Dick
Forum Replies Created
-
Peter at Almost Chrome Metal Polishing in Nashville, TN 615-351-5932
-
I saw about the same on my 2016 Liberty (2015 shell) for increase in fuel mileage. I used about 2 gallons of DEF each 120-150 gallon fill of fuel. I had the old fan system. I got info from Prevost about upgrading to the electric fan, but it could not be done on my coach because they don’t cool the a/c condenser with the electric fans. They relocated it on the newer coaches to the passenger side 4th bay on an H if I remember correctly. It seems to be a beter way to go, as my fan runs almost all the time with the dash air compressor on. I know that is impacting the fuel consumption.
I had two coaches with the Detroit 60 series and the Volvo is better as far as I am concerned. Quieter and more fuel efficient.
-
It’s a new process, they will figure it out and it will come down.
Actually I heard there’s a Liberty guy doing it to his 2017, 1st one.
Yes were home in La Quinta.
There shutting everything down again, nothing allowed inside. No place to eat but home.
Later
bv
-
My older series 60 at 60 mph I would say right around 1300 rpm’s
-
Bill, It’s probably an HWH system. You should be able to trace from the service door down from the switch or the leveler back. There is a solenoid in the system and for what it’s worth, my wire is marked HWH and is orange.
-
I never want anyone to make the leap from what I suggest what something can and cannot do with any kind of suggestion as to what YOU should do in your own coach. FOR ME…….I would never go back to a dome (yes, I had an in-motion dome for many, many years) now that things have changed so dramatically and my aversion to watching commercials now that I am able to utilize a DVR for nearly all of my TV watching. I have never tried it, but I suspect you could DVR hours of the various music channels and “watch” them as you drive, again, without interruption. Don’t hold me to that, as I have no reason to attempt that……..Hum, I wonder……
-
Dick
MemberNovember 12, 2020 at 6:22 pm in reply to: Looking for recommendations for some paint workOnce the clear coat is gone your entire paint job will follow unless you take some action to prevent it. Keeping it waxed won’t help. You need to address it as soon as possible. This assumes that it’s clear coat on the paint and not just some clear coat that is on the roof and not part of the graphics.
-
Those switches will tend to act up sometimes when they are left in one position for a long time. dirt, dust, oxidation of contacts? Before you buy a new one, if yours tends to be left alone most of the time, I would cycle the old switch through it’s entire travel several times.
-
I would keep an eye on that belt for awhile…screwdrivers are not necessarily a recommended method for belt installation.
-
Jimbo, I recognized some words like Crestron, but my Crestron is only used to lock and unlock the bays that I keep bales of Benjamins in.
Does Crestron play the Lennon Sisters??????????
How do you keep the needle from jumping when you play 33s or 45s?
-
Jon,
Don’t travel alone. Let me know next time.:)
-
Put me down for the Oysterfest in April.
-
Thanks for the ideas.
I ordered the new belt from Prevost based on the VIN and config, but will double check with them on sizing.
What is more interesting is that I have 1/2 inch breaker bars and my tensioner is definitely too tight to move one handed. I wonder if my tensioner is not correct in some way which is causing the difficulty. With that said I had the same belt on for 6+ years and no issues so I don’t think it is urgent, but now that I know it shouldn’t be so hard to move, I think I will have someone take a look next stop at a shop where they are familiar with the expected tension.
-
Yes, as it turns out, the circuit breaker is a GFI breaker, it isn’t downstream from a GFI outlet as I had presumed. You guys were quick to note the difference; thanks!
So..I’ve cycled and re-cycled all of the breakers but still no joy. Next is to check for a flaky GFCI breaker and see what I can find. I will post the result whenever I learn what is actually the culprit.
Thanks to everyone. I’m really, really enjoying getting to know the rig, but have to say, this is an entirely different ball-game when compared to some previous coaches (Monaco, Fleetwood, Winnebago).
Cheers and stay safe…