Jon
Forum Replies Created
-
Circling back with an update on this for posterity. After multiple discussions with a DD/Allison shop, a seated coach company that runs 35 Prevosts, two Prevost reps, and a fellow owner who is VERY knowledgeable, we had a consensus on the most likely issue: throttle position sensor. Following the verbal investigation, a road tech came out, and, of course, the over-revving issue did not recur. Proactively, we replaced the throttle position sensor, and now we can rule that out going forward.
I continued to get boost pressure error codes (as I have since buying the coach), and, yesterday, the gauge was pegged at 30…even at idle. Of course, that also did not recur upon the tech’s test drive, this morning. After further investigation and digging, things are pointing to a wiring harness associated with the boost sensor. I had mentioned that, yesterday, as a possible cause as I recall seeing posts about this harness issue, previously. That is now on its way from Syracuse, and I’m hoping that puts this issue to bed as my wallet needs a major nap!!!!
-
Top pic on mine it has a pop-it valve on top for vent, with out a dip stick to check oil I need to remove plug on side and see if oil comes out, when I changed oil in it I filled oil till it came out of side hole. Jeff you say newer boxes have a long tube and a filter for vent??
-
Excellent! DIY is always rewarding!
-
Do you guys worry at all about the computers in the second bay? We have the Allen Bradley setup and there is a heater on the bay ceiling. I was told it is because you can’t let the computers get below freezing. For those of you who winterize, do you do a complete power down so the computers are shut off?
-
Good stuff and I’d be sure not to use that electrican again if they can’t wire a 50 amp RV plug…
-
Prevost Car website has a coach check list, but a pre-trip inspection goes beyond checking the lights. It should include a DOT brake check, it should include the usual fluid levels and tire pressures, but it also needs to include converter and toad specific items. That type of comprehensive check list has to be specific to your coach, conversion and toad.
When you get your coach that is when you need to design one.
-
Thanks for your response, and sharing good information.
Once all the items you’ve mentioned have been checked. I guess I’m looking for the steps to getting going. Check mirrors. Start engine. Do you adjust the height or level or does the bus do that for you? Any other things one should do before releasing the parking brake and moving out?
-
I am curious that in one bay is top of the line fresh water pump system, way more money than a 12 vdc system. Right next door is a baby AHE 450D Aqua Hot that has an engine preheat loop, but the loop is not installed.
The big Aqua Hot only adds $2000 and that is at retail, has 3 heating loops, not only 2, engine preheat loop and a coolant tank that stores 3 times as much heat as the baby heater. It heats the interior and hot water at the same time. The baby one does one or the other but not both at the same time.
Using the baby 400D, no preheat loop and no stir pump, or the 450D is the choice of the plastic, box on rails, bling, cost cutting folks.
Anyway, just wondering.
-
Another excellent corrosion killing product is OSPHO, a dilute solution of phosphoric acid. Upon contact with corrosion, OSPHO chemically reacts and converts the oxidation to ferrous phosphate or Al phosphate, an inert salt. When it dries, the surface is treated and primed, ready for painting. There will be no more corrosion to paint over.
-
Yes I got my H345 during that time it has not lost much value