Forum Replies Created

Page 115 of 2304
  • Archived

    Member
    October 3, 2020 at 6:43 pm in reply to: This video could save your life

    If you have a blow out the first reaction should be to apply power to stabilize the situation. The application of power disengages the jake or retarder so if you do what is needed initially neither is a factor.

    Then once stabilized reduce or remove power appropriately to begin slowing while maintaining control. Neither the jake or retarder will be on if you are still applying a small amount of power, and if you take your foot from the pedal, engaging either, if the coach starts to exhibit some unwanted actions, add back in a little power or disengage the retarder.

    Nothing should be done suddenly except the application of power and then only to maintain stability. After that anything that is done can be done gradually and smoothly.

  • Archived

    Member
    October 3, 2020 at 6:38 pm in reply to: This video could save your life

    Thanks Al. Wasn’t sure whether either system could be used once back in control of the coach/wheel after the initial blowout…to help slow down when maneuvering over to the shoulder further down the road? Or, do you just let the vehicle glide to a halt?

    Thought using Transmission Retarder or Jake might be preferable to touching the brakes at any point in bringing the coach to a full stop.

    (Not to jinx us…but, so far fortunate enough to never have experienced a blowout or flat.)

    Will definitely watch the video, again. Don’t believe the server could be found on the first forum Post. Will scroll through the above Posts for an active link.

  • Archived

    Member
    October 3, 2020 at 6:19 pm in reply to: This video could save your life

    The video is about what to do in case of a blow out at highway speeds. We’re talking micro seconds when it happens.

    Watch the video over and over as your actions make the difference ending in the ditch or the shoulder.

    Safe to say …you won”t have time to think about Jake or retarder. 636381

    Ive seen 18 wheelers safely on the shoulder with a blown front steer. To me that represents a professional.

    Go back to first message on this thread…blue letters are hot. Sorry forgot to post that info.

    AL

  • Archived

    Member
    October 3, 2020 at 2:45 pm in reply to: Microphor

    If you have just the electric one like I use to have, do you hear the motor run when you actuate the flush handle, if you do and the flapper does not move it is probably the plastic shaft the flapper is made on is striped or one of the plastic gears in the motor housing is stripped.

    Either one of these conditions require toilet to be removed.

  • Archived

    Member
    October 3, 2020 at 1:10 pm in reply to: This video could save your life

    This video could save your life is dated but the message is not.

    Please watch the video, post your comments, tour this thread as a lot of stories, opinions are documented.

    Go back to first post on this thread to watch video. 636381

  • Archived

    Member
    October 3, 2020 at 10:33 am in reply to: Microphor

    Dorel

    Did you ever change the mixing valve I sent you 3 years ago?

    Air opens the flap I believe, do you have any aux Marathon leaks on the house side? Can you get the cover of the toilet off to inspect?

    You know the answer is Tecma.

    Later

    bv

  • Archived

    Member
    October 3, 2020 at 7:51 am in reply to: Tachometer – Identification/Replacement

    Check for a loose or bad ground behind the dash.

  • Archived

    Member
    October 2, 2020 at 2:16 pm in reply to: Odometer Not working

    Where did you purchase yours, Art? I am also needing to replace a Speed Sensor. So I am thinking I might as well get a speedometer at the same time.

    Hope all is well with everyone in the PC.

    R

  • Archived

    Member
    October 2, 2020 at 10:12 am in reply to: Jake Rebuilt

    I certainly don;t claim to have the mechanical experience as others here. I too was concerned about having my engine removed for the valve job. But I think it all depends on where you go. I took it to American Fleet in Springfield and these guys do this all the time. In fact they wouldn’t do the job in frame as potential for expenses and damages inside in their opinion outweigh the risks of pulling. Out and back in with no drama. Another advantage is they replaced every single piece of hose and several other items I don’t recall while it was out that would have been difficult in frame. Just my two cents worth.

    Bill

  • Archived

    Member
    October 1, 2020 at 7:58 pm in reply to: Odometer Not working

    Look on the invoice I sent you it say’s Pulse# 034900

  • Archived

    Member
    October 1, 2020 at 8:51 am in reply to: Odometer Not working

    So when replacing does the odometer start at 0 miles on does the current miles come off the ecm?

  • Archived

    Member
    October 1, 2020 at 7:26 am in reply to: Jon, oh Jon, oh Jon, oh *&(*&^%

    I’ll repeat…….Unless you have an agreed value policy you have just allowed the insurance company to decide the market value of your coach.

    How comfortable do you feel letting someone who has a large financial stake in the business agreement you are in with them thinking your coach has the same value you think it does?

    Your agent might be the nicest guy in the world and your best friend and he has zero chance of convincing the insurance company what you think is the real value of your coach is correct.

  • Archived

    Member
    September 30, 2020 at 10:09 pm in reply to: CLARKE POWER

    Clarke Power in Nashville ran up a bill on me a few years ago to the tune of $10,000+. They were only authorized to check the transmission that had recently been replaced by another Clarke Power location. When I called for an update they were replacing stuff we’d never even discussed checking. Their internal communication was deficient, to say the least. Fool me once …

  • Archived

    Member
    September 30, 2020 at 10:05 pm in reply to: Odometer Not working

    They do that. I replaced mine a few months ago, found one cheap on eBay.

    You have to figure out what the pulses are one way or another, I think my setting was about 36400.

    https://www.ebay.com/itm/VDO-1-211-012-341-Vision-Black-85mph-130kmh-3-3-8-Electronic-Speedometer/382971209158

  • Archived

    Member
    September 30, 2020 at 10:53 am in reply to: Camaro

    Never took many pictures of my cars, never thought about it. My buddy growing up still has his car from high school , that what my 68 looked like, this car has around 40,000 miles on it, should have kept mine, could not afforded it back then in high school.

Page 115 of 2304