Prevost Community Forums

Find answers, ask questions, and connect with our
Prevost Community around the world.

  • Headhunter JetpaQ

    Posted by David on February 27, 2021 at 6:37 pm

    Hello,

    I need to replace my Headhunter JetpaQ water pump. Do they make it anymore? Will the Mach 5 work as a replacement?

    Thanks

    David Thomas

    1998 Featherlight XL

    Gerald replied 5 years, 6 months ago 15 Members · 17 Replies
  • 17 Replies
  • Roscoeapproved

    Member
    February 28, 2021 at 8:37 am

    Jetpaq was phased out many years ago. You’ll have to switch to something like Grundfos or Headhunter Mach 5. You will likely have to change some fittings as well.


    Jeff and Lindsay

    91 Marathon XL
  • Chuck & Katrina

    Member
    February 28, 2021 at 9:44 am

    DT, we replaced our Headhunter Mach 5 last summer. After talking with Headhunter (very nice and helpful, btw) with like. We wanted to carry a spare, so they told us if we sent the the metal label off the old pump, they would do a considerable discount for another had we known about that before ordering one on line, we could have bought first replacement much cheaper. I think it was around $11000.

    you might call them during the week. From photos i “googled” of ea the Mach 5 and Jetpaq, they look similar in the positioning of connections


    2000 Featherlite H3-45

    2024 Jeep Grand Cherokee

    Leesburg, FL
  • Archived

    Member
    March 1, 2021 at 11:53 am

    Be aware the Jetpaq had a built-in accumulator tank and the Mach 5 does not. I had to install a tank when I changed pumps.

  • Gerald

    Member
    March 1, 2021 at 12:01 pm

    Regardless of whether the pump has a built in accumulator tank or not, if the coach has a headhunter toilet there should be an accumulator tank as close to the toilet flush valve as possible.

    I have done that and have a tiny Shurflo 60PSI pump as a emergency back uo to the headhunter pump and I can still flush the toilet. Without the accumulator tank I would never get a complete flush. I did that so I would not have to share a toilet with 10,000 of my closest friends at a rest area.

  • Pat

    Member
    March 1, 2021 at 12:03 pm

    Hello, what is involved in the installation of the external accumulater tank? My JetpaQ when turned off, the pressure would immediately go away..

    Thanks

    David Thomas

    1998 XL

  • Ronald

    Member
    March 1, 2021 at 12:10 pm

    You need to find a location where you can install the accumulator as close to the toilet flush valve as possible. It will work for the whole house, but its proximity to the toilet will assure the toilet will flush completely.

    See the above photos. I had no room in the water bay so the bathroom was right above it making the undersink location practical.

    My coach also has another accumulator tank, but it located so far away from the toilet flush valve water could not flow into the valve fast enough or with enough volume.

  • Tad

    Member
    March 3, 2021 at 12:57 pm

    Actually, has anyone determined that you have a headhunter toilet?

  • Bill

    Member
    March 3, 2021 at 6:47 pm

    Hello,

    I just finished installation of the Mach 5….Pressure is awesome and toilet flushes perfectly. I have ordered a 2 gallon accumulator tank and plan on installing soon.

    Thanks

    1998 XL Featherlight

  • Archived

    Member
    March 8, 2021 at 12:30 pm

    Assuming you have no other accumulator tank, you need to. The mach 5 will run often for short periods of time without an accumulator.

    When I installed my new mach 5 w/o accumulator, it overheated from frequent cycling and shut itself off. Of course, my fresh water temp was over 100F so your mileage may vary!!!

  • Archived

    Member
    March 9, 2021 at 9:44 am

    Hello,

    I have very little room left in my Water Bay. I just got in a 2 gallon accumulator tank but it is too big to fit.

    What option is best?

    1) try to find a 1/2 gallon or so small tank that would fit in my bay.

    2) Install the 2 gallon tank under my bathroom sink. (This is on the opposite side of coach maybe 10 feet away from bay valves

    Thoughts?

    Thanks

    1998 XL Featherlight

  • John & Billie Jo

    Member
    March 9, 2021 at 1:52 pm

    I placed my accumulator under the bathroom sink, It is a Shurflo 2 gallon and fit nicely in the cabinet. See photos above.

  • Dick

    Member
    March 9, 2021 at 10:40 pm

    Is the shureflo just for flushing or is the flow enough for showering, washer, etc.

  • steve

    Member
    March 10, 2021 at 8:37 am

    The primary water pump is the Mach 5, but if it fails I have a low flow Shurflo pump which is about 1.2 GPM and a 60 PSI shut off. I can close valves to and from the Headhunter pump, and open the valves to and from the Shurflo pump. The intent is to not be inconvenienced by a failed Mach 5, and to allow the completion of a trip so I can replace the Mach 5 in my garage and not on the road.

    The added accumulator when fully pressurized allows for a complete flush of the toilet. The Shurflo pump is adequate as a back up and will be OK for washing dishes, showering and for fully pressurizing the accumulator so it works as a back up. I do not think it will allow multiple toilet flushes or taking a shower and flushing the toilet unless or until the accumulator tank is fully pressurized.

  • Archived

    Member
    March 10, 2021 at 10:06 am

    Good stuff Jon. Can u explain how the A tank is pressurized with the shureflo and meaning of multiple flushes.

  • Towson

    Member
    March 10, 2021 at 10:06 am

    Good stuff Jon. Can u explain how the A tank is pressurized with the shureflo and meaning of multiple flushes.

Page 1 of 2

Log in to reply.