Forum Replies Created

Page 2225 of 2304
  • Archived

    Member
    June 26, 2012 at 12:54 pm in reply to: How to overload the Cruise Airs

    I have over the road air. I don’t need fans. I need sweatshirts.

    You guys knew that was coming, right?

    The problem with the Cruise Airs is when the intake air temp for the condensing unit is very hot, such as that radiating from the highway then the condenser just fails to function as intended. Jim Schoen added misters to his Cruise Air condensers, with the mist controlled by a pressure switch he installed on the condenser. When the internal pressures get up to a certain value that he determined by trial and error, the condensing coil gets a spray mist which brings the pressures down and allowes the Cruise Airs to function well. His water supply is the fresh water from the coach.

    If your coach does not have Prevost OTR air, you may have to have roof air units which will function on hot days.

  • Archived

    Member
    June 26, 2012 at 10:47 am in reply to: OEM muffler?

    sawdust,

    what should or shouldn’t I do? splash guard, is that the pan under the muffler?

    I couldn’t get the link above to open, do you have a brand of paint? or part number?

  • Archived

    Member
    June 26, 2012 at 9:36 am in reply to: OEM muffler?

    Jon, here are some photos of the project. You can see in the before that there is only almost 9″ of space between the brackets. That is why I had to bend them out to get the muffler in place. My plan is to use heat and bend them 90 degrees out, so I can get the muffler in and out more easy.

    I don’t know if I have a factory setup now since I bought the bus used and it has always had a resonator in place.

    Question for now, I was planning that the position of the bottom of the muffler be at a point equal to the bottom of the frame.

  • Archived

    Member
    June 26, 2012 at 8:04 am in reply to: Florida Coach Purchase Inspection

    Contact Rick May at Coachworx. They are located in Clearwater by the airport. All the folks are very good and straight shooters. Would highly recommend them, they do all my work. DonS

  • Archived

    Member
    June 26, 2012 at 6:18 am in reply to: Polishing/Waxing

    THANKS!

    I checked out the link, don’t really understand how it works exactly, but I had never heard of it before.

    BCO

  • Archived

    Member
    June 25, 2012 at 9:43 pm in reply to: Florida Coach Purchase Inspection

    Thanks, I am from Kelowna, British Columbia, Canada. You will have to enlighten me on JAX. Great PDI sheet. Thank you.

    Jim

  • Archived

    Member
    June 25, 2012 at 8:44 pm in reply to: Florida Coach Purchase Inspection

    Exciting….. can’t wait to get another Marathon on our side. The Liberty guys were on a runaway train for awhile.

    I’ve had work done at Marathon Service Center in San A. Great crew, your in good hands.

    Sorry Tuck4u, not a repair, just a battery replacement on the generator was found to be the problem.

  • Archived

    Member
    June 25, 2012 at 8:35 pm in reply to: How to overload the Cruise Airs

    Roger,

    That must have been miserable, nothing worse then the heat with a bus load when you can’t get it cooled down. I hate to be the bearer of bad news, but every one I have had with cruiseairs would shut down in extreme heat from the highway. I like the cruiseairs, but hate the failure due to road heat.

    Hope you keep them running for the rest of your trip and I think early departure is the answer. Our forcast for late this week in N Georgia is 99 degree’s…

  • Archived

    Member
    June 25, 2012 at 8:23 pm in reply to: Florida Coach Purchase Inspection

    Jim,

    In my opinion, your best bet would be Marathon in San Antonio, FL, not far north of Tampa. They built it and a PDI from them or Prevost Jax would be a good way to go. Take a look at the PDI article Jon did here on our site at: PDI


    If you need anything specific, just let us know, you will get lots of help.


  • Archived

    Member
    June 25, 2012 at 8:15 pm in reply to: Polishing/Waxing

    Sam,

    You bought the best pre-loved Liberty in the county and if the
    interior setup had been to our preference, it would have never been
    on the market. It looks fantastic and I doubt it could have found
    a better home. Be sure to look in the safe, it has a false bottom and
    you may find some gold. Jon can’t remember and the last time he
    looked, he found one of his prized possessions, an 8 track tape of
    Bobby Darin, his favorite song being Mack the Knife.

    Keep digging in the all the compartments, you’ll find treasure.

    PS – Glad your on the site and hope we can meet you one day. I
    have stories for you!

  • Archived

    Member
    June 25, 2012 at 8:06 pm in reply to: OEM muffler?

    DaleJ ……. sorry about the late reply. We are enroute home with some “Extras”, grandkids/Adult in bus and experiencing some “shoulda knowns” with AC cooling in this 105-108 temp in Kansas…..My muffler looks just like the schematic shown in the posting. That said, When (read if) we get home from Salina in the next day or so, I will get with my mech and show him. Sounds like you are going ahead with the project. He mentioned that he did not see any problem with the brackets, etc mentioning that he would use all new piping up to the turbo and that we would give that a close look at the same time. Good luck, sorry I got into this predicament, but, what the H, its all fun of some sort.

  • Archived

    Member
    June 25, 2012 at 8:00 pm in reply to: Installing New House Batteries

    DKO,

    I hope you get good service out of the Deka’s and I’m sure you bought them right. I didn’t have much success out of the 8D’s I had, they failed before 3 years and were maintained properly. Check the warranty, it’s either 12 or 24 months.

    Some try to compare Deka’s with Liflelines and it is not apples to apples. I’m obviously biased towards Lifeline and the 5 year warranty is a proven benefit. I have handled one 6v battery warranty in the years I have been dealing with them. One of our fellow Prevost owners was having trouble with his Lifelines and much to his surprise, we discovered he had purchased old stock 3 years prior by a less than honest repair facitlity that I won’t name. I got Lifeline involved and they sent him 6 new 8D’s, at no cost. It wasn’t their fault, but they stepped up anyway.

    I hope your installation goes well.

  • Archived

    Member
    June 25, 2012 at 5:49 pm in reply to: Installing New House Batteries

    That is a good link and the charging specs are near the end. They are very explicit. Unless you have a temperature sensor I would go with the 80 degree charging voltages and stay to the low side.

    Just a comment not to be confused with criticizm of Deka or a sales pitch for Lifeline. On another site a long time ago there was a discussion of one manufacturer’s battery versus another. The concensus was the Deka is a lighter battery in weight versus the Lifeline and the owners who reported seemed to agree they averaged about a year longer service life with the Lifeline. In another discussion lead acid batteries were discussed as having the greatest tolerance for abuse, possibly the longest life if maintained, but the time required to properly maintain them (adding water as required) outweighed any benefits.

    Regardless of the batteries selected, charging them exactly as called for by the manufacturer, and limiting the depth of discharge had the greatest beneficial impact on their life. The point being, if you rely on generator autostart, when you program the inverters, if they control the generator start use a 50% discharge rather than going deeper such as 80%.

  • Archived

    Member
    June 25, 2012 at 5:37 pm in reply to: OEM muffler?

    Dale,

    Something doesn’t jive. I replaced mine on my 87 and while I am fuzzy on the details (hence have not added to the discussion) I do remember I replaced it from the bottom as you are doing and there was nothing that prevented me from doing it. I do remember I replaced the pipe going into it at the same time and the hardest part of the entire job was getting the pipe(s) going into the muffler in place. I certainly did not have to cut off any brackets, or modify any.

  • Archived

    Member
    June 25, 2012 at 4:36 pm in reply to: Installing New House Batteries

    I heard back from the distributor this afternoon concerning the charging specs. They do not have a clue. They have a large network of dealers but harldy ever sell AGM batteries. He said their AGMs are Deka batteries by East Penn.

    I looked up Deka AGMs and every one I found is black on the side. These new ones I have are gray on the side like the Lifelines that I am replacing. Should I call them back? Does Deka make a 4D AGM that is gray?

    Never mind…. I found gray ones online…

    Can the charging specs be found with this information?

    I was beginning to feel like I could do this….

    Here is a LINK to a pdf about their AGMs

    DKO

Page 2225 of 2304