Forum Replies Created

Page 43 of 2304
  • Archived

    Member
    October 23, 2021 at 10:27 pm in reply to: What does it indicate

    the smaller tag on yellow wire will tell us more. also number tatooed on yellow wire will tell us what it does.. the black wire is a ground.. yellow = 12V system… red is 24 volt. The whole wiring manual is a download from prevostcar.com…select tech manual.. the number on yellow wire will tell it what it is for. the tag(smaller) will give you the connector number. It will become clear once you get the codes(wire or connector numbers) Also realize that there are several unused circuits. some are extra some are just plain ones for something you don’t have.. give me the number tatooed on yellow wire. I enlarged it but was turned to far. I’ll ck book tomorrow. Bob

  • Archived

    Member
    October 23, 2021 at 4:10 pm in reply to: Blind guide

    Ralf is it a blind hold spool tensioner if so Amazon has then 6 bucks for 4 pieces.

  • Archived

    Member
    October 23, 2021 at 3:18 pm in reply to: 8V92TA blower bolt – can I remove one?

    I found a video from Scott (Bus Grease Monkey) that showed the install of the blower. It looked like I should be okay, so I went ahead and removed the bolt behind the turbo. It then became apparent that the forward bracket wasn’t even attached, so it all came loose with that one bolt. Now I just have to make a new hose and squeeze into a small space again to reinstall.

  • Archived

    Member
    October 23, 2021 at 12:56 pm in reply to: ROAD AIR, NO REAR BLOWER

    Thanks, folks. It actually turned out to be the R38 relay.

  • Archived

    Member
    October 23, 2021 at 10:47 am in reply to: Blind guide

    If you can’t find it, might have to get a couple 3D printed or machined. Fairly simple part.

  • Archived

    Member
    October 23, 2021 at 10:38 am in reply to: what did you do to your Bus Today

    Cleaned and rebuilt the Racor. It was disgusting

    Changed all 8v fuel filters

    Changed generator oil

    Changed all fuel filters on the generator

    Started everything up and let run for a little bit to make sure everything was good to go.

    Jessica, Tanner and I will be doing a lot of traveling in FL the next few months:)

  • Archived

    Member
    October 23, 2021 at 10:16 am in reply to: Aux Air Compressor Cycling Every 2.5 hours

    Larry! The Aux system does all the air to everything except the brakes, So driving down the road the level system gives you ride height, level low when parked to level, belt tenisioner’s on Detroit, generator air bags, foot well slide, pocket doors, toilet if you have air toilet, sewer dump valves and any other air things. When we park we don’t need any air,We Changed toilet right away no air pocket doors, Generator air bags are by their self 2 schrader valves I add air once a year, Bus stays level.Detroit belt air bags stay full for months, So when I fire it up belts are always tight, Their is a check valve up there above valve with red knob, I got rid of the red knob valve because it leaked and I put 1 1/4 inch ball valve in line, If I need to change a belt I turn the ball off push schrader valve belts are loose, turn ball valve on belts are tight. That red knob valve was $250 bucks I couldn’t talk myself into that, I made it simple. My compressor Never gets turned on. Larry when you drive watch your aux gauge probably slowly drops to 100 psi then governor kicks in and gauge rises to 120 psi if it’s slow no big deal, Mine at 1st was every couple of minutes, now it stays put I got rid of most of the bad leaks.

  • Archived

    Member
    October 23, 2021 at 9:17 am in reply to: Allison Transynd is the Way to Go!
    Synthetic atf was not installed from the factory in 1998.
    Send a sample to JG Lubricant Services for analysis and they will tell you all you need to know about your atf. The owner created the TES295 spec.
  • Archived

    Member
    October 23, 2021 at 8:44 am in reply to: Aux Air Compressor Cycling Every 2.5 hours

    Your 2.5 hrs is not unusual, you do have leaks in the aux system. To charge the engine belts with air before starting, you turn the yellow valve in the steering compartment to merge your accessory air with the Prevost chassis air. Keep in mind your aux compressor makes a lot of water, so be sure to drain off water often from the aux tank before introducing aux air to the Prevost side. Close the valve after charging the belts.

  • Archived

    Member
    October 23, 2021 at 8:38 am in reply to: Aux Air Compressor Cycling Every 2.5 hours

    In my CC I have an on/off button for the air Aux compressor. I have found in my bus as i have fixed leaks currently there is no reason i need the aux compressor to run. When i first got my Bus, i needed the aux air at 100 psi to keep the bus level which was a challenge because i had suspension leaks ans aux air leaks. Once I replaced all my air components my bus will sit level for weeks, with my aux air dropping about 10 psi per 24 hour period. I don’t have air pocket doors, or a belt tensioner. Since you are mentioning your belt tensioner is at 0 psi, maybe that is the leak path? There should be a check valve trapping air in your belt tensioner, and an actuation valve in the driver bay to release tension to change the belt. My guess is they put the regulator between that circuit and the aux air tank? On my bus it was harder for me to chase down all my aux air leaks than it was all the other air components like brakes, bags, valves, fittings etc. Maybe someone with your model year has other input.

  • Archived

    Member
    October 23, 2021 at 1:40 am in reply to: Allison Transynd is the Way to Go!

    So what year did they switch to the synthetic fluid ? Having the fluid change out is on my to do list. Mine is 1998 chassis.

  • Archived

    Member
    October 22, 2021 at 4:24 pm in reply to: Replacing Trace inverter

    I have done a lot of research over the past week regarding inverters, I also spoke with Annete Hedblom, Sales rep for Magnum. They do have an issue with meeting the current deliveries, but are working as hard as they can. Chip shortages are also an issue adding to their struggles. She mentioned new orders might be out as far as the end of Q1 2022. This prompted me to look around, and i think the Victor is a good option for me to rethink my Battery and solar management.

  • Archived

    Member
    October 21, 2021 at 7:03 pm in reply to: Allison Transynd is the Way to Go!

    So here is an interesting story to follow up my trans fluid change report.

    in line at a dump station and I put it into gear and nothing! I look and the dreaded fault light is blinking on the pad. I kill the engine and try again. Nothing. I get that sinking feeling you get when your wallet is seriously lightened and your afternoon is looking like it will extend for days.

    Looking behind the bus I see a lake of fluid. And quickly realize it is am of my nice new Transynd flowing across the pavement. We were towing our truck so we used it to pull the bus back so I could climb under and not have to swim under. I get in there and I see that everything is intact but I feel at the top of the filter and the sealing ring has popped out and allowed the fluid to simply pump out at great speed.

    I just happened to have a filter strap wrench and 2 gallons of cheap Walmart fluid in the bay. I reseat the trans filter with prong in correct position and add 2 gallons. Doesn’t even register on the do-stick. I go to Walmart and get 4 more gallons to add and I am touching cold-low on the dipstick. The bus is now moving and everything seems fine.

    I suppose having a few basic tools helped me out here.

    i am happy to report W.W. Williams in Savannah is standing behind their work and paying Smith Power locally to redo the job and flush in Transynd. The guys at W.W. Williams in Savannah are top notch. Tragedy narrowly averted. Kinda scary to think of what a mess this could have been if I were not at a rest stop dump station.

    Elliot

  • Archived

    Member
    October 20, 2021 at 10:09 am in reply to: Liberty – odd alternator config
    Clint & Tammy – If that Liberty doesn’t have roof airs? don’t walk, RUN away from that deal.
    A couple of yrs ago I saw a non-OTR riveted Liberty being advertised here on PC by a Dallas dealer. I thought to myself “I pity the fool” that doesn’t know better than to buy a Prevost with CruiseAirs and no OTR ac.
  • Archived

    Member
    October 19, 2021 at 3:13 pm in reply to: Liberty – odd alternator config

    It’s at Olympia, not a roof-air coach and marketed as a rare and simple Liberty. Same floor plan as your old 97.

    I understand the non-OTR perspective and the Cruise Air concerns.

Page 43 of 2304