Archived
Forum Replies Created
-
Dan,
So sorry to hear that.
Maybe jon, I mean Tom, could waive your dues for a year to help you out.
-
Archived
MemberApril 8, 2021 at 10:16 pm in reply to: Amber & Red check engine lights?? And over rideI have a scan gauge on dash I wonder if it will read codes? And Jon the over ride switch is it a momentary switch, hold it in and start engine and move bus?? Thanks’ Jon for info.
-
Archived
MemberApril 8, 2021 at 10:39 am in reply to: Amber & Red check engine lights?? And over rideThe amber check engine light (CEL) is to let you know something needs attention. The list of things that will trigger a CEL is extensive but generally speaking it is a condition that will not prevent continued driving. Depending on the DDEC level it can include emissions issues and some conditions may cause the engine power to be derated.
A red stop engine light (SEL) on most coaches is a signal the engine shut down is imminent. On most older coaches only low oil pressure, low coolant level and high engine temperature will shut you down. On later model coaches high oil temperature will also shut you down. If you get an SEL the over ride switch will provide you with a short time period to prevent shutdown. If for example you are in the fast lane and need to get to the shoulder it is appropriate to use that over ride.
It is not uncommon for a CEL or SEL to occur with no other problem than a faulty sensor or perhaps a bad ground. I have had real problems that the SEL or CEL alerted me to such as a failed radiator hose creating low coolant level giving me a SEL, or a lazy #1 injector giving me a CEL. Neither showed in my dash gauges, but they were real issues that needed attention.
I trust but verify because with every bus I have picked up a reader from ebay and when I got the CEL or SEL I could plug in my reader and see exactly what specific problem was creating the light. I have learned to always trust the lights, but to dig a little deeper to determine the problem and to help define my response. On most coaches you can use the information center or pro driver to get a little detail if no reader is available. Early DDEC coaches have provisions for flashing the codes.
-
I have a 28 inch screen on my computer, I enlarge it to 400 present and I wrote down the colors on a card from french to english but you see check valves protection valves all the components of the air system ,Their is Black-Green-Red-yellow-Blue hoses for all air systems.
Red-Rouge for Secondary brake system (Front) – Vert-Green for Primary brake system (Rear) – Yellow-Jaune for parking spring Brakes – Blue-Bleu for Travel Mode suspension – Black-Noir for assessoires includes Leveling-slides ofany kind, anything else little compressor. If you follow the air path you will learn a lot about the system that’s what I did. Don Beard (lonestarace) helped me a lot when I bought the bus. Don knows his stuff.
-
You would have to have an adapter or change out the fitting to the small SMA connector.
-
Ditto, likely a question for the tech dudes at Pressure Pro.
-
There’s plenty of room. Come one, come all.
The object for this week, aside from trying to eat all the Gulf Coast oysters, is to see who can tell the biggest lies.
-
Looks like I will be able to make it to Orange Beach after all 🙂 I’ve booked a site and will look forward to seeing/meeting folks!
John
-
Chad, I am sure the Pressure Pro engineers can answer that. Given the amount of grief they have had with the problem of lost signals and various antennas I suspect they have learned a considerable amount about what works and what does not.
A lot of the problems I sense are the amount of metal our coaches have that has the potential to block signals because they do not seem to have as much lost signal issues with conventional RVs.
As to running an antenna I was able to do it with only one hole drilled in my steer compartment floor. I ran the antenna down into the steer compartment near the bottom of the windshield post trim. From the steer compartment I brought it outside and ran it behind the front fender trim, up and over the wheel well. Then I ran it straight back along the underside of the bays and over to where I attached it to the rear strap of the fuel tank. The antenna length is too short to run it front to rear through the conduits under the floor.
-
Bill, when parked the brakes should retain pressure. If they jointly lose pressure the problem almost always is attributable to parking brake components between both the primary and secondary tanks up to and including the relay valve for the parking brakes.
Mikee made a good suggestion and a review of your pneumatic system on the Prevost diagrams will show any other potential leak sources between the tanks and up to and including the relay valve.
Given that Prevost was starting to use push in fittings around the time your chassis was produced I would not rule out something as simple as a fitting.
-
https://techpub.prevostcar.com/en/
Oddly enough I cannot find a diagram for a 1997 chassis XL40, converted or anything else, at that link.
-
Hi Pat:
Sent contact info to corrected address. Have not had it returned, so I believe it has worked.
Chuck
-
Al, no problem here and I think if you can get a used door complete you are goiong to save a lot of time, plus it will not have any evidence of damage. You are making a right choice.
Fixing damage, either by the owner or a body shop is both hard and sometimes not so cheap. My point was that depending on the extent of the damage sometimes an owner made repair is a good choice.
All of us who have needed repairs, especially if new parts are required the availability of parts is a long time coming and sometimes the prices are insane.