Forum Replies Created

Page 39 of 2304
  • Archived

    Member
    December 6, 2021 at 4:21 pm in reply to: Clean sheet design: inverters, batteries, etc.

    Hello, Chad. Have you looked at Dakota batteries?

    Ron

  • Archived

    Member
    December 5, 2021 at 10:24 am in reply to: Headlight adjustment?

    Art:

    Been playing with mine for awhile. Tried the various methods found on internet post and Youtube. None seamed to work well. Ended up parking on a flat dark back street at night and adjusting the beams up & down and in and out until they looked right. The looked right part came from watching other cars, trucks, buses going down the road at night while I was driving.

    From my observation, Beginning of drivers beam should be about 12-15 ft in front of you and just to the inside of the line that divides the lanes on the drivers side. Beginning of passengers beam should be the same 12-15 ft in front of your and on the line that marks the outside of the lane on the passengers side.

    This is not scientific or proven in anyway. Just seams to match what I see in most of the big rigs going down the road and gives me good visibility without bothering other drivers.

  • Archived

    Member
    December 5, 2021 at 7:57 am in reply to: Recent experience with Ft Worth Prevost Service ?

    Thanks for the suggestions. I know that my converter compressor is OK as I can shut the output air and it will hold 130# forever. I am a full timer so have no access to the underside of the coach safely. I have to depend upon someone who can put it on a lift to check the tanks and valves. I think i have tested the step slide (it has shut offs in line) but I will double check. Nothing else other than the door air lock uses air when parked.

  • Archived

    Member
    December 4, 2021 at 5:35 pm in reply to: what did you do to your Bus Today

    I pulled this rusted oil reservoir out.

  • Archived

    Member
    December 4, 2021 at 5:05 pm in reply to: Windshield remove/replace

    Yes.

  • Archived

    Member
    December 4, 2021 at 4:56 pm in reply to: Windshield remove/replace

    Did you pull out the lock strip?

  • Archived

    Member
    December 1, 2021 at 10:18 pm in reply to: Recent experience with Ft Worth Prevost Service ?

    When we bought our 1999 XL45 in May of 2014, I thought I had excessive play in steering wheel. 72,000 miles. Mentioned this to the late Peter Campbell while ETLC in December of 2014. He said I needed a 3 axle alignment. Had that done at Prevost Jacksonville the next month. The tech picked the Coach up with a frame lift from underneath, not wheel lifts. Walked me to front tires and showed I had excessive play in the tie rods. Replaced those.

    Then did alignment. Drive axle was WAY off. It drove like a different coach all together.

  • Archived

    Member
    November 24, 2021 at 2:40 pm in reply to: OTR oil leak

    Our OTR systems have protection against low or high pressure for the same reason which is to protect the system.

  • Archived

    Member
    November 24, 2021 at 10:23 am in reply to: Desert Shores Motorcoach Resort, Indio, CA

    Sounds wonderful! Happy Thanksgiving, Greg

  • Archived

    Member
    November 23, 2021 at 10:58 am in reply to: OTR oil leak

    Chuck, Are you sure that is the area of the leak? You have either cleaned the area with degreaser or if it is the leak source it is miniscule.

    Generally speaking A/C system leaks such as behind the compressor clutch are identified by black grease at the leak. I have never seen a clean leak location.

  • Archived

    Member
    November 22, 2021 at 8:02 pm in reply to: Vent Hose?

    Jon:

    Usually end up with a single drop or two on the garage floor after parking it. Not a big issue, but a nuisance.

    Chuck

  • Archived

    Member
    November 22, 2021 at 4:50 pm in reply to: what did you do to your Bus Today

    Nice neat looking job Mike, did you go to LI or still AGM?

  • Archived

    Member
    November 22, 2021 at 3:45 pm in reply to: 24 volt master light on 1999 Liberty

    i’m thinking this my just be a loose wire to the dash

  • Archived

    Member
    November 22, 2021 at 3:11 pm in reply to: So that’s where I left it

    In order for that turbo to spin as hard and fast to do that kind of damage it sure is a good way to demonstrate just how much force our engine exhaust can supply.

    I’m guessing however the person responsible might not want to demonstrate that again.

  • Archived

    Member
    November 22, 2021 at 11:07 am in reply to: Need Rv drivers for phoenix Arizonia and nj

    In other words if it is registered and licensed in TX, a Class B CDL is required. It is is registered in TN only a regular driver license is required.

    This statement is not true.

    If you are legal in the state where your driver’s license is issued you are good to drive anything your license allows in your state, regardless of where it is registered.

    The CDL requirement is a sticky issue, it may or may not require a CDL, depending on the job description. If the vehicle is paid for movement, ie commercial trucking, a CDL is required. If driving is a part of your job, not the only thing you do a CDL may not be required. Example, you are your employers assistant and one of your many duties is driving, a CDL is not required. It is not cut and dried.

Page 39 of 2304