Dick
Forum Replies Created
-
There are multiple reasons to cage a brake. Peter cites one example where it is necessary. Another reason might be because the air pressure used to retract the parking brake spring is leaking due to a failed diaphragm or seal. Whatever the reason just knowing that is an option is something to keep in mind. I am sure some coach owners have been convinced they needed an expensive tow because they were not aware caging was an option.
Caging a brake means instead of relying on air pressure to push back the spring that applies the parking brake, it is being done mechanically with an internal screw, or a “T” bolt that is stored on the brake chamber
The only concern everyone needs to be aware of is that caging a brake requires someone to get under the coach. That’s not a big deal, especially since access can be made easier by using the level low to raise the coach. But as we have said often, getting under the coach without chassis supports is dangerous. Once you are in between the wheels under the coach there is room to sit up and work and as long as you avoid pinch points it is probably not very dangerous. Just understand that getting to the open area between the wheels is where there is a risk. A secondary risk is that on brake chambers with the external T bolt the bolt head must be properly seated because if the bolt should slip the spring that is being retracted could release suddenly, and while it is unlikely to cause harm, you will need to change your shorts.
If a binding brake is the cause, the brake does need to be caged so the caliper orslack adjuster can be readjusted to release the brake that is binding.
Anytime a brake is caged you have lost one of the parking brakes, and if the service brake is the problem and it has to be taken out of service by plugging the air line you will have lost one of the service brakes so be aware you may be driving with a compromised brake syste, At that point your driving should be limited to going to a service facility.
-
I used to do my own and then decided to let Jeff do it. There’s more to it than just adding freon and Jeff really understands what’s needed. He’s never just added freon to mine, it’s always been vacuumed, nitrogen tested, new dryer then recharged. I will still do my cars, but not the bus.
I watched a service truck guy at Sevierville attempt to just add freon to an H with dash air and the guy with the bus left with no air as opposed to having just some air when he got there.
-
Ouch, those compressors are cheap, you paid dearly for that one. I get them at Fleet Pride for less than 300 bucks.
Just one other thought. Some have like a 3 minute delay circuit board that keeps the compressor for coming on immediately on start up. I had a problem with one of those, don’t remember which bus, and it failed not allowing the compressor to start. I don’t think my Marathon has that, seems to come on as soon as the button is pushed.
Is the little button lighting up when you push for the compressor at the control?
-
Tom,
Oops, my mistake. I misread. Your 26 1/2″ CC length is correct.
-
Good job on finding a Vantare of that vintage with roof airs!
You will love the OTR air!
-
Mark: Generators … plural? Do you mean inverters? Glad to hear that things are working better. Enjoy the rest of the trip. If you have any further problems, post the problem. We’re all here to help.
-
Has everyone noticed Tom is incredibly silent on how much dues we are collecting? He doesn’t want anyone to know that when he doubled the dues last year it enabled him to build a new house?
Just sayin……….
-
Do you have a voltmeter that you can get accurate readings with? Be sure when changing fuses and pulling fuses that you use the same rated fuse. When the gen is running you have a-c voltage present from the gen, however I would guess the time delay is dropping in and out…If the gen was not producing any voltage the gen would overheat as the cooling fan is 120v and powered directly off of the gen….
-
So just sitting here on shore, my batts show 13.2 / 26.2. I believe I’ve seen them go up to 28.3, depending on the situation.
What’s the “fully charged” voltage the batts would have to fall below before you have to purchase new batts?
-
Most coaches have some mechanical means of preventing doors and drawers from opening under different driving conditions. Our previous coach had a shower door latch like what Tom described. If the folks at Hoffman cannot assist you there are a number of hardware manufacturers that make catches of all sorts, and in the event you run out of luck finding a solution a little Velcro and your imagination might help solve the problem.
-
I will try to answer all of your questions above and see what you think.
We brought the coach into South Lake Tahoe on Monday at around 1 pm and checked into a hotel here to give everyone a day or so break. Because there was no hook up in the parking lot I kept the generator running to keep the bus cool (we bought several cases of wine in Napa that I didn’t wan to ruin). Essentially we were dry docked with minimal powe requirement on the generator of one AC running and the fridge. After one night everything was normal but returning the next morning the generator WAS STILL RUNNING but off line. The “clicking” noise was present and the bus will not accept 24 or 12 V power to the systems (internals only). The generator would not shut down unless holding the reset button on the bottom of the watchdog was engaged. At this point the only thing working is the Prevost only systems.
One thing to note is that replacing the fuse on fuse number 48 (which is the fuse that i pulled to stop the clicking on and off of the circuitry) DID fix the problem momentarily. We started the generator BACK up and turned some lights on and everything seemed normal. We left for dinner and returned to the coach and found the same situatin (Generator on – offline, cant shut down, no controls). After putting several different small fuses into number 48 there was no change. I then shut the generator down overnight using the watchdog reset and turned absolutely everything off including the coach 24 and 12 V battery switches in hopes that if there WAS a drain having everything off line would help. Spent the night in hotel again and going to try again early this morning.
House batteries are all new as of 2 1/2 yeara ago.
Any help is appreciated. Don’t know if running the engine today will charge the house batteries and will help but its the first thing I am going to try. It DOES act like a circuit not getting enough juice to close but what would that have to do with the fuse? Also it is NOT blowing the fuse! I am just changing it. Could the fuse holder have a short?
Mark and Lorenda Wyant
-
Dan,
After having worked for almost 20 years for a tire service company, I am sorry to say that the wear pattern
will not correct itself by rotation of the tire. Once the irregular wear starts correcting the alignment and or
rotation of the tire will not correct the wear pattern. If your irregular wear pattern was caused by over or
under inflation, you could try to correct the wear by over or under inflating, but I would not recommend it.
-
You don’t have to do anything except use the above numbers if and when you need the service.
-
I also used the PC Michelin Tire program when I bought tires. But on the Michelin On Call Road Service, can I just use the numbers above or do I have do register with Dupree?
Tom, you mention “I’m sure it’s not cheap, but sure they will make it all happen.” Is this a separate road service program that has an annual charge?
Is the Michelin roadside service another program similar to Coach.net which I already have? And if it is a tire issue, is there an advantage to calling Michelin over Coach.net?
-
You will get a check engine light Tim.