Archived
Forum Replies Created
-
Archived
MemberOctober 9, 2021 at 11:01 am in reply to: OK…I’m a convert! Centramatics are da bomb!All three Marathons had Centramatics.
I became a fan after discovering my balance weight had come loose and lodged in a foam panel behind the tag.
Take advantage of a lasting balance every time you drive. Factory installed on new Liberty Coaches or they were at one time,
AL
-
What a nice surprise this morning.
Old friends Karl & Natalie who left PC after selling there bus. Are you guys still boating ?
Liberty XL II if my memory is good ?
AL
-
Here is the info I have from replacing these boots in September 2020.
I purchased 8 Energy Suspension tie rod covers part number 90.13015 from: D.W. Ridzon & Sons in North Springfield, Ohio. Their phone # is 330-542-2306.
The total was just under $50 shipped to me in Illinois.
I used the pictured tool (OTC 7503HD) to remove the joints from the arms.
Cleaned everything up and installed per the maintenance manual. I just regreased the front end a couple of weeks ago. Boots still look like new.
-
I’am thinking the coach “Golden Rule ” has landed again. ” Before
you move bus, last thing you do is walk around your bus.
Again, every accident ( over 8 ) at my bus barn could have been avoided, had bus owner gone for a walk.
AL
-
We all realize how those parked vehicles can jump out of nowhere and hit something in the blink of an eye.
-
Spent the last 5 days waxing it. Next will be to polish wheels. After that, get it wet and dirty heading to Indio.
-
Nice job. Now we have a good idea how it’s done for those that want to do this in the future. Definitely looking forward to seeing those photos. I’m glad there is another major DIY on here.
-
Possibly, sometimes these lights are wired in an odd way, Like for example the ground is woven like a coax cable instead of a dedicated wire. if they are cheap enough, buy one and try it. The other thing to keep an eye out for is the spacing on these LED light strips. if the spacing is too far and the light is close to what you see, that could show up, dark to light spots.
Something like this you can cut to length and solder every inch, there might be a finer resolution avail. These cut to length you can solder on the 2 wires.
-
Thanks Bill!
-
Mike, the round thing on the floor is the level used when you hit the HWH auto leveling. If you don’t get level when the indicator says level you can adjust the sensor ever so slightly in the different directions to make it more accurate.
The filter you show is for the incoming air going to your genset. Be sure to clean that filter from time to time as it’s drawing in dust and dirt from the ground only a few inches below your bus. I used water to wash mine off and the filter completely disintegrated. Found a replacement at Home Depot or Lowe’s.
-
Richard this brings up a great Question for me also. Today I was looking at my aux compressor compartment. On the back wall of Bay 1 there is an access door where my aux compressor is. I replaced the filter, and added a water trap, but i am wondering if there should be a fan here sitting on top of this grate? Anyone have an access area like this? I guess this is How my generator gets fresh air from under the Bus?
-
Conversion and year?
-
Did oil and filter changes on the Detroit and the PowerTech Kubota