Archived
Forum Replies Created
-
Sawdust, thanks for the drawing, it made me think, WHAT DID I BUY THE PARTS MANUAL FOR MY BUS FOR? and for the exhaust tape idea, I’ll look for some.
Ken, I wished you had made that post two weeks ago when I was putting this project together, the items you have are all the things I need, but I don’t know if it would have worked, a million dollars is quite a bit 🙂
-
Header wrap tape good to 2000 degrees like
If you are going to fab up straps, make them wide enough to cover the wrap or, spiral wrap it to get the thickness that you need and secure the end with the locking ties ( part DEI 010202 )
-
That is close to what I had in mind, since there is 4 angle iron brackets welded in the location of the muffler. I will be making the metal bands to attach to the angle brackets.
Question; what material would work for the insulation between the bands and the muffler? Something that is 1″ wide by 1/16 or 1/8″ thick.
-
Based on the picture of your charged settings you have a 24 volt
system. That means your cabling will be series/parallel and if there
are any 12 volt leads from the battery bank you will have an
equalizer that must have the ground cable unhooked before you do
anything.Caution – You could easily harm yourself or destroy your new “no
name” batteries by a cable or connection error. If you have any
doubt, get qualified experienced help. I’m reluctant to offer any advice since
I have no experience with Vantare. -
Hey DaleJ…I will look at it tomarrow. I am about to replace mine and have talked with a couple mechanics at home that will do the Prevost thing for me, or they say they have a couple possible ideas using truck style mufflers ( I am like you, I would prefer to quiet it down if anything) but I have not decided yet. Should have probably done it when I did the radiator, but it was not “ready” to do at that time.
-
“DKO, what brand of AGM did you purchase. The recommendation is always to ask the battery manufacture for there charging specs. If you state your “brand” we can find your specs for the Trace SW4024 setup.“
I purchased batteries from a regional dealer that has his own brand. I believe the same company that makes Interstate makes his batteries. He is a friend of a friend. I can call him and ask him the charging specs. What specifically do I ask?“The manual switch you pictured would seem to eliminate AC voltage to the inverter/charger. Even if you can eliminate 110VAC input to the charger and bypass it, some items like air conditioners may not. Many thermostats run off of 12VDC from the batteries. “
That makes sense to me and brings it into focus. I will turn it all off and eliminate any chance of damage.
“Your converter should didn’t do you any favors with battery access. Be careful with the weight of these beast and make sure you disconnect negative terminals first and reconnect positive battery terminals first. This eliminates the tool welding that can occur if your wrench hits any grounded part of the coach when removing and replacing terminal cables.“
You are right. It looks impossible to remove the two that are by themselves. I have been studying it this evening and I am no closer to a solution. I know to remove the negative first and I can certainly do that with the six batteries in the rack. I will not be able to touch the connections on the other two until the six in the rack are removed. I can not even see those batteries clearly until the others are removed.
Thanks for all the information…
DKO
-
I do have the inverter manuals so I will work on learning how to reprogram the inverters before I make the battery change.
DKO
-
Jon is correct…
On our Vantare we switched off all the breakers in the electrical panel inside the bus first and then powered down the inverters. (I noticed in your pictures your inverters are the same as ours) Then turn off the outside inverter breakers and UNPLUG the shore power.We do not have a battery cut off switch. I even switched the Generator off outside. Then verify that you have NO power anywhere…. then do as Jon said.
Our Vantare is figured a little differently from other converters in that everything goes through the inverters.
After new install you will have to program your inverters again.
When you power everything back up you can turn on your breakers on the inside panel again after you verify your incoming power is correct.
Like I said the Vantare setup is a little different from other converters.
Hope it all goes well for you.
-
I need to shut down everything even if I can bypass the inverters with a switch?
Not doubting you just trying to make sure. Since we live and work in this thing and it will be 100 next week I would love to keep the power on for the air. This is liable to take me several hours.
If shutting everything off is inevitable then you advised, “ Do the shut down according to the procedures your converter has outlined..” Although the previous owners seemed to keep every scrap of paper I have NOTHING from Vantare about anything.
Other than that your directions are clear. I can turn off each inverter. I also have a breaker type switch to each inverter. And I have a main breaker where the shore power comes into the coach.I won’t do it this time but when the next battery change comes around 5 years or so from now I hope to know enough about this to simplify this system. I never dry camp so all I need inverters for is to keep the fridge and a few electrical outlets for computers and chargers while moving down the road. Seems to me I ought to be able to go down to a lot less batteries and maybe even one inverter. I know there is resale to think about but I am planning on keeping this bus long term.
Thanks again for your help.
DKO
-
Well done. Now don’t forget to make notes and label stuff so the next owner knows what and why.
Very professional looking.
-
Mission Accomplished!
It was very easy to punch the hole I needed using the Greenlee punches. I was realy quit suprised how thin the bay door skins are on an XLII. Thanks everyone for the input. Pictures of the final product below.
-
I’m surprised it has taken youz guys this long to realize that at the rate the fed is printing money a bag of charcoal has a greater value.
-
If you haven’t read the episodes of Boxcarokie on PUP, your missing a laugh…
-
Sawdust, that looks familiar. Where did you find one of those? The last time I saw one I think Jon was burning them to start a BBQ…