Alex
-
Alex replied to the discussion Drive axle studs in the forum Chassis 11 months ago
My issue is similar, was removing recent tire install to do brakes, and one inner lug was on so tight that it was binding on the rim snapped when removing it. Thought I was going to have to drill everything out and replace the stud, but with some carful heating up of the remaining lug at the wheel and with an extraction tool, I was able to…
-
Alex replied to the discussion Drive axle studs in the forum Chassis 11 months ago
Eric, did you end up replacing the stud yourself, or take it back to the shop. If you did the job, what did it take to remove and install new stud. I have a damaged stud on my 2001 H3-45 drive axel (with disk brakes) and need to fix it asap as we are getting ready to hit the road.
Thanks
Alex
-
Alex replied to the discussion How many Lithium Batteries in the forum Electrical 11 months ago
Hi Art,
I am not a battery guy, so my question is to try to further understand your concern. Isn’t it better to have more capacity than needed for those occasions when you may need the extra available power such as running an ac unit.
Alex
-
Alex started the discussion TPMS Options in the forum *** General Discussions a year ago
Now that I am going to install TPMS, question goes out to those who have a Prevost installed system. Prevost offers two different internal TPMS. One mounts to the rim with a band, and the other uses BERU sensors. The one that mounts inside with a band is their earlier offering and seems to be a simpler installation than going with the…
-
Alex replied to the discussion Sometimes all the trip pre-checks don’t help in the forum *** General Discussions a year ago
Sometimes all the trip pre-checks don’t help
The bus handles surprisingly well as long as you remember to NOT hit the brakes and accelerate to maintain control and gradually slow down. It does want to pull some to the side of the blowout, but it is controllable and a lot of vibration until you get slow enough. I am amazed that other than the body panel, there is no other damage with…
-
Alex started the discussion Sometimes all the trip pre-checks don’t help in the forum *** General Discussions a year ago
Sometimes all the trip pre-checks don’t help
So just shy of our CA place, on our way back from the east coast, front steer tire blew. Was doing about 65 at the time. Luckily the interstate wasn’t busy. The Michelin tire is only 1.5 years old and has maybe 15K miles on it. Did not see anything on the road so I don’t think we ran over anything. Felt the rubber let loose, then the air…
-
Alex replied to the discussion H3-45 Upper Control Arms in the forum Chassis a year ago
I just got off the phone with Prevost Tech. ( Eric is a great source for help and information) and the bottom line is NO on the retrofit
Alex
-
Alex replied to the discussion H3-45 Upper Control Arms in the forum Chassis a year ago
I have been trying to get to the bottom of why my curb side steer tire continues to wear on the outer edge. In January of 24, I installed new Michelins and had Prevost inspect the entire suspension system and hubs, replaced my upper control arms and did a 3 axel alignment to fix the issue. Worked for the first 8K miles then started to see…
-
Alex started the discussion H3-45 Upper Control Arms in the forum Chassis a year ago
Trying to sort thru fact from fiction relating to 2001 era h3-45 upper control arms. I read on another site that that era upper control arm bushings are susceptible to early wear due to dropping the front low while trying to level out at parked sites. They further indicated that the 2004+ upper control arms are more robust and there is a way…
-
Alex started the discussion Speedometer issue in the forum Chassis a year ago
Looking for some advice on where to start my troubleshooting. Occasionally my speedometer on my 2001 H3-45 will stop working. Everything else remains normal ,with the exception of the cruise control which will not work when the speedo stops working. The bus will continue to drive normally. Sometimes it will happen when I first start up…