Forum Replies Created

Page 2222 of 2304
  • Archived

    Member
    June 30, 2012 at 8:06 pm in reply to: Message center display and gauges not working

    Thank you, I have been done that road with no success. I have recently also found out the backup alarm isn’t working either. I am going on the assumption that these are all on the same feed. Guess I’ll be calling Prevost on Monday.

  • Archived

    Member
    June 30, 2012 at 4:44 pm in reply to: Stop engine and check engine lights coming on

    “A couple of comments about shutting down house DC
    power to protect batteries. There is a specific procedure and it
    requires the inverter to be shut down first, then as a precaution shut
    off the 120V supply to the inverters. Then it is safe to shut down the
    house”

    There is a small compartment on the outside near the engine with the 2 shut down handles. one is marked 12V the other is 24V. So I should shut down the inverters from the wall panel inside the coach first, then the main switch (in the inverter bay), then the 12V, and then the 24V for long term unplugged storage (like a week or so)?.

  • Archived

    Member
    June 30, 2012 at 2:58 pm in reply to: Polishing/Waxing

    I love – it. Just does’nt get any better then that.

    He is just taking it out on all of us that he needed to wax his new bus.

  • Archived

    Member
    June 30, 2012 at 2:41 pm in reply to: Polishing/Waxing

    Hey Al, note Mr. Perfects spelling of “migazine” above!

  • Archived

    Member
    June 30, 2012 at 12:23 pm in reply to: Stop engine and check engine lights coming on

    Was DDA able to fix your engine problem? Was it the ECM or ground problem? It sounds like your house batteries were drawn down. Do you have AGM’s or lead acid batteries? If the latter, get a hydrometer and get some readings.

  • Archived

    Member
    June 30, 2012 at 9:16 am in reply to: Name that sound

    What Al and Jon said. Mine does the same. I wouldn’t worry about it.

  • Archived

    Member
    June 30, 2012 at 9:14 am in reply to: Suggestions for Places to Park in ND, SD, WY or MT

    The KOA in Sioux Falls is great for those just going through. Easy on and off of I-90 and they have nice long pull thrus. We have stayed there a couple of times while either coming home or heading west. Elkhorn Ridge is great as Tom has said. Very nice, easy in and out and close to lots of the action around the area.

    If you go up to I-94 and head west, the KOA in Bismarck is ok and the one in Billings, MT and Bozeman, MT are also not bad. We have not stayed for more than one night at any of these as we have always been heading to another destination, but they worked well for us and were easy in and out.

  • Archived

    Member
    June 30, 2012 at 9:00 am in reply to: Polishing/Waxing

    I have never heard of the product Sam uses.

    On the pecking order how does this product compare with McGuires ?

    Using McGuires for years it works well and I believe it has quality ingredients in the make up on there premium lines.

    Price point is near each other.

  • Archived

    Member
    June 30, 2012 at 8:32 am in reply to: Name that sound

    I believe all is normal.

    When the hydraulic steering reaches the end travel , it senses to resist further travel.

    There are valves that by-pass the pressure side to the return side. With out this feature the lines would rupture along with bent steering linkage.

    Check the fluid level at the reserve tank in the engine bay. If fliud level is within specs, all is good.

    Some units make more noise then others

    AL.

  • Archived

    Member
    June 30, 2012 at 6:45 am in reply to: Stop engine and check engine lights coming on

    Perfect example of people playing with things they should not do.

    Stuff you are describing are things the converter installs and have nothing to do with SEL or CEL. The AC is Prevost and if it was working before I strongly suspect a wire connection is loose, a breaker has tripped, or something has opened the circuit. When you turn it on you should hear the condensing fan start to run and the clutch on the compressor should engage. Both have to happen to get the system working. Unless you were low on Freon and it is just coincidental it quit at the same time it was being serviced.

    What doesn’t make sense is how starting the generator makes stuff that operates on DC power work unless your batteries were dead. Was the coach kept connected to shore power while it was in the shop? Sorry if I ask such an obvious question. If the house batteries were dead a lot more than what you described wasn’t working, and now the battery life has been compromised unless the house batteries were turned off while it was in the shop.

  • Archived

    Member
    June 30, 2012 at 6:35 am in reply to: Polishing/Waxing

    Apparently if Sam isn’t pickin’ and grinnin’ on his banjo, he’s waxin’ on his bus.

  • Archived

    Member
    June 30, 2012 at 6:31 am in reply to: Name that sound

    It might be the sound of hydraulic fluid flowing at your steering sector. Have someone hold the wheel full left or right while you poke your head into the area under the floor beneath the driver’s seat. Until you posted it I never thought anything about the sound which I think they all make at the end of steering wheel travel.

  • Archived

    Member
    June 30, 2012 at 6:17 am in reply to: OEM muffler?

    Jan will be even with you Dale!

  • Archived

    Member
    June 30, 2012 at 4:27 am in reply to: Polishing/Waxing

    I just have a hard time believing there was 20 MINUTES worth of cleaning you could do on something Jon used to own. You must have driven through a bug storm on the way home!!

  • Archived

    Member
    June 29, 2012 at 11:42 pm in reply to: OEM muffler?

    NICE!!!

Page 2222 of 2304