Forum Replies Created

Page 47 of 214
  • Dick

    Member
    May 5, 2020 at 6:42 pm in reply to: New Promotion from Prevost – Steering & Suspension

    Ordered 6 new rear shocks for rear this morning from Prevost part # 63061 for $47.73 x 6 =$286.38 not bad they are close so should get them in a couple of days, replaced front last year with Koni adjustables, I think I can replace them without pulling tires?

  • Dick

    Member
    April 30, 2020 at 12:13 pm in reply to: Dish TV in bus and home

    Follow-up/conclusion to our original question/situation:

    We duplicated Glen’s configuration and had the DISH service installed at home yesterday. It was established as a new account in order to get maximum deals and discounts (currently offering a $300 gift card). The in-home new Hopper 3 receiver has a large feature list and we’ll be busy a couple of days learning!

    After a week or so, we will add the Wally receiver in the bus onto our home account and leave it activated for $7 monthly (just like Glen).

    Thanks for the answers and info

  • Dick

    Member
    April 27, 2020 at 9:28 pm in reply to: Water Pump Replacement

    No ac power isn’t an issue for the pump. No dc is. That pump is dc. It’s the one that liberty puts a 30 amp resettable breaker on even though the pump can take 50. Mine is at the bottom of the middle row. You can check if you have dc voltage there. If you need to reset the breaker (it looks like a fuse) just unplug it and put it back. That resets the CBF breakers.

    The Groco is a magnificent pump – one of the best marine pumps there is (and price to boot) it can essentially be completely rebuilt for about $400 (psr master kit) . So I would keep it if you can

    You do need to be a little familiar with power or get someone professional to help. A voltmeter is first and foremost here.

    if it’s an impeller you would hear and see the pump run but have low flow. If you don’t even know if you have power – then you aren’t at diagnosing impeller yet.

  • Dick

    Member
    April 27, 2020 at 5:32 pm in reply to: Air Lines After Slide out Controller 2006 H3

    Jeff: The new air block/manifold stopped the slide air leaks … until the rear seal blew a few months later. Then I had two new seals and a new manifold and no slide air leaks. But of course more leaks came up elsewhere over the next couple of years and I fixed those myself. Sold it six months ago leak free.

  • Dick

    Member
    April 27, 2020 at 1:03 pm in reply to: Amana fridge

    Joel, your normal luck seems a lot like mine. If something breaks, I buy two. Not that I need them both, but the second one extends the life of the first by eons.

  • Dick

    Member
    April 25, 2020 at 11:57 pm in reply to: New Service Paramters

    Steve: I think that’s pretty heavy handed.

    ETLC permits us in the coach, in the shop, on the ground, up in the air, doesn’t matter. Jeff also lets us walk around the shop and watch the techs, ask questions. (Note that not every tech in the world appreciates someone looking over their shoulder and asking questions. I respect that, and respect them. I usually ask first.)

    Prevost Jacksonville had the same policy in 2015 and Prevost Houston in 2019.

    I did hear or read an unsubstantiated rumor that an owner might have walked out of a raised up coach while in the air at a Prevost shop. Unconfirmed.

    The shop in Kerrville TX that did the radiator fix wouldn’t let us on the shop floor even to walk to coach to get something, they escorted us. I couldn’t watch the tech work. We couldn’t stay overnight in the coach. I didn’t like that, but it’s their business and not mine, they were the only show in town. So I had to accept that.

  • Dick

    Member
    April 25, 2020 at 10:55 pm in reply to: New Service Paramters

    In the coach while lifted may be safe for occupants, but absolutely would not want to be that mechanic underneath. His safety is at risk if an occupant was to switch on aquahot, start or cause generator to start, accidently hit dump valve,etc.

    Prevost should never allow this, nor any other garage because we all know people !

  • Dick

    Member
    April 25, 2020 at 8:45 pm in reply to: Steps to Replace Allen Bradley Board Battery?

    There are several series of the SLC 5/500 PLC. The earlier one have the battery behind the door. The newer series require that the board to be pulled out of the tray to replace it. It’s snapped in place on the circuit board. A capacitor should hold the program for several minute while you change the battery. Just be aware that if the program is lost, it will require a PLC tech with the Allen Bradley software and a copy of the program to access the PLC to reload it. The converter should have a file that can be emailed to you. The safe way to do it is have the tech plug in and copy the program and then change the battery. This is only required if you have the internal battery. The power to the PLC has to be turned off before you pull the board. I only know about this from my work place. We have several machines that used the older PLC’s.

    There are youtube videos about this.

  • Dick

    Member
    April 23, 2020 at 2:14 pm in reply to: Coach prices

    Jerry,

    POG doesn’t sell coaches, Prevost-Stuff is the sales entity.

    The same Marathon is here on PC and there is no comparison between a Newell and Marathon.

    MARATHON PREVOST H3-45 QUAD SLIDE #1187

  • Dick

    Member
    April 23, 2020 at 1:23 pm in reply to: covid 19 update

    This is a web site focussed on buses, and Prevost in particular. Dr. Yetter is an expert and his posts are helpful informative and valid because they are based on facts.

    But there is a reason we don’t do politics, taboo topics like abortion or guns because they are divisive. The virus is now in that category because expressing an opinion on Cruisairs or roof airs is not going to divide our membership like the taboo topics are.

    There are all kinds of places on the internet for folks to advocate for what they believe regarding the virus, but unless you are a physician or a health care official it is not going to be here. Anything we want to know about this topic is available elsewhere.

  • Dick

    Member
    April 23, 2020 at 11:32 am in reply to: Stop leak in OTR?

    Don, after reading other posts about pressure overload, Think I need them as mine has dumped freon on 2 separate times in the last couple years. Cheapest thing to try. Pull and install new ones, vacuum system and install R134.

  • Dick

    Member
    April 23, 2020 at 8:51 am in reply to: Stop leak in OTR?

    Where do you guys buy your pressure switches for the Carrier O5G’s, low and high side. Prevost, Welch or elsewhere.

  • Dick

    Member
    April 20, 2020 at 8:58 pm in reply to: covid 19 update

    The problem I see with your response is that the majority of our US citizens have lost all sense of common sense!

    It’s now all about ME and to hell with the rest of you folks. Just look at the beaches that remained open and are now being re-opened. Look at the protesters mobbing city halls who were all bunched up just inches apart. You simply can’t fix stupid and when the Government re-opens the Country there is going to be a huge swell of infection and lots and lots of folks are going to die. Maybe that’s the Big Guys plan but I am not ready to meet my maker and will do everything in my power to keep myself “socially isolated” for as long as possible.

  • Dick

    Member
    April 20, 2020 at 8:53 pm in reply to: covid 19 update

    Doctor Yetter,

    I was just reading your message which is good info, then I came to this…..

    BTW we all do appreciate Jon’s isolation from the rest of us! LOL

    Never expected that nor seen it coming….LOL Good one DR.

    AL

  • Dick

    Member
    April 20, 2020 at 3:13 pm in reply to: Trouble at FMCA

    Jerry:

    Thanks for the thorough background on FMCA and its structure.

    FMCA is structured very similar to the three motorsports organizations I’m an officer of. No employees, put on events, sell a few sponsorships, etc.

    Structuring events to “break-even” is financial suicide for any organization unless it has deep pockets, a well healed affiliate, or very understanding sponsors.

    In two of the three organizations I’ve involved in we have some vocal and influential members who thing profit is evil. (Yes, they are car people.) I’ve been involved in those two for fifteen years. Its taken a while, but more rational heads have prevailed and we have slowly gotten the “break-even” crowd to understand that having financial reserves to be good … especially during the 2008 to 2011 downturn in amateur motorsports and when we have terrible weather, have to pay massive track rental and only a handful of entrants show up.

Page 47 of 214