Forum Replies Created

Page 2223 of 2304
  • Archived

    Member
    June 29, 2012 at 11:29 pm in reply to: Suggestions for Places to Park in ND, SD, WY or MT

    Thanks, Tom. Went to the website. That is a nice place!

    DKO

  • Archived

    Member
    June 29, 2012 at 10:53 pm in reply to: Erratic Gauge Readings

    Thanks Tom. Yes I have a diskless computer and it lives where the Bose amplifier is behind the driver’s seat. Access to my computer must be a bit different than yours. I can remove the end facing the center of the bus and remove the computer. Although the computer is the heart of the system, tracing the arteries that feed it is a bit of a challenge. CC had to translate the analog systems to something the computer would understand. In this case it appears they may have translated them to serial data. I have discovered where the device is that translates air pressure. What I haven’t found is where it’s getting it’s voltage reading.


    I’ve traded a couple of emails with Nick. He’s a bit busy right now but will look for the wiring diagram when he gets a chance.

    I have Silver Leaf’s VMSpc from my last coach. I was going to hook it up to see which readings are supplied directly over tghe bus used by Detroit, Allison, and possibly Prevost. Unfortuantely, I have the wrong connector. Silver Leaf is sending the right one to Alaska for me to use when I get there.

    Did you install a Silver Leaf Glass Dash? If so, can you tell me what was involved and who did it? I’ll still need a translator for anything not on the communications bus or move those things to dedicated guages, which is not my preference.

    Thanks again,

  • Archived

    Member
    June 29, 2012 at 6:14 pm in reply to: Stop engine and check engine lights coming on

    Epilogue………

    Finally picked up my coach today… two and a half weeks…..He told me they are short staffed.

    This time some funny things were going on that never happened before.

    Power driver and co pilot seats inop, TV camera inop, bus air inop (fan worked), air horn inop, step well inop and maybe a few more pneumatic devices that I didn’t check.

    Then, I fired up the generator and in a couple of minutes all of the above (with the exception of the warm bus air) came to life!

    ???????

  • Archived

    Member
    June 29, 2012 at 12:25 pm in reply to: OEM muffler?

    I can’t believe that I’m having Jan bake my exhaust parts in her kitchen! It’s hot in there, I’m going back outside where it’s only 90 something with 50 % humidity. 🙂

    Should be putting it all back together soon and I’ll post some photos.

  • Archived

    Member
    June 29, 2012 at 6:42 am in reply to: Suggestions for Places to Park in ND, SD, WY or MT

    Elkhorn Ridge in Spearfish, SD is the place to stay. Elkhorn

  • Archived

    Member
    June 29, 2012 at 6:26 am in reply to: Florida Coach Purchase Inspection

    Just to put an exclamation point on what Sam said……………..

    When we picked up our current coach from Liberty we planned on staying as long as necessary to learn the coach so we were not like a deer in the headlights when we needed to do something. Put this in perspective. We owned 2 Liberty coaches prior to buying our third current one. Despite the fact we were familiar with the systems and that I had done my own work on the coaches for 22 years, I felt we still needed trainng on the new coach.

    We spend two intense days learning all the stuff that was new to us at Liberty. When Troy wasn’t feeding us information we were putting our learning into practice ourselves so we could know what we had learned and also know what we needed more training on. Any coach of any vintage is a complex assembly of systems and most of the operation of the coach is basic, but every coach has its “secrets” that a new owner has to know and understand.

    There is no substitute for training. I will guarantee a new owner will get in trouble sooner rather than later if his traiining is finding the key. While sites like this one are a great source for information to help owners in trouble the best option is to get the training and avoid the trouble. That training also becomes the coach inspection if done properly.

  • Archived

    Member
    June 28, 2012 at 10:48 pm in reply to: How to overload the Cruise Airs

    That sounds like you got a good deal… huge job… glad you had 4 put in too… I am surprised when I hear of 45 footers with 3 rooftops staying cool when its over 100 outside… I can see 4 cooling properly…. glad you are happy and cool.

    Diane

  • Archived

    Member
    June 28, 2012 at 10:06 pm in reply to: Polishing/Waxing

    Detailing the outside of a 45′ bus is not for the faint of heart.

    I spent 4 hours on the front. I am almost finished with the starboard side, and it will end up taking 5 hours. The back end will probably “only” take about 2.5 hours, as it has never had to endure bugs head on at 62 miles per hour (Jon’s maximum bus speed…). The roof will take another 5-6 hours, as will the port side. But once I am done (about 20-24 hours total), it will be pristine, and all I will do from then on is wash it as needed with Zaino soap, and perhaps do an 8-10 hour Zaino overcoat every couple of years. I have a Flex dual action random polisher (http://www.autogeek.net/flex-orbital-polisher.html) that I use on my cars, but I didn’t have the guts to use it yet on the Liberty, so I have done it all by hand. I have no doubt that using the random orbital buffer would cut the time by at least 50%, but I have never worked on a stainless finish, so I was a little too nervous to use the buffer. Perhaps I’ll try it on the roof.

    By the way Jon, I will not continue polishing the slack adjusters. They will just have to get dirty and dull from this point forward! I will keep the copper polished, however….

    Finally, it would take a huge barter to talk me into detailing the outside of Larry and Diane’s bus (or anyone else’s)!

    If anyone is not familiar with Zaino, it is the best. I have used about everything else out there, and there is no comparison for results or longevity of the products.

  • Archived

    Member
    June 28, 2012 at 4:17 pm in reply to: Polishing/Waxing

    That’s good to know, thank you. I’ll check with Liberty and see what they say.

  • Archived

    Member
    June 28, 2012 at 3:54 pm in reply to: Maintenance bulletin Mi97-24 Prevost Question

    “Or you could move this forum inside your coach. There is a lot of hot air here…….”


    I think you are in the wrong forum, wouldn’t a discussion of the “blast-o-gas fuel cell” be more appropriate in the Electrical forum?

    ……………. and thanks.

  • Archived

    Member
    June 28, 2012 at 3:23 pm in reply to: How to overload the Cruise Airs

    I bet that was a big job adding roof airs…. wow… hard to imagine all the duct work and wiring involved… you are a brave man! Your cruise airs were great units and very fixable and also very quiet & efficient. We have redone our entire a/c system as in all new compressors etc and it was a worthwhile investment they are so very efficient & very quiet…


    It was a big job but a friend sent me to a entertainer converter and they needed the work badly. They added four roof airs in 2009 for an excellent price. They told me when I picked it up that they had definitley taken the job way too cheap but they were happy to keep a couple of their employees busy.

    My experience with the cruise airs was very poor. My 45 ft. XL had only three and we were never cool enough. Temps above 90 made for miserable afternoons. I told my wife I was not going to pay the money I did for this bus and melt every summer. Not when I could freeze in my old fifth wheel for a fraction of the cost.

    All three were nearly completely inaccessable as far as working on them was concerened. I have since seen a bus at Prevost Nashville that all of the outside units slid out for easy maintenance. I am sure that would make a difference. Two of the inside A coils are buried so deep behind the cabinets that I still have not laid eyes on them.

    I plan to keep this bus for the duration but if I was trading I would not even consider one with cruise airs. That is just my experience but I am glad that others have had better luck.

    DKO

  • Archived

    Member
    June 28, 2012 at 2:57 pm in reply to: Installing New House Batteries

    Thanks much. That picture of the dog is hilarious!

    I fastened everything up this morning and moved on to a trailer project. I am glad to have this behind me.

    One more interesting note. I was on the phone with Ed today and he was walking me throught the settings on my inverters to double check everything. I have two 4024 inverters. One is original and one was replaced by a previous owner in 2004. We discovered that the default settings were different in several areas. The original inverter settings matched the paper work that I have exactly. The newer inverter matched the updated settings in almost every area that Ed uses in his coach. They both have the same software…

    I am glad we checked.

    Thanks again,

    DKO

  • Archived

    Member
    June 28, 2012 at 12:36 pm in reply to: How to overload the Cruise Airs

    Have 3 cruise airs and 1 froze up (front) a week ago at the beach. Got home called my mechanic and he checked and found it low on freon. He told me it doesn’t take much pressure loss to start that problem. You might check there first.

  • Archived

    Member
    June 28, 2012 at 11:36 am in reply to: Maintenance bulletin Mi97-24 Prevost Question

    Thank you.

    If I use the full A/C system and open the evaporator door, how do I set the fresh/recycle air switch, open or closed?

  • Archived

    Member
    June 28, 2012 at 10:13 am in reply to: How to overload the Cruise Airs

    I bet that was a big job adding roof airs…. wow… hard to imagine all the duct work and wiring involved… you are a brave man! Your cruise airs were great units and very fixable and also very quiet & efficient. We have redone our entire a/c system as in all new compressors etc and it was a worthwhile investment they are so very efficient & very quiet… but not always highway friendly… guess that’s why the invented over the road air !!. We had a 45′ 4 slide plastic coach with 3 roof airs and they were horribly noisy and no way could they keep the bus cool in peak of the Texas summers and were worse when we were running down the highways when it was very hot… they were always freezing up and tripping inside breakers… and they were new (in 2005) too… they may be improved since that time. Of course the insulation factors and differences in plastic coaches and a Prevost are not apples to apples either… but I would choose cruise airs over roof units any day… just my personal preference… plus having experience with them in our boats made believers out of us too!

Page 2223 of 2304