes to keeping moisture from the pneumatic system, This becomes critical when traveling in below freezing temps because moisture within the system can freeze inside critical components and prevent them from functioning.
Marathon has a unique and somewhat complex accessory pneumatic system and when traveling in cold temps it is important that both the Prevost and Marathon sides are dry, and if the aux compressor is used regularly it is important to insure moisture put into the system(s) by the compressor is drained. The good news is very cold air has very little moisture.
-
The emergency car has a negate button for the stop/start technology that stays negated upon cycling the ignition switch. Helps to save the battery, save the starter motor, and reduces the glut of petroleum products on the world market. All good.
-
Because of your proximity I would suggest ETLC. I would not suggest you take it to a shop that only fixes conventional RVs. If you are in Florida I would also suggest Tradewinds.
The switch may not be what is bad, but regardless of the cause I would strongly suggest it is modified so it only turns off when the ignition is off and there is no external or generator power and that you eliminate the on-off switch.
-
Any good tricks for keeping new refer doors closed in travel? the old Whirlpool had cabinet latches on the bottom of the doors to latch the new Whirlpool is completely different and can’t do that. Also Jonathan did you get my E-mail to call ? You have the same set up as I do 2 magnums and same auto start box I would like to ask you a couple of questions. (805) 712-9449
-
Hey Tom what’s the part number? Did you get it from Granger?
-
Harry…in most cases, your mouth should be closed. Ha.
-
Don I wonder if that Belt Tension kit would fit our 1994 Series 60. I might have to go that route It seems that a 27 mm wide bearing is hard to find. I just hate to spend another $10000 right now.
Thanks
Craig
-
I spoke to the guy in the boathouse my last time up there about that very thing and was told straight out… “NO one from ETLC welcome”! Said if Jeff needs to walk on water build a pool!
Harry
-
I always watch my auto fill because it fails to shut off randomly. It mostly fails more in cold weather, but will also fail occasionally in warm weather too.
Davy
-
Joe/Joel, I think you mentioned that in the other thread, ,Mine do not appear to be “tripped” ran out of time to check voltage/amperage.
will keep checking
-
My experience with that symptom turned out to be a bad switch. The rocker switch on the dash.
-
Nice Mark, looks like a great time!