Forum Replies Created

Page 27 of 214
  • Dick

    Member
    May 12, 2021 at 9:59 am in reply to: Clean sheet design: inverters, batteries, etc.

    Hi Chad.

    To your question, “Is it available somewhere online yet? “. Yes, go to the Bus Conversion Magazine web site and you can subscribe which will allow you to download all previous editions of the magazine.

    If you are thinking you can run a 220vac mini-split AC off 12vdc batteries through inverters, do the math and calculate the 12vdc amp draw. Then think about the size of wire required to carry that many amps (don’t forget the inverter losses) and the size of a battery bank required to run that unit for very long………

    You are way better off just turning on the generator when you want to run that unit while not near a power pole.

    Jerry

  • Dick

    Member
    May 11, 2021 at 9:46 pm in reply to: Clean sheet design: inverters, batteries, etc.

    Here’s a photo of the inside of the driver’s side OTR duct, taken from the first bay looking aft. You can see the end of a curved air deflector at the top. The two pipes at the bottom are the coolant pipes, running aft to the shutoff valves behind the main engine radiator. I gave up for now on removing either those pipes or the AC refrigerant pipes along the passenger side. They seem to be anchored at some intervals. I do think I could fish some flexible ducts back in the remaining space, so the ducts could still serve an HVAC purpose.

    I don’t think I could cool the bedroom with a mini-split mounted in the first bay, but I’d be okay with that going down the road. If I could cool the rest of the bus, I’d be very happy. Research continues!

  • Dick

    Member
    May 11, 2021 at 2:03 pm in reply to: Advice!!!!-Financing for 1996 Prevost

    All good but if your running a 800 up credit score, and have for years, and know your lender, won’t be much of a problem.

  • Dick

    Member
    May 11, 2021 at 11:17 am in reply to: Clean sheet design: inverters, batteries, etc.

    Hi Chad,

    The simplest and easiest way to upgrade the house electrical in a coach of your age is to split the house battery bank into two banks – one devoted only to powering your AC appliances through an inverter (or two) and the other devoted only to powering your 12vdc lights, pumps and appliances. By now your coach probably has been converted from incandescent to LED lighting so the 12vdc loads are quite light involving mostly pumps, fans and perhaps a 12vdec appliance or two. Most of the house load is powering your AC appliances through an inverter(s). You can make the inverter house battery bank LiFePO4 if you want to (highly recommended) and leave a couple of your existing lead acid batteries to handle the 12vdc loads.

    I wrote a multi-part series on how and why to do this that was published in recent issues of bus conversion magazine if you are interested. You can leave your alternator and it’s wiring alone. You will only need to add a couple of new components and you will wind up with a modern house electrical system that will be properly recharged while driving, while plugged into shore power, from solar sources if you want to go that way, or while the generator is running. And, you will have way more battery capacity for extended off grid stays than you have now.

    Jerry

  • Dick

    Member
    May 6, 2021 at 11:17 am in reply to: Air leak when in gear only

    well you guessed it .. he has a appointment at 12pst … at loves truck stop in lodi California..

  • Dick

    Member
    May 5, 2021 at 9:34 am in reply to: Trailing axle

    That’s what the mechanic says. He said lifting

    the tag axle will let it slide rather than drag

    with the pressure on the tag axle. I mean I

    don’t often get in tight spaces but at some truck stops

    I have a couple times. Thanks for the information!

  • Dick

    Member
    May 5, 2021 at 9:29 am in reply to: Trailing axle

    I always lift for any turn that is remotely taxing on the tags. I also have changed my policy on tag axle tire pressures. I used to run relatively low tag tire pressures (90 psi) working off the Michelin tire pressure charts and axle loads. I have gone back to 105 psi on the tags to match my steer axle. Some people do that so they can swap tags to steers if they need to. My stance is……If I need to do that swap, I’m not doing that work and will have whoever is check the pressures. Worst case, I have an air hose and air doubler onboard and can make whatever pressure change I need to…….

  • Dick

    Member
    May 3, 2021 at 6:31 pm in reply to: New to Forum: Considering ‘89 Le Mirage Liberty

    I had a 89.. 5mpg ..As far as diy people(me) I wish I had a liberty! $$ says otherwise. Besides I’m a builder and that is a good part of ownership. 40ft and year is a plus..$$ need to be considered. I prefer a 60series coach. Also miles on coach?? Is 6-V92 a transplant? Bob

  • Dick

    Member
    May 3, 2021 at 4:53 pm in reply to: New to Forum: Considering ‘89 Le Mirage Liberty

    I had a 1987 Liberty conversion as our first coach. When we bought it the mileage was 42,000 so it was almost new and unmodified. It had a 475 HP 8V82 and for the 15 years I owned it my mileage was 5.6 MPG.

    The gearing was such that my top speed was 69-70 MPH. I could get up to about 72 with a good long downhill run with the wind at my back.

    I learned quickly to drive it at 1800 RPM which was pretty close to 60 MPH. Trying to drive faster was a recipe for trouble. If we needed to pass someone when driving faster I was at my max speed and if the person being passed sped up even a little, I was hung out to dry. I found out how relaxing it was to be one of the slowest on the road. I rarely had to get off the cruise control because everybody was going faster. It was actually enjoyable putting my type A personality in storage for a while.

  • Dick

    Member
    May 2, 2021 at 10:31 pm in reply to: Recommendations for RV Campgrounds in Phoenix area

    We won’t be in Phoenix until September. Have a long time to over research all the suggestions – LOL

  • Dick

    Member
    May 2, 2021 at 8:27 pm in reply to: Two Hose Clamps Not Always Better than One!

    Jeff

    How about finding a shop to form a bead on the cooper tube to stop the hose from slipping and as well as not requiring 2 hose clamps. A radiator shop would have a bead forming tool.

  • Dick

    Member
    May 2, 2021 at 4:35 pm in reply to: Fuel gauge not reading

    I agree with Al. Perhaps it is from flying when endurance was based on hours, with the bus being similar in using miles to determine endurance. I do have one unknown in the bus, and that is how many usable gallons the bus really holds.

    My practice has always been to use the total miles driven and total fuel purchased for every year to determine mileage. Prior to the failure of my EGR system every year consistently I was getting 5.9 MPG. When the EGR system stopped working my mileage was a steady 6.5 MPG every year. I have not bothered to try to isolate the fuel used by the Webasto or generator since my use of them seems to follow the same pattern every year and neither of them uses a whole lot of fuel each year.

    My listed fuel capacity is 208 gallons. My preference is to avoid truck stops so I created a personal window for refueling between 700 miles and 1000. When I have opted to put 1000 miles on before refueling my fuel gauge shows the needle near or at the bottom. The most I have ever taken on is 174 gallons and when I did refuel the needle indicate the tank was dry and I never got a low fuel warning. If our 208 gallon capacity is a true indication of how many usable gallons I carry I had 34 gallons in reserve. If my true volume of fuel is 90% of that I had about 13 gallons in reserve.

    I am not going to run the tank dry to find out. I know from experience the OTR air tends to drop the mileage, as does towing, especially when the toad is a Hummer so I will not tend to push my limits and if my gut suggests a 900 mile limit due to headwinds or mountainous terrain I will stay on the low side of my fuel range for getting fuel.

  • Dick

    Member
    April 30, 2021 at 2:23 pm in reply to: You read it here

    PC is no longer going to function as a middleman in the collection of dues. Effective immediately send dues directly to Jon. Current address is the Poor House, Knoxville, TN 37914.

    Non-Prevost members must pay double according to the new dues schedule.

  • Dick

    Member
    April 30, 2021 at 12:00 pm in reply to: You read it here

    Jeff, yes, I sold it back to Liberty. I’ll miss’m…. fine folks.

    Mark

  • Dick

    Member
    April 29, 2021 at 7:21 pm in reply to: You read it here

    Congrats Mark! You will still be in one of the safest RVs on the road! Please report back on how the change is working out. But…why didnt the group get a chance to give input on the design choices this time? 🙂 jeff

Page 27 of 214