Robert
Forum Replies Created
-
Bill,
I don’t know if DDEC I is even supported any more, but one of our members is pretty savvy on the 2 stroke engines and I believe DDEC and what can be done with it.
Luvrbus, help this poor chap if you can.
But I do not think you are dealing with a single issue. I would treat the Jake problem as separate from your lack of boost. While your issue with lack of boost or performance could be DDEC, I would do a detailed inspection of the exhaust manifold and the manifold gasket. Both have been historic problems with the 8V92, with the gasket blowing out, or the manifold developing cracks both of which will rob you of substantial power. Look for sooting around the manifolds, a sure indication of the problem.
-
The door locking mechanism on an XL is completely different than the one on the XLII. The operator can control the locking mechanism on the XL, and the one on the XLII is automatically engaged and there is no option to not engage it.
-
ya have an extra bus pass and tickets? We would love to join you!
-
My story, when we first got our bus, we had a large hound dog who bolted one night as I was taking her for her evening walk before bed time. Nearly pulled my arm out of its socket! , So, I began backing down the steps ahead of her to make sure no other dogs were close by and it worked. Of course, now I have a couple pair of jeans with both the right and the left belt loops gone….oh well,jeans are replaceable, shoulders not so much.
-
In most areas with cold winters some fuel dealers blend fuel for cold running. Cut rate low price fuel will not be winter blended. in our area blended fuel cost more. any bio over 5 is asking for gelling when cold. A tank full of fuel bought last summer is not a good plan for cold operation. Having family in trucking in Colorado the use of fuel blended for cold running will not gel at any temp we will move the bus. After Christmas we are leaving for AZ. In the first few miles will top tank with blended fuel.
-
bad valve or bag to full=needs to lower coach to set ride height. Exhaust air from bag to do this—- as Jon said safety first key on position… more details on when you observed bubbles.
-
You mention engine brake spare parts,why not order it with a transmission retarder?
-
Don’t worry about it Bob. This is not a Spelling or English test and we know exactly what you are saying.
-
Robert,
I cannot help you on what sensors you need. I carry the Detroit Diesel sensors that others on various forums have posted problems with. The Volvo engine I am sure is different and although codes are somewhat universal I cannot help with how to access them and interpret them.
As an example we had all kinds of check engine light and fault codes displayed on a trip to Maine. The problem was our charge air cooler. Because it was leaking so bad it was kicking out a series of codes and their modifiers. Because I carry my reader for the Detroit Diesel DDEC V which my coach has I was able to verify all operating parameters with the engine were well within safe limits and I could read not only the code, but the modifiers which give more specific detail. Because nothing other than the lack of turbo boost was wrong I could keep on driving until we got home.
I am sure the same type of reader or provision to read your engine fault codes from a lap top is available so you can see specifically if you need to seek help, shut down, or keep on driving. I think the best source for setting you up with the best spares and the ability to read fault codes in detail will be Prevost or a Volvo engine dealer.
I know your new coach will have a message center and it will have diagnostics. I know the diagnostics are detailed enough to point you at Prevost electrical faults that help you to isolate problems. I do not know if the diagnostics for the engine will provide you with the detail you need to make qualified decisions about what action you must take. I can tell you that if you intend to do your own diagnostics and repairs you need to look at the Prevost training schedules and make sure you enrol in the classes covering those areas of concern, such as AC, electric, etc.
-
1st prob bad ground—-loose or dirty connection + or – 2nd one bad battery—-you might be only showing a surface charge and when under load one fails… Break connection of batteries in stack then ck voltage indivually. . Have found the most likely to fail driverside top stack.
-
Joel
The side drivers window replacement was estimated by Dallene with Jason (no longer shave haircut) standing next to her last Thursday morning, Nov. 21st, 2013
-
Ouch guys, they(Mira Loma) put ours in for 0$ last Oct in Vegas.
-
I thought the Joads made it all the way to Californy.
-
There all on breakers–at worst case — color coded—- yellow 12 volt red 2v volt FWIW future refetance all wires have code tatoo on them usuall 2 or three didget some with a letter and > or < indicating direction of cuttent flow.. Is that too much info? Most all connectors have paper tag with code stamped there is a ledgen on prevost we site that tells which switch they plug into..& what it controls---lots of extras that go nowhere =just incase wires... Bob blk ground usually single # and letter
-
Rick.
There is a relay valve over the tag axle for the coach service brakes. It has two extra ports, both likely plugged. You can get a connection there. No air will go to the toad braking system until the coach service brakes are applied, and when the brakes are released the valve will release that air pressure so the toad brakes will not drag.
Make sure that is the type of air supply the M&G system requires. I use that set up for my Brakemaster braking system. If that checks with what M&G calls for you should have no trouble finding the relay valve if you follow the service brake air line from the brake chamber back up to the relay valve which is bolted to the underside of the coach floor.