Archived
Forum Replies Created
-
Our MX manual says 50 psi.
-
My new Renegade Ikon is coming with Victron’s. I know little about them, but from what I have been reading, those that have them really like them. They are supposed to be true sine wave from the spec sheets.
-
Same thing.
The dip stick on the 755 transmissions especially with new clean fluid is very difficult to read.
On the pan on those transmissions is a small plug that I think ison the driver’s side. It needs an allen wrench to remove it. With the transmission cold run the engine. If fluid runs out, leave the plug out until it stops running out. If none runs out add a little at a time until it does run out.
That is the most accurate way to verify the correct flui8d level.
-
Thanks for the recommendations.
-
So, after all of this, the problem was quite obvious, and I thank each of you for you shared knowledge and encouragement as this group has always been a great help to me!
The weather box for the outlet I bought was keeping the connector from seating completely and at an angle so one of the legs ground or neutral wasn’t making contact. I trimmed the edges of the box after the electrician proved the wirning for me and it has worked fine all weekend!
Dumb oversight in my troubleshooting!
Thanks Again Everyone!
-
Very complicated place first I had my finger wrench and was told by Tom I had free dues,now I brought up this issue and owe dues so Tom check is in the mail please stand by mail box as it needs 3 forms of ID to receive, you are welcome.
-
If you can access your tanks, SeeLevel is the way to go. It’s very accurate and has Bluetooth as well as a monitor.
-
For answers to the first question, it first has to be determined what devices and systems require 120V, and how much current draw each requires.
In my coach, just to cite a few examples, I have a Headhunter water pump and it pulls somewhere between 10 and 15 amps. If I want hot water my HW tank draws about 10 amps. My refrigerator pulls about 5 or 6 amps. My inverters can pull whatever I set them at and right now both are set at 10 amps. Then there are TVs and phantom loads, and any use of DC power adds loads to the inverters.
With 30 amps the true full load assured capacity is 24 amps, but if the breakers are good and all RV park wiring connections are tight you can have up to 30 amps available but don’t count on it.
I did not buy a Prevost to live in a tin tent and would rather park at Walmart with the generator running than in an RV park with only 30 amp power.
-
Congratulations and now the FUN starts .
-
Are you talking about valve adjustments which are an expected occasional need, or are you talking about trying to increase HP?
-
Wave,
I can’t spare you from dealing with a hack, you already did. Who made the decision to put 365 tires on a 14,000 steer axle. Did someone advise you on that or was that your idea?
Steele has done numerous videos that we’re full of mis-truths and lies about Prevosts and built a large audience doing it. His shock value titles are fine for entertaining but not truth.
If you think his videos have helped sell coaches for people that’s fine, he brings value to them but he gets paid on clicks and if you think going from a detail man to a trusted source on the internet for buses I and many others disagree.
As far as kyle goes he did the videos with Steele so he doesn’t get a pass but I know nothing of his work good or bad. And never will.
It’s none of my business who you give your money to or video’s you watch but for people to come on here and post his videos while he gets paid for the clicks is not the proper thing to do.
Later
bv
-
you can adjust the length of the flush.
Larry Nelson
2002 XLII VISION
-
Bernie,Mark,
Amen and a chorus of Angels on top of that!
R