Chip & Pam
Forum Replies Created
-
Roof air? Bus air? What type of unit? What manufacturer?
We just replaced the 3 dometics on our 98XL CC. Had #1 leaking condensation into the bus. Check the drains. If you have the old penguin ones, the drains are made out of vinlyl and they crack over time. The gurgle could be air coming in thru the cracks. New drain cups are no longer made like the penguin 1’s had.
If it is not your drains, your unit is aging out. The only down side of the new penguin 2 units is that they are a little bit louder than the penguin 1’s. I don’t mind it but, it is a few decibels louder than the originals.
-
We are fixed!! Chuck Williams installed 3 new units and the program boards. Ice cold air and no leaks. Chuck found that the RV place, from Manassas screwed the #1 unit up. The wiring was completely wrong. The tech had placed the wiring in such a way that the heat pump reversing valve and the AC were firing off togther. He also saw that the knucklehead had miswired the capacitors. The tech also failed to secure the capacitor on the unit when he swapped board. To top things off, the ground wire was not properly attached. To add insult to injury, the drain cups were siliconed to the bottom of the evaporator drain in such a way that if the lines ever became clogged, the cups would not drain via the overflow. He clogged the overflow with silicone. This was their top guy working on the bus. He was a complete @$&.
Never again will I do business with that shop. I am heading back to talk to the owner and request a return on my $. They ruined a brand new penguin 2 unit, they charged me up the wazoo for labor and they job was complete junk. Lucklily Chuck was able to take us in and fix it all. Thank you Commonwealth Coach for coming to the rescue.
-
Thank you Tom. Just wanted to make sure that wouldn’t make the bus run hotter or adversly affect anything else.
-
Below is the link to a thread on another forum where a contributor is the retired engineer that created the TES295 transmission fluid standard. He is also the co-owner of an oil analysis company.
Sign-up and ask away, its free.
http://www.irv2.com/forums/f125/former-allison-transmission-fluids-engineer-89293.html
-
Sorry for the delay, I’ve been in a nightmare scenario with our AC and RV bozo that screwed it up.
we purchased our MP straight port pumps (2 of them) from “A Parts warehouse” Lake Orion Michighan. Cost was $240 each.
-
having these new lights made me realize something interesting. The couple times my wife was following me in a car, she would complain that I rode the brakes. I couldn’t tell what she was talking about? Well with the trailer behind the coach, and the rear facing camera on, I soon figured it out through the reflection on the trailer. As the retarder comes on, the brake lights actually come on. So coming down a hill, the retarder will be on and the brake lights illuminate. With the original lights you couldn’t see a reflection on the trailer while driving.
-
A very good point Jon.
I had transmission filter and fluid change done to both Marathon’s. One at Marathon Texas, other at Jeff’s.
I do not want any air tools near my Allison Trans. I’ve watched the service to confirm outbound and inbound bolts are not striped.
Second thing if shop does not have a torque wrench…skip the service.
IMHO…..If a tech uses an air ratchet on a Allison Trans….Idiot comes to mind.
PC members you have to really pay attention getting transmission service . Shops that make a mistake will usually play the blame game….Oh, we found the bolt stripped.
I believe the Allison filter housing bolt repair kit is north of $300.
-
The last time I talked with them, they hadn’t designed mounting feet for the Zipdee arms that follow the contour of the stainless panel. I was told this was of lesser priority. Maybe I need to call them again. We have seen the new electric awning demo’d at our last summer’s WBCCI International rally in Farmington NM. While a bit noise, we would do the conversion
-
On your Liberty with what might typically be the loads, including phantom loads it would probably be reasonable to expect you could shut off the shore power or generator at 10:00 and in the morning still have 24.5 volts showing.
So maybe 8 to 10 hours your voltage might be at that level.
That has been my experience with the last two coaches, both of which had 4 8D batteries.
As to the auto-start, I have not used it. But those who use the Liberty Watchdog have said the voltage when it starts the generator is in the 22 volt range. I could never bring myself to abuse the batteries like that so I tried to never get below 24 volts.
If yours has not kicked on by around 22 volts the Watchdog may have an issue. If it has gotten so low as to shut down inverters something is not right.
-
You are right Jon, I think rebuilding the toilet is a right of passage for all Prevost owners.Tom, no fancy test rig for me, I just balanced it on a 5 gal Homer bucket. I’m sure it looked like I was at the alter. One hand on the coffee cup one hand on the throne.
It it really was a epiphany moment.
Wax ring? Oh yeah add $2.50 to the bill. Still the cheapest fix on this beast. And the most enlightenment, even if not the most fun.
-
check the map for a place in Augusta just off i20 that comes recommended. We have not stayed there ourselves.
I would offer my bus barn but I will be out of town and had to cancel my Bella Terra reservations it also 12 miles off the super slab
-
Chip & Pam
MemberMarch 23, 2016 at 6:45 pm in reply to: Side window privacy shades & retracting mechanismMike,
Is that photo sideways such that the pleats are vertical not horizontal like on the main coach side windows?
If yes, the bottom line is I don’t know but, I’m following this thread. My side windows have these along with the front windshield. I have not been able to find a direct replacement. My existing shades had a united shade company name on them but when I contacted them they claimed to have never made such a product.
waiting………
-
Is it the Detriot message center that u need???
-
Will,
If yours is a DEC II I have the entire DEC troubleshooting manual for the 8V92. Provides the diagnostic steps for each code. Flash your codes using the test switch in the steering bay and post them. I’ll find a way to get you the right pages.
-
Welcome Doug & Mary!
This forum has been invaluable for us to learn about our bus! The seminar was terrific and a place to connect to other owners when we researched the Prevost bus.
Now, if you can just get Jon to include an updated power point slide on “how to use your IPhone when surfing the PC forum…