Forum Replies Created

Page 104 of 2304
  • Archived

    Member
    November 10, 2020 at 11:36 am in reply to: Tracking sat system

    Satellite TV is a dying industry. You might end up purchasing a boat anchor. Everybody is going streaming via internet. Musk’s Starlink will be able to provide broadband even in the boonies.

    If you really need satellite TV, tracking dishes are necessarily smaller and have a worse signal to noise ratio than stationary dishes. Do you really need TV going down the road?

    Upgrading your existing TV to broadband is easy. Install an Amazon Firestick (or equivalent) HDMI dongle and connect it to your phone’s WIFI hotspot. Done.

    My 2c.

  • Archived

    Member
    November 10, 2020 at 11:19 am in reply to: OYSTERFEST AND A SEMINAR

    If Gods willing and the creek don’t rise I’m in.

  • Archived

    Member
    November 9, 2020 at 7:20 pm in reply to: 02 Zip Dee main awning

    We had Jeff install the NX mod to our manual Zip Dee patio awning this summer. It has made a world of difference and made it much easier to deploy and store the awning. We didn’t use the patio awning much in the past because it was such a pain to put out & then put back up, especially if alone & in high or gusting wind. The NX is the way it should have been designed from the get go, IMO.

    http://www.awningsbyzipdee.com/nx-hardware-upgrade-kit.html

  • Archived

    Member
    November 9, 2020 at 7:08 pm in reply to: The Good Ole Days
  • Archived

    Member
    November 9, 2020 at 6:41 pm in reply to: Tricks for getting alternator belt off/on

    I will not suggest the belt tensioning device doesn’t require a few pounds of effort, but with a reasonable length breaker bar (I have used both 18″ and 24″) it is not difficult to swing the belt tensioner through the arc needed to release belt tension and remove the belt.

    It is important the breaker bar is oriented when put in place to it sits perhaps a little above horizontal so a downward force to a position just below horizontal allows easy belt removal.

  • Archived

    Member
    November 9, 2020 at 6:11 pm in reply to: Time to sell the bus !!

    Jimbo, you are right. Diane and Larry have been a part of the PC family and we have shared great times with them.

    Let’s start new threads for unrelated topics please.

  • Archived

    Member
    November 9, 2020 at 12:00 pm in reply to: Time to sell the bus !!

    Ernie,

    8’x13′ of flooring. Just the living area.

  • Archived

    Member
    November 8, 2020 at 4:27 pm in reply to: The Good Ole Days

    Guess I’m one of the older members of the group. I went through Navy flight training in 1950. flew the F4U Corsair in my first squadron then transitioned to the F9F and got 26 missions in the Korean war. Helicopter training and flew Hueys in the Veitnam war. Retired from the military in 1961 and stared the first Helicopter Ambulance service in Florida. Ended up with 8,000hrs helo and 9,000hrs fixed wing. Received my Master Airman award in 2014.

  • Archived

    Member
    November 8, 2020 at 8:48 am in reply to: Tricks for getting alternator belt off/on

    Try wrapping the alt pulley first and go over idler(s) last.

  • Archived

    Member
    November 7, 2020 at 11:42 pm in reply to: Webasto nozzle

    Got that infernal cover off the pump, turns out there are no connectors under there, they are in the wires clipped to the chassis above it. It did let me turn the pump shaft by hand, moved freely. Unplugged the two spade connector in the 12 v feed to the pump and connected to a 12 v battery charger, pump runs fine draws about 18 amps, nameplate says 20 amps.

    Managed to find a Webasto service manual part number 699.745 dated 1/2004 on the web and downloaded it. It shows pin outs for the control module and wiring diagrams for the pump and heater. However of the two versions shown before and after 1993, neither matches up to the way my unit is wired, which looks factory (Liberty) by the neatness wire ties, and circuit number labels on some of the wires.

    My unit has one (looks black) wire in the A plug, it is a ground wire. The relay shown in the photo is the same as many in the 2nd bay power panel so I swapped out one of the “non essential ones” Still no water pump operation. Testing with the relay out of the socket, I check for 12v to the red wire on the relay, the “feed” wire (“30” terminal) and it has 12.8 v with the control module B plug unplugged. However, when I plug the B plug into the module the voltage at the red wire drops to about 12. Hmmmm. I try jumpering 12V from the #4 terminal of the B plug (the main 12Vfeed wire for the Webasto) to the red wire on the relay socket. Put the relay back in the socket. Water pump operates as it is supposed to. Off when unit turned off, on when unit running.

    I followed the red wire that has the wavering voltage and it disappears up into the underside of the floor through a hole with a bunch of other wires. Running up probably to some chase leading to bay2 maybe? Not sure how plugging in the B connector at the module changes the voltage at a 12v feed wire that comes from ???. That would only make sense if the “12V” on the wire somehow was routed through the module.

    Any suggestions? Sound like a bad control module? For this upcoming trip, if I need the Webasto (hope not, I’m going to Phoenix!), I made up a little plug in jumper from B4 terminal to the relay 30 terminal and I’ll just run it that way temporarily.

  • Archived

    Member
    November 7, 2020 at 11:17 am in reply to: Remote Generator shut down

    Thanks, yes my controller crashed and wouldn’t allow the generator to keep running. I got the new controller directly from Kohler, no problems with it running now, just the remote off switch from inside the coach. It’s not a big issue as I have options and thought it would be nice if it was something simple to resolve. I’m in Canada, so it might be a bit before we can stop in at Coburg to have it looked at.

  • Archived

    Member
    November 6, 2020 at 2:24 pm in reply to: WHAT ARE YOU WAITING FOR??????????

    As much as I want an opportunity to get the insurance mess straightened out, after my last experience I am not optimistic.

    It might be different for sticks and staples owners who are willing to accept ACV, but when we expect insurance suitable for a bus conversion and then want agreed value we are out of luck. There are so few who will write a policy at the level of the value of our coaches there is virtually no competition and we get what we get.

  • Archived

    Member
    November 5, 2020 at 7:15 pm in reply to: New used bus

    I would have to say that we were treated to ALL of the available ETLC amenities! It’s best left right there!

  • Archived

    Member
    November 5, 2020 at 4:43 pm in reply to: New used bus

    Great looking coach Bill. Wondering if you got the use of the ETLC Pontoon boat that included the VIP lunch and beverage package, all compliments of Jeff? Back in the day, the campground host, Buddy, would bring fresh doughnuts and coffee to potential coach buyers, but he’s now back in LA sucking head and eating tail.

    I’ve heard others have been offered the ETLC Houseboat for a week on the lake, but I think you have to spent a certain amount in purchasing a coach.

    The picture below is just a sample of ETLC service and Buddy delivering a new seat to a VIP customer.

    Hope you enjoy your CC…

  • Archived

    Member
    November 5, 2020 at 3:09 pm in reply to: New used bus

    beautiful. the flooring is exactly how i would like to change mine.

    R

Page 104 of 2304