Forum Replies Created

Page 6 of 83
  • Tim

    Member
    March 3, 2018 at 5:29 pm in reply to: AUX Air pressure

    And thanks to BA, I have one of those … gen air bags set at 25 psi (Marathon Aux).

    Mini-Airbags for belts in engine compartment set to 50 psi (Prevost Aux)

    My Air Slide is set to “0” … we never use it. (Prevost Aux)

    My toilet is 12v, not air.

  • Tim

    Member
    March 3, 2018 at 5:15 pm in reply to: AUX Air pressure

    Along with suggested gen mini air bags pressure is a Pressure Relieving SMC regulator. Pressure relieving allows the increase heat in generator bay to self adjust keeping pressure at your setting. Marathon is 25 PSI.

    Don’t have the “new” SMC part number which I understand was replaced recently.

    Here is the previous correct heat relieving number;

    SMC AR-20 NO1H-Z

    AL

  • Tim

    Member
    March 3, 2018 at 3:15 pm in reply to: POS Zip Dee Evolution awning

    TEXAS 40, Pat is removing the parts needed and saving the awning and hardware for me to pick up. Thanks for sharing these parts for Pat and myself. Darrell

  • Tim

    Member
    March 3, 2018 at 11:36 am in reply to: POS Zip Dee Evolution awning

    Thanks George. Kenneth said he still had it and I was welcome to come by and grab it. I sure appreciate it.

    I had a guy out here in AZ where we are staying suggest that I take my motor apart and do the brushes basically rebuilding it. He said unless it has turned into a ball of rust it would be worth salvaging. I will have to see when I get it apart.

    To all, I will hang on to the rest of the awning and if anyone sees this post I will be more than happy to help anyone else with a part(s) they may need from George’s old awning.

    Thanks again.

  • Tim

    Member
    March 2, 2018 at 8:52 pm in reply to: Progressive Surge Protecter – Warranty – Crap

    In my specific situation, I paid for a replacement plug and it was highly recommended I replace the power cord. I took their advice.

  • Tim

    Member
    March 2, 2018 at 4:52 am in reply to: OTR Central A/C -heat issue

    Thank you Boateral and Prevost Service. Those are great suggestions and we’ll explore them immediately!

  • Tim

    Member
    February 27, 2018 at 4:10 pm in reply to: WEBASTO CIRCULATION PUMP

    Pres,

    I am not familiar with your circulating pump, either its configuration or performance specs so take my comments with that in mind.

    I have a substantial Webasto circulating pump that could have been installed by Liberty or Prevost. I don’t know who it was but I do know if the motor fails I will shop for a motor that will mate to the pump. There are standards for things like motor size and attach points so I will just match the motor to the one on there. It will likely be on the shelf at WW Grainger.

    If the pump has failed I will do an internet search for circulating pumps and find one as close to the one I now have. Circulating pumps are not pressure pumps and their purpose is just to keep a liquid flowing. They are common for a lot of applications so finding one should not be a challenge.

    It might not mate up to your fittings exactly, however plumbing is simple and you are very likely to have little or no cost associated with installing a pump with slightly different dimensions because in my coach the connections are via hose fittings meaning a piece of rubber radiator hose can be cut to the correct length and I am back in business.

  • Tim

    Member
    February 27, 2018 at 4:03 pm in reply to: 2017 Solar Eclipse Video Update

    June

    We love it, love it, live it. We had such a great time. We are happy everyone got to experience this event with us on the Idaho side of the Tetons. Can’t wait until 2024 for the next one.

  • Tim

    Member
    February 27, 2018 at 3:51 pm in reply to: Prevost Insurance

    Thank’s guys, this info will help out.

    Gary

  • Tim

    Member
    February 27, 2018 at 10:56 am in reply to: Leveling valves

    I have had sticking Level Low valves especially if I haven’t used the system in a while. Now I make sure the AUX air pressure is at max (125 psi)* before I operate Level Low. This helps the valve spools move with more force.

    As with all systems on the bus, I have learned exercising them regularly is necessary for trouble free operation.

    Gerald

    *.. To get max AUX pressure I turn on high idle and fan the brakes until the compressor cycles on. Once it reaches max pressure I use the Level Low system

  • Tim

    Member
    February 25, 2018 at 5:41 am in reply to: No Rally, Rally – Petoskey, MI – August 2 – 6

    Does anyone know the secret to getting the folks at Petoskey to make a reservation? I have tried many times to call them over the past three weeks. Left messages, no call back. The number either goes to voice mail or to the corporate office. the corporate office can’t make the rally rate reservation. They have sent the office an e-mail and nothing in return.

    I realise it is off season up in the frozen north but the corporate folks tell me they are in the office just reduced hours.

    Any clue?

  • Tim

    Member
    February 23, 2018 at 8:56 pm in reply to: Leveling valves

    This is dangerous territory trying to analyze level low system leaks or problems for a variety of reasons. First, I think unlike most systems today the coach in question might have the “reverse logic” and in order to maintain the coach at a given level the aux air system has to be pressurized at least 30 to 35 PSI all the time.

    I also think the coach does have 5 port valves in the rear, but they are out of sight in front of the drive axle forward fender liners. But we are not at the coach and cannot tell what is true and have to rely on posted information to be accurate.

    Older coaches with unknown history can act in an unexpected manner because a poorly maintained air system in the past can put water in the valving system and make any and all advice or conclusions about problems completely off the chart.

    Lastly, the valves are definitely old style which suggests the potential for leaks in old valves and fittings and air bags is high so even if we understand fully the situation the simple answer might be to start from the beginning and replace all valves.

  • Tim

    Member
    February 23, 2018 at 5:43 pm in reply to: Tour bus rear ends 18 wheeler – Palm Springs, CA

    Dick: The money has been poor for years, and it has not kept pace with increases in other fields. A guy I have known for over 40 years who used to work for us, just retired last year. He told me he was making less money at retirement than when he was working for us 9+ years ago. Wages had been going up until the 2008-2009 time frame. When freight volume went south, so did the jobs and wages. Carriers were laying drivers off in some cases during this time.

    Also, since there are no barriers to entering the trucking business, you see many startups with older, used equipment that are willing to haul for less just to get their foot in the door. They hire basically anyone. They pay as little as they can get by with. They are the worst as they are here today and gone tomorrow only to be replaced by another fly by night outfit that does the same thing. We ran into this kind of crap all the time, and would lose freight to that kind of carrier. Then when they fell down on the job, the customers would call us expecting miracles of us since their freight was late or still sitting on their dock. Some of the customers learned that cheap is usually not good, but not all of them did. They were the ones who were always looking for the cheapest, not the best.

    The drivers you see today that are clean and squared away are the exception.

    By the way, shortages also exist in the charter bus business. Ever noticed all the old bus drivers that are out there. Guys driving that are 70+ years old are not all that uncommon in some areas. I know of a couple who were driving at 80+.

  • Tim

    Member
    February 23, 2018 at 1:54 pm in reply to: Carlisle Autofest – February 22 – 25, 2018

    Fred, I want you to know I am still charging you rent for the use of MY ramps.

    You can send my check to Jeff’s address and I am sure he will give it to me !!!!!!

  • Tim

    Member
    February 22, 2018 at 7:47 pm in reply to: Upgrade Time?

    Truk He said he is going to list it in the Coach for sale section next week.

    Craig

Page 6 of 83