Forum Replies Created

Page 56 of 2304
  • Archived

    Member
    July 14, 2021 at 3:02 pm in reply to: Paint Codes

    IIRC Prevost was painting the shells in Quebec back in those days.

  • Archived

    Member
    July 14, 2021 at 2:38 pm in reply to: Is it true never a fatality on a prevost…9

    I doubt if over the millions of accumulated miles Prevost conversions have been driven that there was never a fatality. But I have seen accidents of conventional RVs such as Dick shows above and do know it is common for the upper portion to separate from the chassis which does leave the occupants in an unprotected situation.

    A Prevost chassis will remain intact as has been seen in numerous news reports of accidents relating to seated coaches and entertainer coaches but there is not a lot of protection for the driver or front passenger in a head on collision or a collision with something solid like a bridge abutment.

  • Archived

    Member
    July 14, 2021 at 2:03 pm in reply to: Sudden gen power lose

    I’ve replaced a couple voltage regulators on my Kohler and discovered the fan that ventilates the air in the generator compartment was not functioning. Generator engine will not overheat because it is cooled by an outside water source but the powerhead and electronics will and they give no warning. I now check operation of the vent fan at every gen oil change.

  • Archived

    Member
    July 13, 2021 at 5:40 pm in reply to: Wrong Phone Number

    Hey John it was me! Lol! I might have mixed it up! I’m not up on my Morse code!!

  • Archived

    Member
    July 13, 2021 at 9:52 am in reply to: Auto overFill

    To Badfitter,

    If your valve isn’t closing all the way or takes too much time to close then your valve may be getting clogged up with calcium. Most solenoid valves can be taken apart and cleaned. You may have calcium built up around the diaphragm or plugging the pin hole that allows water to seep above the diaphragm which forces it closed. (Just be sure to get the springs back in the right way).

  • Archived

    Member
    July 12, 2021 at 2:30 pm in reply to: Stranded in Cody,WY Transmission/electrical

    Bernie! Would it be possible for him to give you a call and ask you a few questions?

    If that’s alright text or email me a number and I’ll pass it on.

    Thanks

  • Archived

    Member
    July 12, 2021 at 8:41 am in reply to: Wrong Phone Number

    I’ll swear Jon you are in the Rodney Dangerfield club, just don’t get any respect !

  • Archived

    Member
    July 12, 2021 at 8:39 am in reply to: Wrong Phone Number

    Jon:

    A smart phone can open your garage door…

    Chuck

  • Archived

    Member
    July 11, 2021 at 4:43 pm in reply to: Soundown in generator bay installing screws

    If I need to run a screw through something that may catch and bind on a screw I open a hole in the material by heating up a steel rod or phillips screw driver to melt a hole that will be open for the screw.

  • Archived

    Member
    July 11, 2021 at 3:31 pm in reply to: Petoskey

    Hello Jeff; We have missed Petoskey for the passed couple seasons but intend to

    make it this year 2021. Looking at the forum now it looks like my wife and I maybe

    alone, let me know if I am right or wrong. We are going to make our reservations

    and hope for the best. Thanks Fred & Judy

  • Archived

    Member
    July 10, 2021 at 10:07 pm in reply to: Exhaust heat blanket

    Reason for heat blanket is to control temp in the engine compartment. It belongs on exhaust tubes and should be replaced if missing.

    AL

  • Archived

    Member
    July 10, 2021 at 6:19 pm in reply to: Engine tuner

    on the ISL engine PDI hook up there laptop computer and played. Yes more horse power and a lot of heat, no better fuel consumption.

    Also EPA had a huge fine on them for there modification, do not know how that with down.

    Larry Nelson

    2002 XLII Vision

    2019 Buick Envision

    Hurricane, UT

  • Archived

    Member
    July 10, 2021 at 6:11 pm in reply to: Engine tuner

    on the ISL engine PDI hook up there laptop computer and played. Yes more horse power and a lot of heat, no better fuel consumption.

    Also EPA had a huge fine on them for there modification, do not know how that with down.

    Larry Nelson

    2002 XLII Vision

    2019 Buick Envision

    Hurricane, UT

  • Archived

    Member
    July 10, 2021 at 9:19 am in reply to: Magnum inverter experience anyone?

    Just to note if you switch to Magnum. They use a standard phone RJ-12 jack 4 wire for the panel. Don’t waste money and time running a new cable unless you really want to or it’s fairly easy. Just cut the Xantrex connector off, choose 4 wires and crimp a phone jack on. The manual for the panel shows how to make the cable.

    I’ve done it several times on replacement inverters and never had an issue. I always gave my customers the option, but it would save them $$$.

  • Archived

    Member
    July 10, 2021 at 3:59 am in reply to: Allison Transynd is the Way to Go!

    Great tip,

    Thanks Jon!

Page 56 of 2304