Archived
Forum Replies Created
-
Jon, I ran it today and I would say the noise is about the same. So trading 2 inches of old for 1 inch of marine grade material must be about equal.
Inside the coach I attribute most of the sound to the squirrel cage fan and motor not the yanmar diesel. In my setup the radiator is mounted horizontally to the floor of the second bay, just ahead of the Aux fuel tank. The direct drive fan is mounted on a plywood box mating with the radiator. All of which is directly below the aisle in the living area.
I did pull the access panel to the fan and interesting there is not any insulation on the top of the bay, only the back side and the left side wall (the right side wall is the back of the generator box).
I have some material left and will add a layer to the roof one day. My primary objective was to get the old crumbling material away from the generator head. Two many stories of expensive repairs due to grit and dust in the head.
-
David I don’t have dash air, but I think the radiator fan on coaches that do may cycle with the dash air compressor clutch.
-
ALTITUDE!!! Overnight thought. Our coach previously lived primarily in Kentucky and Florida (2002-2017). First few in OK, and the two years before our purchase in OR, not used. Dr Frank Poorer (KY and FL) was the longest owner
Would ALTITUDE have anything to do with our issue. Everything else up here gasps for air, why not genset cooling electric fans
todays experiment will be to power electric blower externally again with access panel, genset side, removed with sound box door open, then shut to check amps in blower. Increased air flow thru the radiator via floor opening beneath genset, as well as the draw from ground at radiator could change things
-
OMG how’s that flexibility tonight ?
-
Looks great Joe, congrats.
-
Dee and I send our condolences Roy and 48 years, that’s somethin! You be good to yourself you hear!!!
-
Yes Dick, thats the most sense. Featherlite didnt indicate that when i spoke to them
We are going to clean the radiator today. Reading, there dhould be 30 degree difference of the coolant between inlet and outlet. Perhaps air is restricted from tears of grit slowing air flow hence heating it up. Stay tuned
-
Thank you Bernie and Tom…
Tested the motor with 12V power directly to the motor, no turning or even trying to turn. Gently tapped the motor, no luck.
Motor out of commission…talked to Jeff and I decided to take the job on since getting a new Tecma Plus could take awhile.
I ordered a new motor, new cam to replace if needed, a service kit for the vacuum breaker and flapper gasket. The other components seem to be OK.
-
Wait a minute, if the vacuum motor has to work harder wouldn’t the amp use be higher?
You will hear the motor speed up significantly because the motor is working less.
-
Jon
our test showed amps drawn by blower fan sourced out showed 9.7 amps pulled. When we opened the access door, amps drawn was 11.4 ish. So what you described above with your vacuum cleaner analogy proved true.
The main problem remains, the squirrel cage fan/motor assembly housed in this sealed box pulling hot air thru the radiator iscawash in “hot air”. This hot air per our installed thermometer shows with ambient temperature of 85 F, it took 19 minutes for box interior to raise to 104-5 degrees, which is when electric fan motor inside squirrel cage fan QUITS due to its spec of 104F degrees shut off. -
Ditto, plus all over my house on various older TVs. It is the best. Someone put some nice but not smart TVs in my Liberty and this is what makes them smart! I get pretty good internet with my AT&T even though it says it might throttle at 25 it rarely does.
-
Today, next we will,plug radiator fan into alternate source via extension cord again without genset running measure drawn amps, the take access door off (surrounded by the blue tape photo above) and check amps drawn If amp drawn with access door off, them
n original design fails to provide inadequate air flow pulled by fan blower thru radiator, or radiator is too plugged for the proper air flow to keep fan motor from working too hard aka pulling more amps which creates hest, which eventually under a good load causes fan to heat up that bewitching ambient air temp cut off point
-
John. Grainger fan/shroud/squirrel cage came with new run/start capacitor albeit different than original. Old was 30amp. New is 65
We even removed new capacitor from side of fan shroud to get it out of heat and mounted it outside box cover
i guess next step is carve larger opening in bay 3’s floor and lay radiator down flat and mounted squirrel cage fan shroud on top like other Vantares we are looking at for hints on internet