Forum Replies Created

Page 155 of 214
  • Dick

    Member
    February 1, 2016 at 3:24 pm in reply to: Prevost Bra

    Usually the converter can provide a bra. I assume the coach has the snaps on it so it almost requires the converter to make the bra so the snap locations are matched.

  • Dick

    Member
    January 31, 2016 at 1:20 pm in reply to: Know Your Prevost Seminar 3

    Thanks Tom. Looking forward to the seminar.

  • Dick

    Member
    January 30, 2016 at 8:18 pm in reply to: PC/Parliament Air & Coach Concours Winter AutoFest

    Can’t do it unless you can find a rental and then provide a rider with proof of insurance adding Carlisle Events on their policy. Owners with golf carts can bring them subject to the above.

    Rent scooters, but do it soon, they run out. BA has two rented so he can tell you who to call.

  • Dick

    Member
    January 30, 2016 at 7:13 pm in reply to: XLll head light problems may be solved

    Push the very end of the signal light stick the little round button on end and it will flash your marker lights

  • Dick

    Member
    January 30, 2016 at 4:39 pm in reply to: PC/Parliament Air & Coach Concours Winter AutoFest

    I think I know the answer but….looking at the map layout and guidelines I don’t see any reference to golf cart rentals. I think that means they are not allowed or not needed. Is that correct?

    Electric scooters are allowed for those who need them and are for rent.

    I know some OLDER individuals may need a CRIKET (Jon??) and I fully understand that too.

    Just want to make sure if we might need/want a golf cart, are they allowed and if so how is one rented.

  • Dick

    Member
    January 30, 2016 at 10:32 am in reply to: 30AMP Service

    The manual is correct. The 50A service is really 2x50A since it uses the 240V split phase. The 30A is really only 30A. With the 50A plug you can draw 240Vx50A=12000W; with the 30A plug you can draw only 30Ax120V=3,600W.

    On a 30A plug both inverters have to share 30A.

    Gerald

  • Dick

    Member
    January 29, 2016 at 2:51 pm in reply to: Holding Tank Odor in Coach

    I would assume these under the sink vents are one way valves to allow air to enter the system and on exit. So the tube to the roof is really your exhaust and the under the sink valve should prevent a negative pressure on the system. But I have been wrong before. Just doesn’t make sense that air would be vented out under the sink. Defeats the purpose of the water trap.

  • Dick

    Member
    January 29, 2016 at 2:28 pm in reply to: Catastrophic Awning Failure

    Thanks

    i’ll try when I get it.

    Greg

  • Dick

    Member
    January 29, 2016 at 9:33 am in reply to: wiring

    Thanks Guys.

  • Dick

    Member
    January 29, 2016 at 8:43 am in reply to: Catastrophic Awning Failure

    I also had a kit on an XL and it worked great, eliminating the need for the extension pole or ladder.

  • Dick

    Member
    January 29, 2016 at 7:48 am in reply to: wiring

    Thanks Peter for the help. Will do. I know the previous owner towed and I did also with an ford edge after I bought in 2011. Gonna check wiring after we get home after the trip to see grandaughter. On the bright side , the wife will behind me for 200 miles today and not fussing bout my driving or my 14 year old great dane dog. He a gasser.

  • Dick

    Member
    January 27, 2016 at 10:11 pm in reply to: Holding Tank Odor in Coach

    I agree – I wish they just vented everything to the roof and put a 1-way valve up there. That wasy you couldn’t blow out the P-traps. I also think that becuase of the problems with air pressure, the P-traps should be 2 feet tall instead of the normal house version that is only a couple of inches. Hmmm…. I wonder if I could retrofit that up….

    Frankly the fact that there are odor problems at all in these busses is ridiculous. All that money and R&D spent on electronic doodads instead of a little thought put into how to make sure the bus doesn’t smell like a sewer.

    I suppose I get it…. electronics, TV’s, and Accent lights sell. Guarantee of no smell probably doesn’t.

    Walt

  • Dick

    Member
    January 27, 2016 at 12:04 pm in reply to: Catastrophic Awning Failure

    I too have one of those air/electric ZipDee’s. I’ve seen it opened only once, when Jeff Rowe did the pre-purchase inspection. My wife has asked about opening it up from time to time and I’ve told her since I’ve heard those things can be so unreliable and prone to locking themselves wide open at the most inopportune time … the time I’ll open it is (1) at ETLC, (2) at home, more than two weeks before a trip, and (3) only on the road if I have a SawZall in the coach with a new box of blades and a good ladder.

    I sniffed at a coach (1998 Liberty Classic Lady) which had no big awning on the curb side. Seller said it came unhooked or loose on the Interstate while traveling between Memphis and Alberta and its in the ditch somewhere along that path. I called Zip-Dee and was quoted about $2,500 for their longest manual awning (23′ or 24′, can’t remember). Woman on the phone said they should be able to match the fabric of the other awnings if Liberty can provide the original order information.

    Liberty (North Chicago) and Zip Dee (Elk Grove Village) are only 35 miles apart. You might be able to get Liberty to do the removal and install. Check with Bill Doherty at Liberty.

    Tom & Bill wrote: “after many many issues, fights, language not suitable for the public, we ripped that SOB off and installed a manual Zip Dee.”

    Exactly my fear.

  • Dick

    Member
    January 27, 2016 at 11:57 am in reply to: Catastrophic Awning Failure

    Charles,

    I cannot tell what kind of awning you have currently but I will tell you when we had our Foretravel, we had the Zip Dee Auto Awning and after many many issues, fights, language not suitable for the public, we ripped that SOB off and installed a manual Zip Dee. Never had a problem or fight after that.It was a fairly easy change out, some paint repair and we were good to go.

  • Dick

    Member
    January 26, 2016 at 3:04 pm in reply to: 12V Webasto Heat problem

    Hi All,

    I was able to talk to Leon at marathon for a bit this morning. And we went over this and the entry light. Figuring I needed cheaper heat (our last electric bill went up by 400 from the heat pumps) I’m working on this first. But now I’m sitting in a waiting room so figured I’d post an update.

    Leon said there was a pump at the Webasto and a pump in the front compartment. Sounds like 2 pumps total. I knew the front pump wasn’t working – but also didn’t really know that it was part of the Webasto heat System.

    Leon said that the pumps are controlled by a relay that was in the back closet or engine control box. Mine was in the master closet. it is relay rdp – but mine isn’t labeled anymore. Making it easier to find.

    Anyway there was no input voltage to the coil of the relay so to test if this was the problem I re plugged the relay to the normal closed configuration and viola! Heat works (yay!) but now to find the root of the problem.

    Chased the coil input wire up to a techlink relay module and the module clicks and the signal light is on but there is no power at the connector out of the module.

    So so that’s why the heat didn’t work – the input power to the relay has failed. Someone was on the right track and changed the black cube style relay – but that didn’t fix it.

    I emailed marathon the progress and asked what to do when the techlink relay isn’t outputting voltage – will post when I solve this.

    Thanks is for all the info and pointers – getting close on this one.

    walt

Page 155 of 214