Forum Replies Created

Page 65 of 2304
  • Archived

    Member
    May 6, 2021 at 3:39 pm in reply to: Circuit Breaker on Generator

    Take a picture and send it to him…to show it said 50 Amps.

  • Archived

    Member
    May 6, 2021 at 9:14 am in reply to: Air leak when in gear only

    Perform a DOT brake check. I would be very inclined to guess you have a leaking parking brake diaphragm. Report back here the results.

  • Archived

    Member
    May 5, 2021 at 9:44 pm in reply to: Royale Schematics

    Thanks, I also got some info from Art. I will check the connections and the relays, I’m believing one of these two things are probably the problem. I would still love to get my hands on some schematics.

    Thanks

  • Archived

    Member
    May 5, 2021 at 2:04 pm in reply to: Royale Schematics

    ANDRE

    CHECK THE SPADE CONNECTION BUNDLE BACK UP THERE.
    THE OLD CONNECTION HEAT UP, DRY OUT AND NEED TO BE CHANGED.

    I HAVE #201 AND FOUND THIS BOX ALSO, I QUESTIONED THE CREW
    AT PHOENIX AND DIDNT GET A DIRECT ANSWER.

    WE WERE ABLE TO PURCHASE THE SCHEMATICS FOR OUR COACHES
    I GOT THE INFO FROM DAN AT ROYALE.

    FOOL’S PARADISE
    ROYALE #201

  • Archived

    Member
    May 4, 2021 at 10:22 pm in reply to: New Silicone Hoses Installed on Webasto

    Nice job Jeff keep up the good work. Awesome photos by the way.

  • Archived

    Member
    May 4, 2021 at 8:46 pm in reply to: Fuel gauge not reading

    Bill,

    So all of your other gauges have the proper 24 volt reference voltage? Seems weird because i just had my dash apart and i think all of the gauge power supplies were daisy chained from one supply point.

  • Archived

    Member
    May 4, 2021 at 6:58 pm in reply to: Make sure the wheels are turning …

    Hard to tell if that’s just a flat tire and the wheel is buried in the mud or an actual disaster.

  • Archived

    Member
    May 4, 2021 at 1:48 pm in reply to: Fuel gauge not reading

    The devise you show is a chassis electric system monitor. It will not warn of issues with the house electrical systems.

    The monitor instructions are available in detail on the Vanner web site, but the short version is it monitors voltage on the 24 volt side of the electrical system. If the voltage is over 30 VDC, or under 24 VDC it will light up the dash warning light for voltages. It is also monitoring battery balance which is regulated by the equalizer. The battery balance has to be the 12 VDC power has to be 1/2 of the actual 24 VDC power, within about 1/2 volt. The 12 volt power is important because the engine ECM needs 12 V and if it gets down to a low voltage it shuts down the engine.

    Whenever I get an electrical system warning light my first response is to pull to a safe spot and verify the input voltages to the monitor are within the required range. If they are OK, but the warning light is on the indication is a failed monitor. In that case I pull the wire at the monitor to extinguish the light. If the monitor is OK the monitor is advising of a needed repair.

  • Archived

    Member
    May 4, 2021 at 1:24 pm in reply to: Clean sheet design: inverters, batteries, etc.

    Chad, the only downside to pulling the OTR system is you lose backup heat and air. But since almost all the conversions currently produced rely solely on driver’s air and the house roof or Cruisairs it is certainly an accepted method of staying comfortable.

    The electrical system which will be updated can be as complex or simple as you choose. If I were to start with an outdated system I would do the following. Start with an automatic transfer switch. By doing that if properly set up, it will prioritize your electric source, with inverters being the default source. If shore power is available it will switch to that source. Some inverters will recognize when the loads exceed shore power and will allow the inverter to supplement the shortage. The highest priority for a transfer switch will be the generator.

    With updated inverters acting as battery chargers in the presence of shore power or generator power you likely will want to reconfigure the bus bars in your electrical panel, with inverter fed devices having separate bus bars. You would get to choose what circuits you want always powered such as the refrigerator, outlets, TV, coffee maker, etc. You may have to consider the gauge of wire feeding your electric panel so it can carry the loads you put on the inverters.

    I heartily recommend LiFePo4 batteries because of not only the significant weight savings, but the amount of usable power is significant. Depending on loads when dry camping those Li batteries will reduce the amount of times the generator has to run.

    What you might consider is setting the electrical system so you monitor the amp hour usage as the means of triggering auto start. Most auto-start systems look for low voltage before kicking on the generator, but Li batteries have an almost flat voltage curve before they need to be recharged. When that point is reached the available power is all but gone and it is easy for the batteires go into shut down.

    Copy what the converters are doing. They do it right, including providing systems that are safe and function well.

  • Archived

    Member
    May 4, 2021 at 1:13 pm in reply to: H3 Toll window not working

    I am not intimate with what it takes to access the motor, but it should be as simple as removing an access panel.

    If it is the toll window on a door, that usually involves removal of a lot of trim and the panels.

    When you are in there be sure to add some means of releasing the door lock. If your door mechanism fails on the entry door getting the door open may give you access to the dash and any buttons needed to lower the entry door toll window or the to unlock the entry door. We have had a number of members unable to get into the coach because something failed in the entry door preventing access.

  • Archived

    Member
    May 3, 2021 at 10:51 pm in reply to: Recommendations for RV Campgrounds in Phoenix area

    West Yellowstone, Montana 59758. I used to live there driving snowcoaches into OFI, and driving MCI’s transporting chartered ski trips

  • Archived

    Member
    May 3, 2021 at 3:46 pm in reply to: Royale Schematics

    My accent lights started to go off after a few minutes and did so for a short period of time (2 days) and now they won’t come on at all. I’ve traced it as far as I can from the switch to where it connects to the the lights. I’m not sure where the input line comes from or whether there is some type of device between the line input and the switch. Also I found this box behind a panel behind the washer, and don’t have a clue what these relays are for

  • Archived

    Member
    May 3, 2021 at 3:05 pm in reply to: Recommendations for RV Campgrounds in Phoenix area

    I would like to go snowmobiling with Hilgers in Wyoming mountains in January and then on West Yellowstone, WY for a few days of snowmobiling in Yellowstone National Park.

    Should we put you on the short list to invite?

  • Archived

    Member
    May 3, 2021 at 1:26 pm in reply to: Recommendations for RV Campgrounds in Phoenix area

    I suppose you would also suggest a trip to Minnesota in mid January?

    Let me guess you head to FL in July and WI in January?

  • Archived

    Member
    May 3, 2021 at 1:05 pm in reply to: Recommendations for RV Campgrounds in Phoenix area

    I could have sworn Dick suggested driving to Phoenix this summer.

    Seriously??????????

Page 65 of 2304