Forum Replies Created

Page 41 of 83
  • Tim

    Member
    September 15, 2016 at 8:54 am in reply to: Using Jake Brake in traffic

    On and on High with my 8V92TA and it works pretty bueno.

  • Tim

    Member
    September 15, 2016 at 8:48 am in reply to: Special Thanks to PC Community for Our New #592

    John & Terry

    Congrats…just aren’t many things more exciting that getting your Prevost motohome. I hope you enjoy yours as much as Dorothy and I have. I’ll confess, there’s a serious learning curve a-coming…at least for me. I was knowledgeable about main-stream coaches, but I got a real lesson in humility when I got my coach. These guys that have had ’em for years have probably forgotten what it was like…but it has been an interesting three years, learning about my coach….but, bottom line: we love this motorhome! Supremely comfortable, maybe a tad expensive to maintain, but get ready for gushing and MH-envy when you pull into a campground!

    Good luck and good travels…

  • Tim

    Member
    September 13, 2016 at 6:01 pm in reply to: Boosting Power

    Pushing well over 25 tons and pulling a 2 ton toad up a 6% grade for several miles is no easy task. But the 500hp S-60 does a pretty good job of it. We all wish we could get over those grades a little faster but I’m content with the performance of my engine. It will take the 13 mile long 6% grade out of my home town in 4th gear at between 40 & 45mph. I’ve owned 3 busses with the same weight and the same 12.7 DD S-60 in them. They all have performed similarly. The big difference I’ve seen is the Prevost can do it and keep the cooling system at a lower temperature than the 2 Wanderlodge LXi that I previously owned.

    All that being said, I must confess, I’d love to have a 600 horsepower engine in my bus.

  • Tim

    Member
    September 12, 2016 at 10:57 am in reply to: Bus for sale

    Brett,

    I sent you a private email

    AL

  • Tim

    Member
    September 10, 2016 at 1:33 pm in reply to: Open neutral?

    It is very difficult for anyone to diagnose some problems when nothing seems to fit within logical parameters.

    It is far worse trying to do the diagnosis over the internet. When at the coach I suspect all of us that try to diagnose problems surmise what might be the cause, and almost without thinking we check for continuity, or voltage, or air flow or movement, or any of a million other things that might sharpen our focus, and help isolate the problem.

    But I think when an owner or previous owner has made a change, and especially if the change is either not obvious, or just plain makes no sense, we all go a little crazy until we can figure things out. I still have a very hard time trying to include unexpected causes for issues. One I will never forget was in dealing with a very smart owner trying to diagnose a problem on a coach that was brand new to him. He had just bought it and realized he could not get a certain function to work on the leveling system.

    He and I talked through the entire operating logic of the system and the only explaination of why he could not get the coach to do something was a defective valve. Everything else we could consider was checked and verified as operational. As it turned out the reason the feature was not doing what it was supposed to do was the pneumatic system was water logged. Not just a little moisture, but a full hydraulic lock that prevented the device from doing what it was to do. Neither of us got our brains wrapped around a pneumatic control system filled with water because it was so far from what was expected. I thnk the exact same thing may be at work creating your problems that have no logic based on what we understand a converter’s system operation will be.

    Air is pretty safe to play with and under a worst case you may create a leak. Electric is not so safe, especially if you have reverse polarity or no ground. At the very least verify you do not have a “hot” chassis where you become the conductor of electric if you touch the chassis or any metal parts.

  • Tim

    Member
    September 10, 2016 at 10:24 am in reply to: Open neutral?

    Jon,

    Thanks for jumping in on my situation. The first thing that I did when getting the coach home was go through the huge stack of manuals and documents that came with the it. During this process I went throught the coach and tried to familiarize myself as to how everything was suppose to function. You are correct in your hunch that someone has “monkeyed” with it. In the electrical diagrams provided by Marathon I discovered that the transfer switch control wiring had been altered. There are a couple of very small reconfigurations that have been noted on this transfer switch schematic. After spending 5 full days reading inspecting and testing this is the only thing that I think has been altered. The rest of the coach truely seems to be original mechanically and furnishings wise. Knowing that my inspections and research start with limited experience with luxury coaches, I agree with you that having it gone over by an expert such as Jeff at ETLC would be a wise venture. Also from reading here Jeff would probably be the best choice because of his reputation and also he is probably the closest qualified shop geographically for me.

    As noted in an earlier post to Gerald, the only things I have done is change the shoreline breaker block and breaker and changed the 3 spade terminals that seem to be linked to the alteration. I believe that the control wiring for the AC power is working as intended now. The only exception would be that I have yet to test the auto start function on the generator. If this does not function by simply switching it to autostart mode and bring the batteries down with 24 volt loads I will wait and have it tested by Jeff.

    I appreciate your concern and have a bunch of respect for you from reading your posts. Rest assured knowing that I have kept myself out of trouble “for the most part” for 30 years working on things in which I have limited knowledge. The key here as you know is not doing anything that your are unsure of based on ample research. Its important to be able to be able to sort out if a task is better left to an expert. There is also much to be gained by understanding the systems before bringing something to an expert so long as your actions do not cause additional problems. I have no illusions that there will be no more problems found or that I will be able to diagnose and fix anything and everything on this coach.

    Thanks again Jon! Jeff

  • Tim

    Member
    September 10, 2016 at 8:44 am in reply to: Private bus sales on PC do work

    Tim, just leave that pup tent packed away unless Ms Cindy decides you need a night on the hard ground. I’ve got my eye on one “H” already.

    Not planning on missing Claw fest.

  • Tim

    Member
    September 10, 2016 at 5:40 am in reply to: Head lights upgrade

    If you are talking about the LED light bar or the driving lights in the bumper no not as bright, I also had LEDs in the old headlights they where very bright and the light matched the light bar white light , the new headlights are very bright also just a different kind of light , the new ones have H9 bulbs in high and low beam and both are on when high beam is on

  • Tim

    Member
    September 9, 2016 at 4:20 pm in reply to: Head lights upgrade

    Very Nice Peter!

  • Tim

    Member
    September 9, 2016 at 3:25 pm in reply to: Head lights upgrade

    Looks good Peter!

  • Tim

    Member
    September 8, 2016 at 8:25 pm in reply to: Window Shade in Marathon

    Tim,

    Since our H’s are only a couple years apart, we probably have the same Hunter Douglass Silouette shades and they don’t have strings to operate, they just roll up and down with the motor. The valance can easily be removed with a few screws so you can get to the blind. There will be 2 tabs that are used to release the blind, I use a piece of plastic, but you can use a credit card. Look at this video: Silouette Removal

    The motor is a Somfy and the gear on the end is probably broken or stripped. The motor looks like this:

    Hope that helps..

  • Tim

    Member
    September 7, 2016 at 7:04 pm in reply to: Coach Shopping in Baltimore

    John,

    On the rear electrical box over the engine there should be an aluminum data plate bonded ot the box cover.

    It has the Detroit Diesel informtion relating to the engine, including build date, serial number and the DDEC level. If the enigne has had any service bulletins or campaigns that have been complied with there is likely to be a sticker located near the engine data plate atached as will so you will know its service bulletin status

  • Tim

    Member
    September 7, 2016 at 7:00 am in reply to: 2000 Vantare keyless entry not working

    Take the windshield out as drilling the lock is bad idea on a XL, those locks are not available for several years….I have sent locks out to locksmiths to have them matched and not had good success. I would rather drill out the handle and replace it than the lock

  • Tim

    Member
    September 5, 2016 at 7:26 pm in reply to: Noisy Dash Air

    Doug,

    I think you have to go through the dash. I helped Roger years ago, don’t remember the vintage he had,

    but we found a pen in the squirrel cage that had fallen in from the defrost vent.

  • Tim

    Member
    September 5, 2016 at 4:56 pm in reply to: Noisy Dash Air

    George,

    Thanks for responding. I didn’t know if anyone would remember your 3 year old post! I will try to access it from the top. Others have said it may be easier to remove the stainless from the front of the bus to get to the blower! I’m up for trying something easier first.

    Doug

Page 41 of 83