Forum Replies Created

Page 91 of 2304
  • Archived

    Member
    January 1, 2021 at 6:39 pm in reply to: Suspension Squeak and engine compressor question

    Bill:

    Had the same issue in colder weather when I first got our coach. When I had the front end rebuilt it stopped. I believe it was the old hard rubber in the front sway bar

    Chuck

  • Archived

    Member
    January 1, 2021 at 12:07 pm in reply to: Vibration-Am I missing something?

    I have found Road conditions play a Hugh part in vibration . So have you been on any road surface and experienced No Vibration ? If not then a visit to Prevost is needed . After all they made the coach 🙂 Happy New year Guys , may your repair cost be lower than mine lol as i sit and await the Genny motor rebuild 🙁

    My saying is Smooth Road Smooth Ride

    Rough Road Rough Ride

  • Archived

    Member
    January 1, 2021 at 2:30 am in reply to: Vibration-Am I missing something?

    Jacking the engine & trans seams a bit scary, that’s a lot of weight concentrated on the pot metal cast oil pan. How much do I need to lift/jack the engine/trans to determine bad mounts?

    I understand your concern with weight. You might try loading the bus weight by blocking your wheels, step on brake hard, engage transmission, increase throttle. Watch the engine for lifting or movement due to a failed mount. Drive and Reverse will load torque to observe failed mounts.

    AL

  • Archived

    Member
    December 31, 2020 at 5:28 pm in reply to: Vibration-Am I missing something?

    Chuck,

    Both my Marathon H’s had that slight vibration depending on speed, I could never get it corrected. FWIW, none of my other buses with 315’s had vibration issues.

  • Archived

    Member
    December 31, 2020 at 4:15 pm in reply to: The Good Ole Days

    Question for the fans….

    Name the last thing the driver does before driving the bus. ?

  • Archived

    Member
    December 31, 2020 at 10:38 am in reply to: Vibration-Am I missing something?

    Could be harmonics due to tired/old/malformed motor mounts. We had an issue with our first bus, a 1999 shell called 2001 Country Coach 2 slide. Prevost Dallas added some washer or such to bumper side motor mounts after we replaced tires, wheels ( especially inner steels are rarely true) But an H normally has 9 inch wide alloys on inner duals

  • Archived

    Member
    December 31, 2020 at 7:38 am in reply to: Bus leaning to the left

    when we bought our Liberty, I had Prevost replace all the Norgrens and switch to compression fittings. We, also, had the leans.

  • Archived

    Member
    December 30, 2020 at 5:38 pm in reply to: OYSTERFEST AND A SEMINAR

    Jon or Truc, Is Snotball Fest confirmed for April? should we make reservations? Happy New Year guys! Geo.

  • Archived

    Member
    December 30, 2020 at 2:18 pm in reply to: The Good Ole Days

    Have thought about moving up to an Augusta once or twice but the L is simple and reliable

  • Archived

    Member
    December 30, 2020 at 11:41 am in reply to: A Thrill

    Thanks for sharing.

    We drive up and down Hwy 5 all the time from S.F. to Las Vegas. I never knew there was a race trace there. I don’t recall ever seeing any signs.

  • Archived

    Member
    December 29, 2020 at 11:01 pm in reply to: Does the Converter matter with a 20 year old bus?

    We dont think it matters. We used to own a Beaver XL40 from 2009-2015. For Country Coach, you can get work and advice from oregon Motorcoach or Premier RV Services

    for Royale, theres Dan Jourdan of Royale Phoenix. He has build info about all Royales except three

    Angolas and American Coach i believe Panterra Coach has much experience with these converters

    There are sources

  • Archived

    Member
    December 29, 2020 at 6:32 pm in reply to: Bus leaning to the left

    Jerry, it sounds like you did all the right things. However while the 3 port valves you replaced could have been the problems it is also possible the 5 port Norgren on the bulkhead forward of the drive axle could be an issue.

    If you can see it spray it liberally with soapy water. Sometimes they can wear and air can leak past the internal spool and out the end caps.

    If that does not show a leak see if you are getting air leaking from the three port valve in the steer compartment that is mounted on the rear wall near the solenoid valve stack. It is used to exhaust air when you lower the coach and if it is not a lot of trouble put a pipe plug in the exhaust port.

    Finally in front of the fender liner is the ride height valve. See if that is leaking.

    As a practical matter since your service was prompted by the leans, Prevost should not have let the coach out of the shop before verifying there were no leaks. If it turns out something they replaced has a leaky fitting or a leak the cost of repair is on Prevost.

  • Archived

    Member
    December 29, 2020 at 4:09 pm in reply to: Nashville RV bombing

    Food for thought. Times are a changing !

  • Archived

    Member
    December 28, 2020 at 2:40 pm in reply to: Possible Head Gasket issue

    there is a point we need to trust in the pro that deal with it each day.. All I can say it is not acting correct. Might be cheaper to replace than rebuild. Only you can do math on that. A new/rebuilt engine ?will it be generator part go sooner? Please do let us know the outcome of your breakdown..best wishes.. Bob

  • Archived

    Member
    December 27, 2020 at 12:49 pm in reply to: The Good Ole Days

    Unless you are a rocket, blimp, a hot air balloon or a falling object, lift is typically provided by a wing that is moving.

    Even bullets start to fall immediately upon leaving the gun barrel because they have movement, but no wings. You gotta have both.

Page 91 of 2304