Jon
Forum Replies Created
-
I have a M&G on my Excursion. Truthfully I wonder how well they work. If you try to stop the car without the engine running you barely slow it down. The MG has a air cylinder attached to the Brake master cylinder. Without the engine running how is this any different than putting on the brake pedal?
-
This thread looks like a good argument for the Airdog filter block that Jon has.
-
Luc, You will find the ability to raise and lower the coach and have it in motion at slow speeds is an important feature.
What is important is to recognize in advance when the need occurs and to take advantage of that ability. Our coaches are often going to be at risk, not only for high centering, but when approaching or exiting locations with steep transitions such as a steep driveway that because of front or rear overhangs can cause the bus to come in contact with the ground.
You also have to be aware if you lift the tag axle such as to get traction or to shorten the turn radius that the rear is going to drop, making rear contact with the ground a potential risk. Ground contact is not limited to the coach, but can occur with some hitches that are low.
Experience is something we all get right after we need it and like almost everyone on here I have dragged the rear on a short steep driveway, flattened the steel generator radiator exhaust baffle or scraped the bottom of the engine cradle. Get to know your coach which may differ from others, depending on what the converter had hanging beneath the chassis or the type of hitch you use.
Learn how fast it goes up or down, learn how to ignore impatient drivers behind you while you wait to raise or lower the coach when needed, and to understand we all have climbed the learning curve.
-
If you need someone else to jump in on a group buy count me it. I wouldn’t mind having a few of those around. I bet others with the 8V on this site would take some also.
-
Rick,
Is it carboy43? I was looking for those at one time as well and reached out to him to make them. The problem was that the high temp ones had a 150 minimum order and the were about 3 bucks per. Fast decals was better but i never did order them. I looked high and low as well.
Glad to hear your rebuild is going well. Please post some pictures when you have a chance. Jeff
-
That’s the one. Rebuild is coming along nicely. I found a guy on ebay who said he could make some for me. Do you know where I can get some?
Rick
-
Luc send me a picture of the page with the signature in it. We will help you get it working. Never had this issue. Email me at Bill@PrevostCommuniy.com
Thanks
-
Great information!
Is it possible to inflate the air bags fully, (shifting the air lever out of drive mode) and drive the bus at a higher height?
-
Jon
MemberApril 12, 2022 at 11:09 pm in reply to: Air leak on push to connect, plus suspension leaksAndrew, on my bus when the key is off the air is trapped in the bags via the Norgren valves. Even if I drain my aux air to zero my bus will stay at Height.
-
Chuck I have a wall of those certificates, and they are signed by the wife saying I told you so.
-
Ha! You nailed it Dick. Worse than watching is someone standing in your mirror view spinning their finger in a circle trying to tell you which way to turn the steering wheel. 🙂
-
Luck, as far as the signature issue take that up with admin.
Regarding the continue use of push in fittings the simple answer is do not.
There is likely no single issue more annoying and more universal than air system leaks due to aging push in fittings and for an owner to continue to use or reuse them is just plain foolish.
FWIW, a long time Prevost policy is if the air bags hold air (keep the bus up) for at least three days they have succeeded in making a repair. Once they turn over a coach to you after a suspension system repair you can hold them to that standard. Do not expect more.
-
Jon-
Not sure why the bus info doesn’t come up in signature, it is listed in my profile under signature. 96 xl.
I aired the bus up yesterday at 7pm. This morning by 7am the front is already sinking, not bottomed out, but the mud flaps are touching the ground. I don’t notice much drop in the rear. I was under the impression with the key off the bags should hold air for quite awhile, as you all have confirmed. I will be headed back to Prevost. The day I picked it up, I pulled out of the shop floor and parked outside to have a look around. I noticed a loud hissing coming from the front end. I got the mechanic and he confirmed and had me pull it back into the shop. Turned out tobe a push in air line was loose. I don’t hear any loud leaks now, but obviously there is leakage.
Mike- Do you have a link about the “whisper” you purchased?
-
Luc, add your coach information to the signature line if you want answers relative to your coach.
The entire suspension system on some coaches can be perfect with no leaks, but if the suspension system has the reverse logic suspension control, a loss of pressure in the accessory system can cause the suspension system to drop.
It is highly unlikely a rear will stay at the height it was at when the key was turned off while the front left or right goes down. If the front leaks it will go down equally, side to side because the side to side movement is a function of the right or left rear air bags. If the rears remain up the bus will not lean.
-
I wonder if all H3’s have this access?