Archived
Forum Replies Created
-
Year or coach? Any evidence it was used to pull an oversized stacker trailer?
-
I have had the Continental tires for the past three years. I replaced Good Year tires. The ride and handling have been great and I have had zero issues. I have never had Michelin on the bus.
-
Maybe loose connection caused heat and then that?
-
Good news is, it looks like the part of the connector with the pins on the circuit board can be saved by careful cleaning with contact cleaner. That is a custom part and likely hard to find.
The plastic female connector part that melted would need to be replaced and the ribbon cable shortened a bit to expose undamaged wires. If you don’t have enough slack to shorten the ribbon cable, you could patch in just the wires that corroded/melted.
Count the wires in the ribbon cable and search for “female ribbon cable connector” with the appropriate number of pins/sockets.
Here is an example
https://www.mouser.com/ProductDetail/HARTING/09185406813/?qs=GZB%2FOSW0r0G7wPxAoQA0Lw%3D%3D
-
Be aware the Jetpaq had a built-in accumulator tank and the Mach 5 does not. I had to install a tank when I changed pumps.
-
Al,
Vanner said unit was beyond repair last year. Currently 28 VDC and 14VDC are the readings I get at the Vanner and the Marathon Dash Monitor. Vanner keeps the a newer version of old unit in stock and price was good.
-
I’m in Maine and it was 0 yesterday first time I have every had the us in these conditions but to my surprise it’s doing better than I expected.
-
Archived
MemberFebruary 27, 2021 at 10:17 am in reply to: Advice Requested for Removing a Splendide 2000Thomas, removing and adding shelves, or a closet, is exactly what the best half wants to be done.
R
-
Hello Chuck – believe you are spot-on. Have also been told simply dropping the door is what causes them to break.
Was told to prevent cracking, to gently lower each door without grasping the bottom panel, then push it at the top with your palm to “click” it fully closed.
-
The panels are from factory glued to the door with Sikaflex. The old ones have to be cut off with a long knife and the door cleaned before putting them back on. Sikaflex can be ordered through Prevost for a reasonable price.
I replaced all my panels last year.
-
The factory ones are fiberglass but the ones I purchased are composite and they work great and so far very durable
-
Speaking of fires, Jeff sent me this today from CA, I have no details.
-
Archived
MemberFebruary 26, 2021 at 4:15 pm in reply to: Advice Requested for Removing a Splendide 2000Al,
Looks like you are the only one thus far that wants this Spendide2000. Come up and help me get it out and it is yours. eMail me and I will provide my personal cell phone so that we can discuss.
Ron