Forum Replies Created

Page 28 of 48
  • Jon

    Member
    December 11, 2021 at 8:52 am in reply to: Recent experience with Ft Worth Prevost Service ?

    In Fairness to Prevost, I have been the victim of Prevost techs learning on my coach and making costly mistakes. But they stepped up to the plate and corrected their mistake at their cost. Plus when it’s done Prevost stands behind their parts and labor for 1 year (even on a 21 year old coach). Hard to find in today’s world.

    Chuck

  • Jon

    Member
    December 9, 2021 at 10:44 am in reply to: Connecting to 30 amp service Inverter operation

    GMJDW: Check your manuals, but I wouldn’t be surprised if there are dip switches on the rear of your inverter control panels which will allow you to adjust the inverter charging power use. Stupid pita place to put them.

    Your vintage coach should have no problem being stored on 20 amps as long as you don’t need heat or a/c and provided you’ve set the inverters to limit battery charging draw. My coach is stored on 20 amp service.

    Maybe you could find the upgrade control panel(s) used on ebay.

  • Jon

    Member
    December 8, 2021 at 8:01 am in reply to: Connecting to 30 amp service Inverter operation

    If you just keep your amp use on each leg well under 15 amps you should be fine. High amp usage such as bulk charging, water heater, cooktop and microwave as an example have to be monitored and must be on separate legs.

  • Jon

    Member
    December 7, 2021 at 12:52 pm in reply to: OTR oil leak

    An OTR compressor seal for a professional is about a 2 hour job, more or less, and involves popping off the clutch and the bolts behind the clutch to expose the seal.

    It is not complex, but after completion will require some recharging. The system can have most of the refrigerant pumped to the system, and then the compressor sealed at the valves to minimize the refrigerant needed to recharge.

    Take advantage of the Prevost service manuals on their web site because they do a great job of providing instructions.

  • Jon

    Member
    December 7, 2021 at 10:41 am in reply to: OTR oil leak

    This post was timely for me as I was getting ready to ask a related but slightly different question. I’ll just jump on here since the conversation is similar.

    This week after running the coach (without OTR running) I saw oil on the ground below the AC compressor and see that it has leaked oil below the compressor shaft. Pretty obvious to me it is the compressor shaft seal.

    I am headed to Florida at the end of the month. Is there any issue with driving it (without running OTR) and getting it repaired in Florida? Also, is that seal something I could consider doing myself (I have done alternators) or is it something I should just let a pro take care of? If it is something you have done, does anyone have the service manual with instructions?

    Thanks as always!!

  • Jon

    Member
    December 7, 2021 at 8:56 am in reply to: Clean sheet design: inverters, batteries, etc.

    Chad, same here on the batteries! I have been following those videos for a while now. Although I would consider using a different BMS, or at least make sure the alternator will shut off if the built-in BMS decides to disconnect.

    Jerry, I have considered a lead-acid and lithium combo, but for simplicity I would prefer a single type of battery. In the design you suggest, can I assume the inverter/charger is connected directly to the lithium batteries, and the lead-acid is only a buffer for alternator charging?

    However, I should give the lead-acid buffer a little more consideration: given that there is already another 24-volt lead-acid battery system (chassis batteries), I wonder if there’s a opportunity to sort-of combine the two systems, house being lithium, chassis being lead-acid, and all alternators charging lead-acid, and BtoB chargers “carrying over” charge from the alternator, through the lead-acid, to the lithium batteries.

    With Victron, the BtoB chargers should be able to be controlled by the inverter, and you could stack these chargers in 70-amp increments. So getting to 200-450 amps should not be too difficult, as long as there is not a problem pulling that current from the lead-acid batteries. There’s also some opportunity to have chargers in the other direction, in case your lead-acid chassis batteries are drained after sitting a while. I am really liking the sounds of this…

  • Jon

    Member
    December 5, 2021 at 10:21 am in reply to: No power to my thermostat

    Tony:

    Not sure about this, but I think there is a fuse on the control board in the basement unit that provides power to the thermostat.

    Chuck

  • Jon

    Member
    December 1, 2021 at 7:30 am in reply to: Too Cold here, where to go? Planning tools

    The correct link to Weather Underground is https://www.wunderground.com/

    I prefer Weatherbug https://www.weatherbug.com/ but both have excellent information.

    Where to go when it’s cold up North? My choice is Arizona. I have FL but lots of folks head there as well. If you want to go to TX it’s not “warm” all Winter unless you head to S. TX toward the Mexican border.

  • Jon

    Member
    November 30, 2021 at 4:14 pm in reply to: Driving with tag axle up

    My bus is a 2005 2004 shell it came new with grease bearings and I love it so for. The original owner that had it built was in the in trucking business

  • Jon

    Member
    November 29, 2021 at 10:38 am in reply to: Prevost Week West Palm Beach

    Jackie and I will be there

  • Jon

    Member
    November 24, 2021 at 8:54 am in reply to: OTR oil leak

    My concern is that the leak may not be the fitting but rather the point of attachment of the fitting to the panel. If so, the price of poker goes up. Agree with Jon, not likely to cause a disaster. If this is not a R22 system, can top it off quite a bit for not much money. And keep an eye on things. Could go a long time before having to do anything else. Perfection being the enemy of success. While leaks from unknown sources tend to drive me crazy, as long as I have a handle on it (and take my medication) I can tolerate not throwing money in that direction – as long as it is cooling ok.

    Mike

  • Jon

    Member
    November 23, 2021 at 1:51 pm in reply to: OTR oil leak

    Jon:

    Cleaned the area while up in Massachusetts, 1,200 mile drive home and found the leak. Had a drip of oil on my garage floor, looked up with flash light and saw a droplet of oil hanging from the bottom of the nut shown in the picture. Touched it with my finger before taking the picture so oil residual is not as noticeable as it was before I touched it.

    I did have the leak around the compressor shaft seal as you noted, that was fixed about 1 1/2 years ago.

    Can I make a couple of hundred mile trip without damaging anything or should I just keep the bus air (OTR) off?

    Chuck

  • Jon

    Member
    November 23, 2021 at 10:30 am in reply to: OTR oil leak

    It’s amazing how clean a 20 plus year old Prevost Bay is and how well it’s made. I work on a lot of different Fiberglass motorhomes in different bays working ontheir Aqua Hots and even on newer coaches not nearly this nice.

  • Jon

    Member
    November 23, 2021 at 12:20 am in reply to: WANTED: Ole B & W Sony Dash Monitor

    Don, check with http://www.colawrvsalvage.com they’re located in Carthage, MO and they should be able to help you. Just give them the Sony part number.

  • Jon

    Member
    November 22, 2021 at 11:15 am in reply to: Need Rv drivers for phoenix Arizonia and nj

    Another option would be look for professional tour bus drivers.

    Bill

Page 28 of 48