Forum Replies Created

Page 30 of 214
  • Dick

    Member
    March 7, 2021 at 12:31 pm in reply to: Out With The Old, In With The New

    Just to jump in here quickly; I finished this same upgrade two days ago – same regulator from same supplier (unaware that others were doing this!)…and it fixed a host of problems.

    I’ve had fluctuating current on the 12v side of things in the house and multiple electronics were not happy. Specifically – the Red Dot Marathon OTR control boards wouldn’t work and were most unhappy.

    Cleaned a ton of grounds, added a ground, checked tightness, and still dash lights pulsed bright/dim and the A/C controls were inoperative, with situation worst at idle.

    I removed the voltage regulator and had it tested and the results said that it was fine….27.7 volts and all good to go. But still the flickering, unstable current after replacing.

    Replaced the regulator with the new 990 one and bingo. Rock solid current and now everything works perfectly on the house side, including ‘Marathon’ OTR A/C.

    The point of this posting other than to share: Here is a link to a file that I obtained from Prevost with their instructions for replacing the original 111847 with the newer 10503805. It was most helpful and I wanted to share for anyone else perhaps considering the same upgrade. In the end, I figure 25 years for a voltage regulator is a pretty good lifespan 🙂

    John

    1118447 to 10503805

  • Dick

    Member
    March 4, 2021 at 10:18 am in reply to: 12v switch by front door

    Nice good thinking.

  • Dick

    Member
    March 3, 2021 at 6:56 pm in reply to: What else

    Tom thank you sir I really appreciate it.

  • Dick

    Member
    March 3, 2021 at 9:48 am in reply to: What else

    My first reaction when I read your post was to think if you have a temperature sensor on your inverters. As you likely know the charging voltage varies as temperatures vary.

    But my second thought was that it could be an indication of tired batteries or possibly a battery with an internal short.

    I presume if you are subjecting your batteries to heavy loads that could be another reason for staying in bulk, but with light overnight loads that would certainly allow the inverters to get into float.

    What kind of inverters do you have and how old are the batteries?

  • Dick

    Member
    February 26, 2021 at 11:58 am in reply to: WE ARE 5000 STRONG

    Thanks Guys for this site and all the info that comes from it; even the BS,Lol.

  • Dick

    Member
    February 24, 2021 at 1:56 pm in reply to: Trace inverters

    I cannot speak about others, but when I set my charging current it is fixed until I change it again. It does not matter if I am on shore or generator power.

    I typically use a very low current setting in the heat of summer so I can run A/Cs and other electrical loads without tripping the shore power breakers. With low current charging settings it might take all night to fully charge the chassis batteries, but that is OK.

  • Dick

    Member
    February 23, 2021 at 8:51 pm in reply to: coolant leaks

    Cold weather creates more leaks in the coolant system than anything else.

    Get a screwdriver and tighten the multitude of hose clamps.

  • Dick

    Member
    February 19, 2021 at 10:57 am in reply to: Generator removal from a Royale

    I feel your pain. Can’t get to the back of my Wrico to access the regulator. They say that’s what’s my problem is as it drops power after running for 20 or 30 minutes. Did notice bolts in top of rail beside Kubota motor and that might be your deal also. Think those bolts stop rollers from coming out to far.

  • Dick

    Member
    February 18, 2021 at 10:45 am in reply to: Marathon Coach Schematics

    Also note, we are not talking about simple linear point to point wiring. Starting in the late 90’s Marathon switched to multiplexed wiring with programmed nodes using a CAN bus like signalling scheme. No simple fixes other than replacing cables/nodes not unlike modern cars.

  • Dick

    Member
    February 18, 2021 at 12:34 am in reply to: Wow, look what Winegard bought

    Thanks Al

  • Dick

    Member
    February 17, 2021 at 8:03 pm in reply to: Roof Airs Leaking Water into coach

    Thanks Art. I will take a look tomorrow and give that a try!

  • Dick

    Member
    February 15, 2021 at 12:41 pm in reply to: When Is Empty Empty?

    I’ve asked Robert Hitt from Prevost to enlighten us.

  • Dick

    Member
    February 15, 2021 at 9:46 am in reply to: Broke Down In Chattanooga Tn

    Can’t you pull the relay for the daytime driving lights to help save the battery’s?

    Chuck

  • Dick

    Member
    February 12, 2021 at 3:40 pm in reply to: Hard Freeze in Houston

    if your not gonna winterize it, fill it

  • Dick

    Member
    February 12, 2021 at 1:42 pm in reply to: Possible beginning of runaway engine???

    Many moons ago I had a gas pedal fail. At least I thought that is what it was.

    As it turned out when I started to pull it out to get a part number from it I found the connector had been pushed together with one of the pins skewed sideways, not in the hole but touching the metal around the hole.

    I think it came from the factory that way. The coach was about 10 years old at the time. The fix was to straighten the pin and make sure it went into the connector.

Page 30 of 214