Tim
Forum Replies Created
-
Congrats Gary, See you down the road.. Prevost or airstream, we do both, you can’t go wrong with either
-
Dick, no I,m talking about the rally (no cost) at Parliament Jan 4th-8th. Geo.
-
It’s for access to a A/C air filter. The screws are removed which gives you access to a clip, pulling gently can remove a narrow 18 inch filter which needs to be cleaned. The dust and dirt on that filter is from the A/C recirculation button on the A/C dash control.
-
We are booked also… we got the same spot we had last year which was awesome !!! Ready for April to be here….. and looking forward to meeting old friends and making new !!
Cheers… Diane & Larry
-
Ronald,
Forget about pressure washing, there are so many things that can go wrong with that idea. And I am sure if one of your units gets fubar’ed from some dude with a pressure washer you will end up on your own.Take off the covers and carefully brush any junk stuck to the outside of the condenser coil. Then just use water. Chemicals are fine if you are very dirty or oily and I am sure yours are not. Coil cleaners contain acid and even the ones that don’t have harsh chemicals in them that could streak your paint. If you feel you need some kind of cleaner and plan on using it, make sure you wet down your paint job and roof so the acid and harsh chemicals are diluted by the water so not to streak it. Again……. Just water if you can…
Steve
-
Some of the early 60 series detroit had 5 speed Allison transmission Darrell
-
Jon and Tom (or anyone knowing),
I wouldn’t mind turning off the ‘heat loop’ during the summer. Is that easy to do?
Thanks,
Mark
-
I hope so. Aggravating(sp) If not run a new groung to black wire going to motors also the relay block attached to bottom of dash frame. right of brake pedal about a foot is bad about loosing ground. I had mine loose during rebuild of dash and things didn’t work. Put screws back in and all was good. Maybe I’m late to game but just read this. I pay less than 150 for non prevost defroster/heat/ac (motors in front air box). Just two wires going to 24 volt motors that are pulling 12 V on low 18 volt on med and 24 v on high thru reostat/fan control. Bob
-
12/16/2015 4:54:41 PM
– Thread – Jon
CAC hose solution Special thanks needs to go to Bill F and Karl L. because this problem has apparently been resolved and awaits a sign off at Prevost, plus an updated CAT base. Both guys kept the topic in the forefront.
Bill Jensen who is retiring at the end of this month, and who is going to be sorely missed relayed the following information.
It is a little confusing and I think I have the numbers correct, but within a short period of time (maybe a couple of weeks) all branches and the parts guys will be up to speed on this hose isse.
First, all hoses specified are going to have the 500 degree rating, including the cold side. So any future hose replacements are going to eliminate any concerns about the hose temperature ratings. That is a huge improvement and is great news.The only thing we all have to be aware of is all hoses are going to be BLUE. That’s right, Volvo has 500 degree hoses and they are blue so once this change goes into effect the color will no longer be used to determine the acceptability of the hose for the application. The part numbers are now going to have the temperature rating so if in doubt check with Prevost parts and they can verify the temperature rating.
It could be confusing to those of you who have had recent hose replacements and got blue hoses. The only key to acceptability is to review your paper work or look for the part number on the hose. Here is information I got from Bill regarding part numbers, but please verify the accuracy with the parts guys if you feel the need to change hoses.
Volvo 70396486, 7039865, and Prevost 531471 are all 500 degree rated hoses. If you have blue hoses on the hot side, if they have any of these numbers you have 500 degree rated hoses. If you have 531469 you have a 350 degree rated hose.
If there is any doubt in your mind regarding the hose rating I would urge you to order replacement 500 degree hoses and just keep them with you in your spare parts bin if you don’t want to change hoses at this time.
-
Ok
I don’t want this to become a Marathon Vs. Liberty thing but this is my two cents on this. It’s complicated and over engineered for what it is but it sure nice on a marathon to put the cap on the hose after dumping both tanks the hose is clean. Press a button and the hose retracts..another button and the drop door goes up and I don’t have to touch a hose, rinse a hose etc.To Jon’ s point about never filling the tank without dumping first. I guess that means your pump is always on?
To each his own I guess
-
You could have 2 ways to turn it on. If your on shore power you might ignite it off your dash but if you have no power going to the bus you would have to use the plug in back.
Truks is closer to your vintage, he will know.
Your engine loop water off the webasto is a valve to the right of the radiator on a straight pipe. Looks like a water valve you have at home.
Later
bv -
Steve
One of your Liberty boys needs to jump in here but most block heaters are in the rear CS engine bay.
Your looking for an unplugged extension cord that usually is hanging in the rear corner, plug the cord in to 110v and it will start the heating element for the block.
Some cold weather builds also have oil heating plugs but I doubt you have that.
Later
bv -
Geo, have you ever found a free pet of any kind?
-
That plug got pulled weeks ago Bill by popular demand.
For up to date events & rallies go to Rally Information, the big blue box.
-
Each counterperson (even the women) are purpluxed the first time they see the card. Sometimes before I can say turn the card over, another counterperson seeing the purpluxsion and tells them what to do.
About the only thing that I don’t get a discount is something that’s already on sale with a discount. The discounts have ranged from modest to significant. Worth the time and effort to sign up and use the card.