Jim/Chris
Forum Replies Created
-
Any way to tell if a coach may have a future delam problem while shopping used coaches?
-
I missed that button, too. Now I’ll have to find something else to grumble about. Any ideas?
-
Dan, I think I understand your question, but to be sure there is no chance for misinterpretation regarding my opinion on this, the short answer is yes I would always opt for the greater capacity.
This point I want to make very clear because it is a safety issue. On my coach I have 70 amp circuit breakers relating to the transfer switch. If I replaced my transfer switch with a 90, the loads the contactors could handle would be 90, but I am protected because the wiring was sized for 70 and there is circuit protection for 70.
Increasing the size rating of components is perfectly fine as long as the circuit protection and wiring are sized for their capacity, which may be less.
-
Jim/Chris
MemberFebruary 17, 2019 at 8:44 am in reply to: Carlisle Autofest – Lakeland, FL – February 22 – 2Hey Bill, can you please post directions to the camping area we are supposed to use?
We basically know how to get to the A&C as we were there several years ago but since the camping has changed – where do we go now?
See you Thursday, probably before lunch.
Thanks!
-
Jim/Chris
MemberFebruary 13, 2019 at 6:46 pm in reply to: Cancer Donation – Leon Snyder – Marathon CoachGreat guy most knowable on Marathon always had time to explain things he will be greatly missed
-
Tested both Vanner 60-60 units that are connected in parallel. Unit one has 12.8 on the 12V post and 25.5 on the 24V post. The second unit has 12.8V on 12V post and 25.6V on the 24V post.
Will check each battery next.
Ron
-
Yes I replaced that Burkett valve with Norgren, Found out the Norgren valve #K910026 has 4 ports It can be (NO normally open) or (NC normally closed) just by connecting ports differently. The same Norgren #K910026 is used inside frame above tag to do 2 different things 1 is NO & other is NC so that valve could be used in different applications.
-
Ron,
Diagram photo sent to your email.
-
I might not have even mentioned this, but the cat is out of the bag so here it goes.
When we left Prevost Houston Thursday we intended to drive about 300 hundred miles and park at the Bass Pro in Denham Springs, Louisiana.
What is that about the best-laid plans of mice and men?
Counting our test drive of 42 miles, we did drive exactly 300 miles in the bus today. However, we are only 70 miles from Prevost Houston where we began.
How in the world did that happen?
Let’s see, it goes something like this.
First the test drive of 42 miles. Then hook up the car and drive 110 miles. Then the bus quits again on the interstate and we coast into a truck stop wondering what in the world just happened. There were no alerts and we had no clue what the cause was. We cranked the bus but it quit. The third time it runs.
On advice from Jeff Rowe and the Detroit shop in Houston that did the engine work, we drove 92 miles west in rush hour traffic to their shop in Houston. Jason from Mid Coast was there, hooked up the computer and found no engine codes. Huh? Something happened.
He crawled underneath and around the engine checking every connection that had been messed with during the repair and several that had not been touched. The engine kept right on running as smooth as can be.
The bus had been running for nearly 8 hours when it shut down. It had been nearly 600 miles since I had taken on fuel. It did not act like a fuel issue at all. It seemed to be an electrical problem.
While Jason was sitting in the driver’s seat he was thinking out loud about possible ways the engine could lose electrical power and not trigger a code. He could only come up with one way, the ignition. He wiggled the key and messed with the wires behind the ignition, but the bus kept purring never missing a beat.
What to do now? Jason offered to let us park there for the night until we made a decision, but we were ready to go. We unhooked and got turned around and we headed east again. We negotiated our way through the dregs of rush hour traffic, found a rest area after 56 miles and stopped for the night.
Thursday we drove 7.5 hours, 300 total bus miles and a net gain of 70 miles. What a day!😇
Friday we drove 395 miles without one problem. As I write this I am sitting in a rest area in Alabama 60 miles from our destination.
I hope this bus saga has not been too long.
Davy
-
To help ease your pain, think $6,000.
-
Thanks guys. I will check for possible other breakers, switches, etc. I have talked a bit with Kyle @ Tradewinds as I am planning to attend that event. I of course would like to be fully functional before heading that way.
-
An 02 will be pre EGR as John pointed out.
-
Jim/Chris
MemberJanuary 24, 2019 at 1:34 pm in reply to: I may have entered into “Flip-Phone-Friday”?Well, I’ve just taken the egg off my face. I went to my bus today and guess what? With the house batteries on, as stated in my in my last post, the DC side of the bus in again non functioning.
I always said that I turned the house and coach batteries off as soon as I shut the engine off and I now know I was right. I’m now back to being clueless to my problem? I went to the office and told the manager the next time I take a run. I want to plug into phase 1 (I’m parked in phase 2 and the only one there) thinking it may have a problem of some kind.
Someone said it’s your 50 amp cord is bad. So I had them move the cord and it made no impact. Some have said the inverter and maybe that’s it. But I still believe it’s the power in phase 2. I would have checked that theory today but the weather wasn’t cooperating.
Harry
-
Jim/Chris
MemberJanuary 21, 2019 at 2:07 pm in reply to: “A funny thing happened on the way to the forum”.I don’t know about that, but not nearly as easy as wheel barrows which were invented for use in teaching FAA inspectors to walk upright.
-
- It’s a Series II FHC manual shift 2WD, and it’s dark blue, if that helps.